Question about 1992 Daihatsu Charade

1 Answer

When first starts cuts out after 30 to 60 seconds and have to knock on cabry to get going then runs perfect but have cleaned out carby and can find no problems inside

Posted by on

1 Answer

Bad float or needle assembly.

Posted on Aug 29, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Tractor starts , but wont run


check float level and operation. check that the idle circuit is clean and if there is a solenoid in the idle circuit ensure that it is working. If the fuel tank is above the carby check for filter / line blockage and that the tap is turning on. as from your description the is insufficient fuel getting to the carby and the bowl is running dry

Jan 26, 2014 | Cars & Trucks

2 Answers

I have put a reconditioned carby on my eh holden it wont start cold with out pourig a small amount of fuel down the throughtof the carby onece running it starts each time perfect sit over night no go


fix the choke to work properly for starters next if you still have the original cast iron manifold then get the butterfly in the exhaust to work as well. It heats up the inlet manifold which helps to vaporise the fuel

Dec 31, 2013 | 1964 Holden EH

1 Answer

Car starts fine when cold and runs and idles fine. When hot, car does not start.


Sounds like you have a fuel vaporisiation fault. If a carby ther should be a fiber gasket between the carby and the manifold to stop the engine heat transfereing to the carby and boiling off the fuel. If efi system I would be looking at the regulators in the fuel manifold for excessive drain back. Have it checked at a dealer.

Jan 10, 2013 | 1991 Buick Century

1 Answer

'01 Tahoe starts right up, idles perfect for abour 20 seconds, then starts to spit and sputter then eventually cuts off. Will start right back up and do the same theing over and over again. Fue


I just fixed mine it was doing the same thing take the air box hose off and clean the throttle body valve with some wd40 or brake cleaner the little valve will move clean inside wherever you can worked perfect for me

Nov 24, 2012 | 2001 Chevrolet Tahoe

1 Answer

I install a fuel pump but can't get any fuel to the throttle body. the fuel pump runs but it won't go through the throttle body?


hi.. so is it a carby or direct inj or throtle body inj ? if its a carby then you may need to clean out the jets, if not then the fuel does not neciserily go through the throttle body, just make sure your fuel lines are on the correct way, they are easy to confuse and usualy the most common mistake... if it is a mechanical fuel pump to a carby try starting useing 'easy start' aerosol can and it might help **** the fuel through... also if the carby is empty it will be hard to get fuel in so you can help by tipping some fuel into the carby pots..

Feb 11, 2010 | 1987 Chevrolet S-10 Pickup

1 Answer

Daewoo Lanos 1999 Not starting


Usually this is because the carburettor dries out and there is a needle and seat (internal on carby) that can get stuck and not let fuel in. Usually from a little dust water and general **** that comes with the fuel. Id spray the carby out with carby cleaner, remove the fuel line from it and spray out the fuel bowl. Possibly even open up the carby and completely clean it, but only if you are confident on putting it back together. But try just spraying it and cleaning it first, then tip probably a quarter (1/4) of a cup of petrol in the hole in the carby and try starting it, this should make it run. Maybe a little rough at first, but you may need to clean the carby a couple of times, and will need to pump fresh fuel from the tank. So good luck and hope it helps.

Dec 21, 2008 | 2000 Daewoo Lanos

1 Answer

1990 suzuki sierra - stalling,


Yes your snorkel should have the right size for air to come-in, hope you have the right diameter, but snorkels will not seriously affect your vehicle substantially.
It could be that your fuel system is dirty. I would go for having those carbs cleaned but before you do this, I would advise you to clean your gasoline tank of rusts, water then blow those fuel lines with air to declog, change your fuel filters, if you do a lot of offroading, put two(2) fuel filters, first filter goes just above the gas tank, beside the chassis, the second will be place before your fuel pump, inside your engine compartment. have those fuel pumps cleaned too, check for leaks and moistures on your fuel hose and lines. if you have done all these, and nothing happened, check for strong sparks on your plugs, it could be that they ready fouled up.and check on your igniton coil,

Nov 20, 2008 | 1990 Suzuki Samurai

Not finding what you are looking for?
1992 Daihatsu Charade Logo

Related Topics:

72 people viewed this question

Ask a Question

Usually answered in minutes!

Top Daihatsu Experts

Colin Stickland
Colin Stickland

Level 3 Expert

21990 Answers

yadayada
yadayada

Level 3 Expert

64034 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

Are you a Daihatsu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...