Question about 2005 Buick Terraza

Open Question

Remove front console - accessory power outlet not working

Posted by on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the signal light relay that makes signal lights flash located on 2000 ols intrigue 3.5 liter


Important: The hazard warning switch includes the turn signal and hazard warning flashers.
Removal Procedure
Remove the center air deflector. Refer to Instrument Panel Center Air Outlet Deflector Replacement .
Squeeze the retainer on the backside of hazard warning and cruise control switch.
Pull the hazard warning and cruise control switch from the retainer in the instrument panel.
Disconnect the electrical connectors from the hazard warning and cruise control switch.
Remove the hazard warning and cruise control switch from instrument panel.
Remove the hazard warning and cruise control switch bezel from the instrument panel trim pad by using a small flat-bladed tool to the release retainers.
Remove the radio. Refer to Radio Replacement in Entertainment.
Reach through the radio opening and push the retainers up towards the roof of the vehicle. When the retainers release, slide the instrument panel (I/P) center air outlet deflector out of the I/P opening
Remove the air outlet deflector
Remove the instrument panel accessory trim plate. Refer to Instrument Panel Accessory Trim Plate Replacement in Instrument Panel, Gauges, and Console.
Remove the bolts from the radio.
Pull the radio toward you.
Remove the front floor console trim plate. Refer to Front Floor Console Trim Plate Replacement .
Pull the instrument panel (IP) accessory trim plate away from the IP trim pad.
Disconnect the IP harness seat heater leads, if equipped.
Remove the seat heater switches from the IP accessory trim plate, if equipped.
Remove the IP accessory trim plate.

Nov 09, 2016 | Cars & Trucks

1 Answer

Center console removal


Well, this good to be interesting to say the least, and probably long as well. By my gm. service information your going to need to take out the front bucket seats so the sides of the console can come off.


Remove the left front seat . Refer to Bucket Seat Replacement .



1



Front Floor Console Extension Panel



2



Retainer Clip (Qty: 5) same for right side.



showgif.do?image=1875475





tif.gif








Callout







Component Name






Preliminary Procedure

Remove the right front seat. Refer to Bucket Seat Replacement .







1





Front Floor Console Extension Panel







2





Retainer Clip (Qty: 5)








Front Floor Console Accessory Trim Plate Assembly


Procedure

Use a flat bladed plastic trim tool in order to release the console accessory trim plate from the console assembly.



2



Retainer Clips (Qty: 5)



Remove the front floor console accessory trim plate. Refer to Front Floor Console Accessory Trim Plate Replacement.



1



Front Floor Console Accessory Housing Screw (Qty: 2)




Notice: Refer to Fastener Notice in the Preface section.




Tighten

2 N?·m (18 lb in)



2



Front Floor Console Accessory Housing Assembly


Procedure




  1. Disconnect the electrical connectors.


  2. When replacing the front floor console accessory housing assembly, transfer all necessary components





  1. Remove the rght or left front floor console extension panel. Refer to Front Floor Console Extension Panel Replacement - Right Side or Front Floor Console Extension Panel Replacement - Left Side .


  2. Remove the front floor console cup holder housing. Refer to Front Floor Console Cup Holder Housing Replacement .



1



Front Floor Console Rear Trim Panel Screw (Qty: 1)




Notice: Refer to Fastener Notice in the Preface section.




Tighten

2 N?·m (18 lb in)



2



Front Floor Console Rear Trim Panel



3



Retainer Clip (Qty: 4)


Preliminary Procedures


  1. Remove the front floor console accessory trim plate. Refer to Front Floor Console Accessory Trim Plate Replacement .


  2. Remove the right and left front floor console fillers. Refer to Front Floor Console Filler Replacement .



1



Front Floor Console Armrest Assembly Bolt (Qty: 4)




Notice: Refer to Fastener Notice in the Preface section.




Tighten

9 N?·m (80 lb in)



2



Front Floor Console Armrest Assembly


Procedure

Position the armrest assembly out of the way leaving the electrical harness attached.



3



Front Floor Upper Console Trim Plate


Procedure

Lift the rear of the trim plate first, releasing the retainers securing the trip plate to the console assembly.



4



Retainer Clips (Qty: 4)



Front Floor Console Replacement (Enclave)





showgif.do?image=1858392





tif.gif








Callout







Component Name






Preliminary Procedures




  1. Remove the front floor console accessory trim plate. Refer to Front Floor Console Accessory Trim Plate Replacement .


  2. Remove the right and left front floor console extension panels. Refer to Front Floor Console Extension Panel Replacement - Right Side and Front Floor Console Extension Panel Replacement - Left Side .


