Question about 2001 Ford Crown Victoria

1 Answer

My new passenger window motor does fit. do i have to change the regulator

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert that hasĀ over 10 points.


    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 7 Answers


Posted on Apr 07, 2011


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

3 Answers

My passenger window on my 2009 hhr won't go up or down acts as if the power is out

Remove the inner door panel and check and make sure the electrical connection is tight on the window motor.

Oct 10, 2017 | Cars & Trucks

1 Answer

Driver side power window on a 1999 chevy silverado LS won't go down. passenger side window works. bought new switch, nothing changed. bought new regulator with motor and still, nothing changed. i...

Motor is not turning in second direction to lower window. Either the new motor is defective or the device that reverses the electricity to the motor is defective. Regulator?

Take motor out and feed it juice - will turn. Reverse polarity and it should turn in other direction.

Aug 27, 2017 | 1999 Chevrolet Silverado 1500

1 Answer

1995 contour,do u have to chang window motor to change regulator. passeng front.

If your motor is good ? you will have to take it off the old regulator and install it on the new regulator.

It will be riveted on. You will have to drill out rivets (1/4" Drill Bit) and install the motor with short 1/4" bolts and nuts.

Aug 22, 2011 | 1998 Chevrolet Cavalier

2 Answers

Passenger window doesn't work, new regulator.

if u have ck all fuses & relays& tried the passenger switch & still nothing,,could have broken wire between door & door jam where the rubber boot is ,,u mite have to peel it back to see wires

May 08, 2010 | 1994 Toyota Camry

1 Answer

I bought a new window from glass shop then bought new regulator and motor online. Regulator fit fine, but window goes in wrong direction and will not go up all the way. The back side is a little lower than...

we had the same problem with our car had to have a new track installed at a glass shop they had to use some kind of special cement to hold it in place works fine now

Aug 09, 2009 | 2001 Oldsmobile Alero

1 Answer

Broken drivers side window regulator on my 95 SC400

i do theses regulators all the time . its not hard to change the motor . you may need to drill out the rivits and replace them with bolts and nuts

Jun 10, 2009 | 1995 Lexus Sc 400

2 Answers

Passenger window i need two parts to repair it ?

You will not know which is the problem until you get into the window. This is a pretty straight forward job, remove all screws holding the door panel on, some will be hidden behind plastic tabs. Take a door panel tool, about $5.00 at a parts store, work it around the panel to find the plastic clips, gently pry them up one at a time. Remove dust cover. You now should be able to see the regulator and the motor. If regulator is intact meter the motor. If the motor is not getting power the problem is the switch. If the motor is bad drill out the pop rivets and remove motor. I have found on some doors it is easier to use nuts and bolts to put the motor and regulators back instead of pop rivets, just make sure they will fit when everything goes back together.

May 01, 2009 | 2000 Oldsmobile Alero

1 Answer

94 Lumina Van Passenger Window

I would plan on a new motor, to chage it yourself may be more than you want to do. To change the motor you will need to remove the regulator that is the devise that attaches to the window and rolls it up and down. Once you have it out of the door the motor bolts to it. (if this van has the cable driven regulator it will be easier to change out)

Feb 21, 2009 | 1994 Chevrolet Camaro

2 Answers

Passenger window will not go up or down

I had the same problem a few years ago except my window was stuck up. There is a cable inside the door that controls the window (not sure what it's called). Anyway, that cable was broken so the motor was working but not the window. Take the door panel off and you should be able to see the cable and if it's still attached correctly.

May 19, 2008 | 2002 Chevrolet Silverado 1500

Not finding what you are looking for?
2001 Ford Crown Victoria Logo

Related Topics:

27 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

76682 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers


Level 3 Expert

5537 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides