Question about 1983 Chevrolet S-10

1 Answer

How do i install the pawl kit on my 83 chevy s-10

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    MVP:

    An expert that gotĀ 5 achievements.

    Master:

    An expert who has achieved Level 3.

    Sergeant:

    An expert that hasĀ over 500 points.

  • Master
  • 500 Answers

Remove the tranny pan there may be a crossmember in the way that may need to go 2. this will get you in the area. now you can see how it works .& comes out... I have not replaced one but seen it w/ changing filters ..good luck..

Posted on Apr 07, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

83 chevy ac compeser kicks on but no cold air


May just need a recharge, you can buy kits with a gauge at walmart or parts stores, worth a try and a lot cheaper than a $300 compressor.

Jul 21, 2014 | Chevrolet Chevy Cars & Trucks

1 Answer

Replacing a starter on an 83 s-10


Its not that hard. The hardest part is getting to the small wires on top of the starter. Just take your time.

Jun 15, 2014 | 1983 Chevrolet S-10

1 Answer

Adjust door gap 83 k-10 chevy


GM has a known issue with worn door hinge pins around that year. With the door open, try to lift the door. If there is movement, the hinge pins and bushings need to be replaced. Your local GM dealer should have the parts pretty reasonable.

Apr 24, 2014 | Cars & Trucks

1 Answer

93 Chevy Cheyenne gas tank into 83 Silvera


no it will not work as these are 2 different style bodies.the 83 has the tanks on the outside of the frame and no fuel pump in tank.the 93 tank is located inside the frame rails and has a electric pump in the tank.

Mar 06, 2014 | 1983 Chevrolet Silverado

1 Answer

Truck rolls backward in park..runs and shifts fine just no true park


sounds like the parking pinn or [pawl] Inspect the parking pawl as it is likely broken. The pawl is a metal pin that engages the transmission's gear when the transmission is in the "Park" position. The pawl manually locks the transmission's gears and is located on the interior side of the transmission's manual control linkage

Read more: How Do I Troubleshoot a 1968 Chevy Hydramatic 400 Transmission? ' eHow.com http://www.ehow.com/how_6940725_do-chevy-hydramatic-400-transmission_.html#ixzz1OKEuCICo i know this says chevy but should be the same type of operation.. i hope this helps you

Jun 04, 2011 | 1989 Ford F 150

1 Answer

Wont shift into first gear even after installing a transmission kit. the car starts running in second could it be a sensor or a vaccum


check the linkage or cable adjustment to the pawl lever on the side of the trans, it is most probably out of adjustment-a very sensitive adjustment too.

Feb 26, 2011 | Chevrolet Lumina Cars & Trucks

1 Answer

83 s10 Chevy truck, i need a manual


all the parts places have them---20$----i bought mine from ebay 12$ including shipping...slightly used but was still very good (haynes manual)

Mar 11, 2010 | 1983 Chevrolet S-10

1 Answer

I need a part for my 83 chevy. its the line going from the slave kit to the trannsmison . part hose and metal line. its a one ton truck


Your best bet is to get it from the dealer..They may have it aftermarket, but it may explode on you...I tried that once..So just find you a dealer an order it.. Or find you a good salvage yard, an take it off a vehicle like yours....Goodluck...

Mar 02, 2010 | 1983 Chevrolet Silverado

1 Answer

I have a 1995 Chevy Van with a 4.3 liter, it's a CMFI eng. I have 2 fault codes 32 and 83, I changed the IAC vavle which is fault code 32. I do not know what 83 is, but the fault codes as the IAC vavle is...


i dont know what that code is but i do know that those enigines have a bad problem with fuel leaks under the upper intake what happeins is the plastic type line that go to your injectors crack or just break and then they leak and then the van runs like poo. if you take the 30 min it take s to get the upper intake off to inspect the lines for leaks if there are broken line or bad o-rings you can buy that whole injector kit. its pretty simple. this is some thing that i would check. good luck.

Jan 26, 2010 | 1995 Chevrolet Astro

2 Answers

I have a 93 Chevy Suburban 1500 and the Transmission won't shift into any gear. I have an 1983 Chevy Suburban Transmission that is still good. Can I use the 83 Transmission in my 93 Suburban?


Not without a little adapting. The 1993 has a 4l60e which is electronically controlled and has shift solenoids. If the 83 is an overdrive it is a 700r4 which is the same trans but not electronic. If you put it in the speedo wont work and you will need to install a T.V. cable so the transmission will shift. The 93 won't go forward or backwards?

Jun 15, 2009 | 1995 Chevrolet K1500

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

88 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8140 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...