  3. Disconnect the automatic transmission range selector lever cable. Refer to Range Selector Lever Cable Replacement .







1





Front Floor Console Screw (Qty: 2)




Notice: Refer to Fastener Notice in the Preface section.




Tighten

2 N?·m (18 lb in)







2





Front Floor Console Bolt (Qty: 10)




Tip

Before installing the right lower forward bolt, ensure that the console wiring harness is tucked below the fastener location to avoid driving the bolt into the harness.




Tighten

9 N?·m (80 lb in)







3





Front Floor Console Assembly


Procedure



  1. Note location and routing of the front floor console wiring harness prior to removal of the front floor console assembly to ensure proper reinstallation.


  2. Disconnect the electrical connectors.


  3. With the aid of an assistant remove the console assembly from the vehicle.


  4. When replacing the front floor console, transfer all necessary components.





h4hqqpweof7+aaaaaelftksuqmcc

arzs+0tf0j6faaaaaelftksuqmcc

Jan 10, 2015 | 2008 Buick Enclave

1 Answer

2007 Chevrolet Avalanche Accessory power outlets don't work


Do the power outlets have a different fuse than the cig lighter ?

Jul 22, 2012 | Chevrolet Chevy Cars & Trucks

2 Answers

My lighter doesnt work, i have two and one doesnt work


There are actually FIVE cigarette lighter/ Auxilliary Power Outlets shown in the wiring diagrams for your vehicle.
The Instrument Panel [1] Accessory Power Outlet (Cigarette Lighter) is protected by the "LTR" Fuse (# 53 - 20 Amp) in the Power Distribution Center (PDC) in the engine compartment.

The Instrument Panel [2] Accessory Power Outlet is protected by the "AUX PWR" Fuse (20 Amp) In the Instrument Panel Fuse Block on the left side of the dash.

The Center Seat Accessory Power Outlet and the (two) Center Console Power Outlets are protected by the "AUX PWR 2" Fuse (20 Amp) In the Instrument Panel Fuse Block on the left side of the dash. NOTE: If your vehicle is not equipped with the Center Seat Accessory Power Outlet, or the Custom Floor Console (optional), this fuse position will most likely be empty.

Feb 05, 2012 | 2008 Chevrolet Silverado 2500HD 2WD

1 Answer

My cigarette lighter works but none of the 3 power accessory outlets do. Where or what other fuse can I check. Manual does not show a fuse place for the power accessory outlets. Can you help


If its a factory item then it has a fuse in one of the fuse panels, under hood, under dash, on ends of dash, or even under the front or back seats. If its one someone installed then the fuse is somewhere in it's positive wire, stuffed under the dash or behind the console.

Aug 23, 2011 | GMC Envoy Cars & Trucks

2 Answers

I have a 2008 gmc acacia. The front and mid auxiliary power outlets don't work. The fuse box is on a horrible location. I can't figure out which fuse it is and I don't want to spend hours...


{: ) At the underhood fuseblock, the AUX PWR fuse 20amps is for the Instrument panel and center console outlets, while the RR APO fuse 20amps is for the rear console and rear power outlets.
If your vehicle is equipped with an accessory 110vac, there is this PWR OUTLET fuse 25amps also at the underhood fuseblock. See red arrows on the sample diagram below:


wyet_helps_12.gif Safety reminders: Use only fuses of the same specifications. A higher fuse rating replacement can heat the wirings and could cause fire.

Jul 21, 2011 | 2008 GMC Acadia

1 Answer

2005 Honda Pilot w/Navi. The front Power outlet unscrewed.


Search on the internet for instructions to install a Pilot cigarette lighter and ashtray. Steps 4 and 5 detail how to remove the console trim. I couldn't find the clips talked about in step six, so I Gently pulled out the base of the front console far enough to get a pair of pliers back there to tighten the power outlet. I have a 2005 Pilot without the Navi sys. Good luck!

Jun 04, 2010 | 2005 Honda Pilot

2 Answers

Front and center console 12v accessory power outlets not working


look under the drivers rear seat for the rear fuse block it will be under a black box right there

Aug 25, 2008 | 2003 Chevrolet TrailBlazer

Not finding what you are looking for?
2005 Buick Terraza Logo

Related Topics:

57 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8210 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...