Question about 1995 Buick Century

1 Answer

1995 buick century hesitating. I turn off engine and then crank back and it's fine few a while. Then starts hesitating again. I changed the trans filter and fluid and ran like a charm for 1 day, The second day started jerking when braking. Any one know????

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 3,072 Answers

Sometimes a PVC valve will cause this problem, it may need a tune up,also. Hope this helps Tim

Posted on Apr 06, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1994 Buick Century Not Turning Over


Can position sensor, maybe, or it might be called a pick-up coil. This sensor is needed along with crank position sensor for computer to determine spark timing.
When you get it started, and if you still have the up and down idle, check for an intake manifold leak.

Jan 06, 2013 | 1994 Buick Century

1 Answer

1994 Buick Century 3.1 liter V6. Engine fail and no crank/start hot


The engine in this car is controlled by a computer, whenever a problem like this occurs a fault code is almost always recorded for the event in history memory of the computer. You need a shop to read this code and perform eh proper diagnostics report the problem. Knowing this make i would say the CKP sensor is defective.

Jun 22, 2012 | 1994 Buick Century

1 Answer

I have a 1999 buick century with a 3.1 engine stop running while driving,ran codes came back with crank sensor,multiply cylinder misfire changed crank sensor,cleared codes,will start,but idles very rough...


Did you replace the crank sensor that is in the engine block between the engine and transmission? it has two and the one by the pulley hardly ever goes bad.

Dec 12, 2010 | 1999 Buick Century

1 Answer

Can i put a 1995 buick century tranny into a 1995 buick park ave if the engines are different?


firstly, count the transmission pan bolts. if both trans are the same, then yes you can swap these trans easily.

Jun 21, 2010 | 1995 Buick Park Avenue

2 Answers

2002 Buick Century 3.1L V6 hesitates to start


With everything you have done the only thing left is the MAF or Map sensor . This is what tells the computer the altitude and air density to know how to deliver fuel.. If its lying to the computer you will have drivability problems. A scanner will show this data.

Jul 20, 2009 | 1995 Buick Roadmaster

1 Answer

Buick century 1993 stalls while driving After driving for a while the car stalls out. It's dangerous because sometimes I'm on a highway. It starts immediately after that and goes a bit then stalls again....


i had the same problem with my 92 exept after mine stalled it wouldnt start for 20 - 30 mins... mine ended up needing a transmission flush for the stalling problem and i tried to drive everyday that helped
hope this helps in some way

Jun 13, 2009 | 1993 Buick Century

1 Answer

1998 Buick Century- Service Engine Light Soon came on


i had a simaler problem(still having problems but not this one anymore) i had a local mech. look at it and he said it must be a vacume leak,but it stumped him as it would shut down then u pull over and wait a min. and it would start and run fine for a few miles or days...i followed the "air/vacume" line off the pcv vale i think to the back of my engine near firewall and on the intake right below the coilpack was a hose loose that came out of a rubber t shaped connection,i put it back in and have never had this problem again...im on a new problem now..lol...hope this helps you out...good luck to all buick owners..:)

Jan 01, 2009 | 1998 Buick Century

1 Answer

Car cranks, but hesitates to start after sitting for over 24hrs


Tune ups are always a good place to start , including air, fuel, plugs and for the extra 5 bucks a PCV valve. If these havn't been done in the last year at least might want to start there. If that doesnt make any difference please post again and we will look at something else!

Dec 15, 2008 | 1995 Buick Roadmaster

2 Answers

1995 buick century transmission trouble


Most likely causes is the OD shift solenoid or less likely the VSS

Oct 25, 2008 | 1995 Buick Century

Not finding what you are looking for?
1995 Buick Century Logo

158 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7768 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...