Question about Chrysler 300

1 Answer

Engine Stalls while driving when hot. We replaced cam shaft , drive shaft and coolant sensors; but always the same

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Chrysler Master
  • 4,514 Answers

Cud be somethin simple--never throw parts at it till u know--may be thermostat or some electrical item heatin up--start troublshootn-buy a repair manual and get car scanned

Posted on Apr 07, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 2004 sebring stalls and will not crank for hours it stalls while driveing or setting still


If it usually starts when cold, but when fails hot will not start until totally cold, suspect bad coil, ignition module or other electronic sensor on engine such as crank or cam sensor. Testing individual parts often is difficult, because part only fails when hot.

Oct 03, 2016 | 2004 Chrysler Sebring Touring

1 Answer

Jeep cranks but does not start


Hi, First replace your plugs. Second check ignition coil(s) one maybe bad. replace with new. If all else is good, have your mechanic check the computer codes. (code scanner) Many of todays cars and trucks have computers to run and control the engine. (management system). Good luck

Feb 04, 2015 | 2004 Jeep Liberty

1 Answer

My car didnt start so i took it to auto zone to get hook on the diagnostic machine it showed need a cam shaft and crank shaft sensor i got them replace and a week later the same problem car will not start...


Does the vehicle run at all with the new sensors?? If it does and experiences stalls or hard starts, read the following. When replacing cam or crank sensors, the vehicle's computer must go through a "RELEARN PROCESS". This can only be done at a authorized GM dealer, and usually costs $130+. I'm not sure if your vehicle has been properly diagnosed, but very rare does both crank and cam sensors fail simultaniously. This problem may be beyond what has been diagnosed, If the relearn process don't work, this issue needs to be re-diagnosed by another tech.

Dec 16, 2010 | 2001 Cadillac DeVille

1 Answer

Engine running -hot or cold- in park or drive the engine rpms go to aprox,500-400 and then stalls. cycle the kry and the engine will run for a while and then start the cycle again


Clean the temperature sensor wire connector.
Replace the temp sensor.
Check the condition of the sensor wire cut(s) or short onto the engine block.
Monitor the fan operation with the hood open during warm up (0-15 minutes.) It should ran after the engine coolant temp get above 195F +.

Jan 06, 2010 | 2000 Ford Focus

1 Answer

I have a 93 mercury topaz that stalls while driving


if it only stalls hot relace the ign module on distributor

Oct 05, 2009 | 1993 Mercury Topaz

1 Answer

2000 Pasat Engine Cranks but No Fire


likely crank shaft sensor ,maybe fuel pump or cam shaft sensor ,ignition module under coil pack,check your codes as your first effort in this,

Aug 16, 2009 | 2000 Volkswagen Passat 4Motion

2 Answers

After driving in hot weather for 20 to 30 minutes the car stalls


Sounds like your coil pack is going bad. When they start to go bad, they will fail when they get hot but when they eventually cool down the car will run as normal. I would replace your coil and that should take care of your problem. Thanks for using FixYa!

Jun 30, 2009 | 1996 Dodge Neon

1 Answer

Engine hesitates or stalls


This might be what we call vapor lock try driving with your gas cap off and see if it still quits under the same conditions.

Jun 17, 2009 | 1999 Pontiac Sunfire

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

117 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7710 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...