Question about 1994 Mitsubishi Diamante

Open Question

Fuel Filter is it an internal or external fuel filter fo rthe 1994 Diamante

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 109 Answers

SOURCE: Fuel filter location on a 1994 Mitsubishi Expo LRV 2.4

it is an internal fuel pump located underneath the back seat..

Posted on Dec 04, 2008

Ad
  • 39 Answers

SOURCE: wheres the fuel filter on my 1987 mitsubishi mighty max

Hi Paulvilla13,

I'm not sure if your '87 is the same as my '88 or not, but mine is located just in front of the tank. I also have to remove the rear driver-side wheel to get at it.

Hope I've helped, don't forget to rate.

Lazaruselite

Posted on Feb 24, 2009

  • 139 Answers

SOURCE: 2001 mitsubishi diamante,where is that fuel filter?

at the back behind wheel on frame rail

Posted on Apr 10, 2009

taran_2005
  • 10515 Answers

SOURCE: Where is fuel filter located on 1992 Diamante?

Hi,

On the first gen diamante its located in front of the passenger side firewall closer to the middle close to the bottom.if in doubt follow the fuel line.

Thanks.

Posted on Jul 31, 2009

  • 6 Answers

SOURCE: 93 mitsubishi diamante, starts runs for 5 mins

Check all of the cables near intake. Make sure all of the sensors are pluged in.  Since if sensors have plugs that are loose than you could have a problem of inconsistent runing. 

Posted on Sep 16, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the fuel filter for a Chrysler 300 M


Most Chrysler products built after 1994 do not use an external fuel filter. They only have a sock filter inside the gas tank.

Jul 25, 2014 | Chrysler 300M Cars & Trucks

1 Answer

Where is transmission filter


Hi there,

The Diamante transmission can actually have up to 2 filters - one internal & one external.

It is recommended to change both these filters when doing a transmission fluid change.

ONLY USE MITSUBISHI ATF - Do not use any other brand of fluid, or you will cause damage to the transmission (Mitsubishi fluid has special properties).

The internal filter is inside the transmission casing and is accessed by dismantling the trans casing - careful, as oil will escape from the trans when you remove this cover. See item # 29, in picture.
wolfman304_3.gif
The external trans filter (miniature version of an engine oil filter) is mounted on the transmission body, which is located behind (or under) the battery compartment. See Item # 6 in picture.



wolfman304_4.gif


Cheers,



"If this has helped you in any way, please rate this solution or kindly leave a testimonial"


May 12, 2011 | 2000 Mitsubishi Diamante

1 Answer

Where is the fuel filter located on a 1994 dodge ram


Fuel Filter REMOVAL & INSTALLATION CAUTION
Never smoke when working around gasoline! Avoid all sources of sparks or ignition. Gasoline vapors are EXTREMELY volatile! All 1989–93 Gasoline Engines and 1994–96 2.5L Engines The fuel filter is located in the fuel line on the inside of the left frame rail, just ahead of the crossmember. Fig. 1: Fuel filter location for gasoline engines 88471011.gif
  1. Relieve the fuel system pressure as described in Section 5.
  2. Unfasten the filter retaining screw and remove the filter from the frame rail.
  3. Wrap a shop towel around the hose connections to catch fuel spillage. Loosen the fuel hose clamps and disconnect the hoses from the filter.
  4. Remove the old fuel filter and replace it with a new one.
  5. Connect the fuel hoses and tighten the hose clamps. Position the filter on the frame rail and tighten the retaining screw to 75 inch lbs. (8 Nm).
1994–96 Gasoline Engines — Except 2.5L The fuel filter is integrated into the fuel pressure regulator which is mounted in the fuel tank. This unit is not controlled by the PCM or engine vacuum. It is calibrated to deliver approximately 35–45 psi (241–310 kPa) of fuel pressure to the injectors. If the pressure exceeds the maximum of the specified range, an internal diaphragm closes to route fuel back into the fuel tank. This system eliminates the need for conventional return lines from the engine bay and accounts for the name of the "Returnless'' fuel injection system employed in these vehicles. NOTE: Fuel tank removal is required for this procedure. Also needed will be external snapring pliers and proper hose clamp pliers, such as No. C-4124 pliers (available through Plymouth/Dodge dealers), or equivalent.
  1. Relieve the fuel system pressure as described in Section 5. Fig. 2: With the fuel tank removed, twist and pull the fuel filter/regulator for removal from the rubber mounting grommet 88471707.gif

  2. Drain the fuel tank and remove the tank.
  3. Remove the fuel filter/regulator (which is pressed into a rubber grommet) by twisting and pulling it straight up. Fig. 3: Use snapring pliers to remove the retainer securing the cover tube to the base of the filter/regulator 88471708.gif

  4. Remove the snapring retaining the cover tube, then slide it down to reveal the clear plastic fuel tube and its retaining clamp. Fig. 4: Cut off the old tube clamp without damaging the plastic fuel tube 88471709.gif

  5. Gently cut off the old clamp without damaging the tube, then discard the clamp.
  6. Carefully pull the tube off, then remove the filter/regulator from the fuel pump module. To install:
  7. Install a new clamp over the plastic fuel tube and attach it loosely to the filter/regulator. Rotate the unit in the line until it is pointed to the driver's side of the vehicle.
  8. Tighten the clamp using hose clamp pliers such as No. C-4124 (available through the Plymouth/Dodge dealer). NOTE: Do not use conventional side cutters to tighten the clamp.
  9. Slide the cover tube up to the bottom of the filter/regulator and install the snapring.
  10. Carefully press the assembly back into the rubber grommet by hand. It should be pointed to the driver's side of the vehicle.
  11. Install the fuel tank.

Jul 14, 2010 | 1994 Dodge Ram

3 Answers

Is the fuel filter external or internal on a 2000 chrysler sebring convertable. 2.5 V-6?


The fuel filter is external, will be an in-line fuel filter meaning it's screw into the fuel line, more then likely will be under the hood over by the fire wall.

Jun 08, 2010 | 2000 Chrysler Sebring

1 Answer

I want to know where the fuel filter is on my car as I need to change it. Mitsubishi Verada, 1994


call autozone.they have a computer which tell where parts are located.if you need a number let me know eaglebear77@yahoo.com

Nov 05, 2009 | 1994 Mitsubishi Diamante

4 Answers

Where is fuel filter located on 1992 Diamante?


Hi,

On the first gen diamante its located in front of the passenger side firewall closer to the middle close to the bottom.if in doubt follow the fuel line.

Thanks.

Jul 31, 2009 | 1992 Mitsubishi Diamante

1 Answer

How do i change the fuel filters without bleeding


you cannot change filter without bleeding it you can however fill the fuel filter with injector cleaner that can be put into filter and NOT into the fuel tank this will help also u can get a external primer pump and attach to the OUT side of filter and pump the fuel through good luck

Jul 01, 2009 | 1990 Ford F350

1 Answer

Fuel filter location on a 1994 Mitsubishi Expo LRV 2.4


it is an internal fuel pump located underneath the back seat..

Dec 04, 2008 | 1994 Mitsubishi Expo

2 Answers

Fuel filter


an automotive shop should have the tools u need its a little plastic thing that goes over the fuel line and releases the clip inside the filter

Oct 01, 2008 | 1994 Ford F150 Styleside Supercab

1 Answer

2003 Sienna - where is the fuel filter?


Hi,

To my knowledge after 2001/2, Toyota no longer uses an external fuel filter on their Sienna models, all the fuel filters are incorporated with the fuel pump inside the tank. Should your model still have an external fuel filter it would be underneath the air filter assembly. You could verify by following the the fuel line/hose.

Additionally, you may want to have your car's computer codes scanned/read, there may be indicators/errors. Depending on the errors/code displayed, they may be causing your intermittent starting which could be anywhere from the O2 sensors to the two A/F sensors or entirely something else.

Hope this be of initial help/idea. Pls post back how things turned up or should you need additional information.

Good luck and kind regards.

Thank you for using FixYa.

Jul 09, 2008 | 1994 Toyota Celica

Not finding what you are looking for?
1994 Mitsubishi Diamante Logo

105 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

77169 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22258 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8725 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...