Question about 2002 Ford F150 Regular Cab

1 Answer

Need to located the temperature sensor on 2002 ford f-150 4.2

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Novelist:

    An expert who has written 50 answers of more than 400 characters.

    Sniper:

    An expert who has posted more than 50 answers, of which 90% or more were rated as helpful.

  • Expert
  • 71 Answers

The coolant temperature is measured from the cylinder head temperature sensor CHT and is located on the drivers side cylinder head in the rear. It is connected to the harness by connector C107 and has gray/red and yellow/light green wires going to pins 39 and 55 of the processor.

Posted on Apr 07, 2011

×

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

2002 Ford f150 evaporative emission control system sensor where is it located


on top of the canister purge can , next to the solenoid of same purpose

Jan 30, 2016 | Ford Cars & Trucks

1 Answer

Coolant temperature sensor location on 97 ford expedition


I believe they are located in the intake manifold somewhere. Make sure the one that tells the computer the coolant temp is ACTUALLY giving out the correct temperature. I had a bad one one time in a 1993 Ford F-150, 5.8L....... no check engine light came on but hard to start. The bad sensor was telling the computer it was 32 degrees F when it was almost 80 degrees outside.!!
Garbage in=Garbage out.

Here is a video link from Youtube. There are 2 sensors, 1 for the guage and the other tells the on-board computer how hot/cold the coolant is. The one for the guage has 1-wire and the other one has 2 wires.
Hope this helps, ask more if you need to. What kind of problem are you having? No heat inside? Guage needle not getting into the normal area?


1997 Ford Expedition 5 4L V8 Triton Engine Coolant Temperature ECT Sensor...

Oct 20, 2015 | Ford Cars & Trucks

1 Answer

Diagram 2002


next to the thermostat , follow this u-tube link for good explanation a comments
Replacing 2004 FORD Taurus coolant temperature sensor

Jul 17, 2014 | 2002 Ford Taurus

1 Answer

Need to know where the coolant temperature sensor is located on a 2002 Lincoln ls 3.9 V8 engine any help would be highly appreciated


The coolant temperature is read off of the (CHT) cylinder head temperature sensor. It is located on the inside on the passenger side (right) cylinder head and is connected to the harness through Ford connector C107. The Ford basic part# is 6G004. It's connected by WH/VT and BR/WH wires to pins 40 and 17 of the vehicles PCM (computer). Keep in mind that if the coolant level is low, if there is air in the system, or if there is a wiring concern, you could have concerns with this sensors reading. Good luck.

Apr 04, 2011 | 2002 Lincoln LS

2 Answers

Where is the temperature sensor for a ford e-150 van 1994 on a 300ci v-8 engine. Thanks rick


1994 Ford Truck E150 1/2 ton Van 5.8L MFI 8cyl Temperature Switch is located: Front seating area, center, under engine cover, front driver side of intake manifold, mounted in engine block.

The ECT sensor (Engine Coolant Temperature Sensor) is located either in the heater supply tube at the rear of the engine, or in the lower intake manifold. The ECT sensor is a thermistor (changes resistance as temperature changes). The sensor detects the temperature of engine coolant and provides a corresponding signal to the PCM. From this signal, the PCM will modify the air/fuel ratio (mixture), idle speed, spark advance, EGR and canister purge control. When the engine coolant is cold, the ECT sensor signal causes the PCM to provide enrichment to the air/fuel ratio for good cold drive-away; as engine coolant warms up, the voltage will drop.

c1fb19f.gif

Engine component locations-1994 5.8L engines

I hope help you with this, good luck (remember rated this help).

Sep 02, 2009 | 2002 Ford E-Series

1 Answer

2001 Ford F-250 need location for IAT sensor is it part of the mass airflow sensor unable to locate it from the intake to the throttle body.


In the intake manifold on drivers side by the fuel rail. It's not part of the MAF. Intake air temperature.

Jun 15, 2009 | 2005 Ford F-150

1 Answer

Where is the engine coolant sensor located on a 2000 ford f150 V8 4.6 L?


please rate as fixya if this helps

SECTION 303-14: Electronic Engine Controls 2000 F-150 Workshop Manual
REMOVAL AND INSTALLATION Engine Coolant Temperature (ECT) Sensor — 4.6L and 5.4L Removal and Installation
  1. Remove the engine coolant temperature (ECT) sensor.
    1. Disconnect the electrical connector.
    1. Remove the ECT sensor.
ae8a8e7.gif The ECT sensor:
  • sends the PCM a signal indicating engine temperature.
  • resistance decreases as coolant temperature increases.
The ECT measures the temperature of the engine coolant. The sensor is threaded into an engine coolant passage.

Mar 19, 2009 | 2000 Ford F150 Flareside SuperCab

Not finding what you are looking for?
2002 Ford F150 Regular Cab Logo

1,473 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

fordexpert

Level 3 Expert

5495 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...