Question about 2006 Chevrolet Colorado

2 Answers

Blower only works on fourth setting - 2006 Chevrolet Colorado

Posted by on

Ad

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 869 Answers

U might need to replace it. take help of a good chevrolet dealer.

Posted on Apr 21, 2011

Ad
  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 8 Answers

REPLACED YOUR BLOWER RESISTOR ITS PROBABLY A $15 PART AND TAKES ABOUT 10 MINUTES TO CHANGE OUT

Posted on Apr 06, 2011

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why is my air condition only blowing on the high setting?


you need a blower motor resistor to get all the speeds again.

Jul 03, 2014 | 1999 Plymouth Grand Voyager

1 Answer

Sentra AC


There's a 10amp fuse that powers the ac clutch relay and compressor. There are 15amp fuses that power the blower motor and the ac control switch. All of those fuses get power from the key switch. The resistor and fan switch provide the ground circuit for the blower motor.
I would want to know if those fuses are getting power, and if the control panel is working. You should be able to ground the blower motor and make it run on high, and that should not have any effect on if the ac compressor is running or not.
It could be a key switch problem in that the circuit is not strong enough to handle the load from the blower and the compressor at the same time.

Jun 21, 2013 | Cars & Trucks

1 Answer

My heater switch only works on setting 4 and 5 fan setting


The blower motor resistor is burned out between the third and fourth tap. The resistor is often mounted on the engine side of the firewall inside a box with a single connector going to it.

Apr 04, 2011 | Chevrolet 1500 Cars & Trucks

1 Answer

Heater will not put out much heat on first 3 setting turn up to fourth and it does get alot of heat whats wrong with 1-2-and3


sounds like the blower motor resistor/blower motor module is bad. They use a series of resistors to drop voltage to the blower motor to make it spin at different speens. High speed bypasses the resistors and allows full voltage to the blower motor.

Heres an article I did with some tips.

http://www.fixya.com/cars/r6571076-blower_motor_not_work

Dec 02, 2010 | 2004 Jeep Liberty

1 Answer

My heat blower does not work in positions 1,2,3 on my 2003 GMC Envoy Can I replace the rheostat myself ? where is the rheostat for positions 1,2,3, located ? can I get access to the blower fan under the...


you can do it you will find it down by the passenger foot are just under the glove box.it has two screws holding it in place and one electrical plug. note if fourth speed is also not working this means a fuse is blown out the fourth speed is wired through a fuse out under the hood fuse panel. good luck please comment on this if it helps you thanx.

Nov 25, 2010 | 2003 GMC Envoy

1 Answer

My AC/Heater fan only works on the third and fourth settings, not on the low settings.


The most likely problem is the blower resistor. Its under the dash on the passenger side near the firewall. The wires to the blower lead to it. Most of the time the resistor burn out. Its an easy fix.

Nov 03, 2009 | Oldsmobile Alero Cars & Trucks

2 Answers

I have an 86 toyota 4x4 with the 22r motor. my


it could just be the switch,, or more likley to be the resistor burned out or the reostat? (same thing realy)

Oct 27, 2009 | 1986 Toyota Pickup 4WD

1 Answer

First and second settings on A/C don't work


Sounds like heater blower motor resister is bad.

Feb 16, 2009 | 1996 Chevrolet Cavalier

1 Answer

Blower fan


its ur blower motor resistor by ur blower

Jun 19, 2008 | 2003 Pontiac Grand Am

Not finding what you are looking for?
2006 Chevrolet Colorado Logo

Related Topics:

45 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8518 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...