Question about Jeep Wrangler

Open Question

I have a 95 Jeep Wrangler that won't start anymore. It cranks but relays won't energize and fuel pump won't kick in. I did some research and found out that the capacitors go bad so I pulled them out but I forgot to pay attention to the polarity. So now I don't know which way to put them back in. Oops! I need some help to find a schematic, diagram, or picture to help me install them. Thanks, Jay

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

unsivilaudio
  • 25 Answers

SOURCE: Fuel pump will not run, 96 Neon 2.0 SOHC

Personally I wouldnt bother tracing the wire as it is probably not worth your time, and just run a constant 12v from the battery to the relay on like 10ga wire. There is probably a short somewhere in the system which can be a real headache to find.

Also it may sound dumb, but check your fuses, and the fusible links under the hood. Chances are that they are all fine though, especially if you have dash lights.

Posted on Dec 30, 2008

seans46
  • 161 Answers

SOURCE: Diagram or proper schematic of fuel pump relay

The Owners Manual under Relays will tell you the location of it. If for some reason it doesnt emial me and I will find it for you. seans46@yahoo.com

Posted on May 24, 2009

  • 1 Answer

SOURCE: 90 jeep starting problem

Check the crank position sensor. I had the same problem in a 1989 cherokee 4.0, and the solution was simply to acomodate the sensor wiring. No replace was necesary

Posted on Jun 11, 2009

junit80
  • 81 Answers

SOURCE: 2007 Jeep Wrangler x will not start. put new fuel pump but still

check to see if their is any fuses blown or change out the fuel pump relay and also check to see if the ground to the fuel pump is getting a good connection these things should solve your problem.Good luck

Posted on Jun 23, 2009

  • 811 Answers

SOURCE: 95 jeep yj 2.5 crank but no start fuel pump not

check fuel pump relay, check main fuses

Posted on Sep 12, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

95 jeep wrangler extended crank time.


This system requires rpm signal before it will power up fuel pump .
THE PCM POWERS UP THE FUEL PUMP FOR TWO OR THREE SECONDS AT KEY ON !

Oct 06, 2016 | Jeep Cars & Trucks

1 Answer

4.0l, i6, fuel shut off


If the ECU is going bad, you will get no power to the fuel pump. Might not even be getting spark when cranking. Try leaving the ignition turned on for a few minutes, to see if the check engine light comes on and if the fuel pump relay energizes. Search this site for the Delayed start check engine light problem.

Sep 12, 2013 | 1992 Jeep Wrangler

1 Answer

2000 jeep wrangler won't start, good crank, no bus


Check fuses first, but could be needs new CPU

Jun 14, 2012 | 2000 Jeep Wrangler

1 Answer

Have a 1998 Chevy Blazer - 4 wheel drive - that cranks but does not start.


those are good for the fuel pumps going bad
have someone crank it while you bang on the tank with a piece of wood or kick it. 95% of the time i can get a bad pump to work one more time by doing this and it also is an easy way to prove it was the fuel pump

Mar 21, 2010 | 2003 Jeep Wrangler

1 Answer

95 wrangler wont start


Please refer to this solution: http://www.fixya.com/cars/t1016149-1989_jeep_cherokee

It's probably the A/C relay under the hood indeed. And your battery might have gone bad too.

Aug 23, 2009 | 1992 Jeep Wrangler

2 Answers

2007 Jeep Wrangler x will not start. put new fuel pump but still will not start. Feul pump does not kick on when key turns>???


check to see if their is any fuses blown or change out the fuel pump relay and also check to see if the ground to the fuel pump is getting a good connection these things should solve your problem.Good luck

Jun 23, 2009 | 2003 Jeep Wrangler

8 Answers

95 Jeep Wrangler wont start


Listen, You need a new computer. Those are your relays clicking. There is no signal from the relays going to your computer to tell the Jeep to turn on. Cause your computer is broke. Check online for the best price. I bought mine from autozone.

Aug 07, 2008 | 1995 Jeep Wrangler

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

38 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...