Where is egr located on dodge ram 1500 mega cab

Marvin

• 85242 Answers
• Posted on Nov 30, 2008

SOURCE: 1997 Dodge Ram 1500 transmission will a 1996 interchange

No, the frame is different.

ZJ Limited

• 17989 Answers
• Posted on Sep 14, 2010

SOURCE: I cant locate the egr

An EGR valve assembly located at the front of the intake manifold. The EGR valve is a poppet style valve (on/off only) and is controlled by an internal diaphragm.



Fig. EGR location and associated components-California diesel

Hope helps (remember to rate this and comment ).

SOURCE: Dodge Ram 1500 can it have a plow?

Yes It can and It should not void the warranty. Contact your dealer.

SOURCE: 2005 Dodge 1500 code p0404 EGR valve.

The electronic EGR valve and solenoid assembly is attached to the rear of the left cylinder head ,

1. Remove electrical connector (5) at top of EGR valve solenoid.
2. Remove tube mounting bolt (1) at intake manifold.

1. Remove two bolts (4) connecting EGR tube (1) to valve assembly.
2. Remove gasket located between EGR tube flange and EGR valve assembly.
3. Remove two EGR valve mounting bolts (5).
4. Separate valve assembly (3) from engine.
5. Remove and discard metal gasket located between cylinder head and valve assembly.

1. Clean area at rear of left cylinder head where it joins base of EGR valve.
2. Clean EGR tube where it joins EGR valve.
3. Position new gasket between EGR valve and cylinder head.
4. Position EGR valve to cylinder head. Install and tighten two bolts (5). Refer to Torque Specifications.
5. Position new gasket between EGR tube flange and EGR valve assembly.
6. Position EGR tube (1) to side of EGR valve and into intake manifold.
   1. Install EGR tube flange bolt (1) at intake manifold. Tighten bolt. Refer to Torque Specifications.
   2. Connect electrical connector (5) to top of EGR valve solenoid (2).Do a final tightening of two EGR tube bolts (4). Refer to Torque Specifications

SOURCE: Replacing the housing part # 68004226AB

Go to this link:
http://www.cumminsforum.com/forum/3rd-gen-non-powertrain/95123-heater-blower-motor-working-but-not-blowing-air-easy-recirc-door-replacement.html


Read the entire link.

The is an easy procedure and the part number are all in the forum post.
Soilution#1 on this thread seems a little touchy...with going in from the top and fiddling with the air bag and all.