Question about 2000 Jaguar S-Type

1 Answer

I have a 2000 s-type 8cyl and it hesitated around 40 to 60 the check engine light came on it was #3 we changed it out and ran fine for 2 days came on again we changed some coles around and ran fine for 3 daqys and came on again and now it worse and its now reading #2 and the gearbox came on then off. It seems like it does not shift sometimes. It has 61,000 miles. What should I do.

Posted by on

  • krisbai71 Apr 06, 2011

    The #3 kept comeing up for the check engine light so we switched it out a couple of times. But it kept on driving ruff and light would come back on. He changed coils around I dont know why.

×

Ad

1 Answer

Just because you get a PO301 thru PO308 does not
always mean that coil is bad

Why would you change coils around?
Now you most likely haven't keep track
of what might have been a bad one

You need to either walk a new coil or have
an oscilloscope put on the coils to find the
bad one.

The shift stratagy could be off due to a
bad TPS Sensor or other issue

You need a repair shop

Posted on Apr 06, 2011

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2007 Toyota Rav4: RPM fluctuates at around 2000 RPMs and engine seems to stutter or hesitate. Fairly consistent around 2000 RPMs. Does not happen when revved in park to 2000 or 2500 RPMs.


You need to check the engine for a vacuum leak, use a spray can of carb spray and lightly spray around engine (do not get on paint finish) when you hit a leak the engine idle will change

Apr 06, 2018 | Toyota Cars & Trucks

1 Answer

2012 Kia Optima.....won't start....makes clicking sound but dash lights come on.......shows engine light


Possible weak/ dead battery. try boosting it before we can diagnose a faulty starter

Oct 07, 2017 | Kia Cars & Trucks

1 Answer

I have a 2004 Chrysler Concorde Lx had a code reader saying I needed to change my cam sensor read 3 codes with that changed it out and reread codes, reset the code and engine light went out for the whole...


is it the sensor or sensor circuit if circuit need to check wiring and connections --and the other 3 codes did you correct them or just cleared all codes when sensor was replaced

Jul 16, 2017 | Cars & Trucks

1 Answer

I have a 2004 Jeep GC 6cyl 4WD. My check engine light is on, scanned and got P0203, P0300, P303. Changed the spark plugs, fuel injector #3. Started it up and ran rough, I left it in the garage all night...


codem p 0203 refers to injector 3---circuit malfunction===causes wiring--injector--ECM
chweck for harness connection , bad wire for no 3 injector or corroded pins for no 3 injector in the connection

May 14, 2017 | 2004 Jeep Grand Cherokee

1 Answer

At about 4000 RPM the check engine light flashes and there is hesitation. The read out says misfire in #3. I have a 2000 GMC Yukon, During regular speeds it is fine. There also seams to be a hesitation...


Your catylatic converter may be clogged if your loosing power or top speed is less than it was. You can check this when its running with a battery operated infared heat gauge. the temperature of the muffler should be around the same temp. as the catylatic converter.

Sep 24, 2009 | 2000 GMC Yukon

2 Answers

2001 focus. Replaced plugs, wires and coil pack. Ran fine for a few days. Hot day traveld about 28 mile ran fine. then without notice hesitated, loss of power going up hill around 35 -40 sputterd and...


Have you replaced the timing belt? if not i would highly recommend doing so. these cars need to have the timing belt replaced before it breaks otherwise it can and will cause major engine damage.

Aug 10, 2009 | Ford Focus Cars & Trucks

2 Answers

1994 mercury cougar turns over but does not start


Need MUCH more information in order to help.

Is the engine getting spark? Is their fuel pressure at the rails ?
Is their oil in it ? Battery connected properly ? Miles on the engine?
Engine size ? Has any one ever replaced the neutral safety switch ?

Jun 01, 2009 | 1994 Mercury Cougar

1 Answer

Hesitation during acceleration


could be the type of plug you are using.I was told only to use ngk plugs.I recently put bosch plugs in my mazda 3 and the check engine light came on and it started missfiring.

Apr 26, 2009 | 2004 Mazda 3

2 Answers

Car hesitation


sounds like the coil pack is failing or you could just have water in your fuel.... buy a couple bottles of gas line antifreeze (it sucks up water) and add them to your tank when you fill up.... if that doesn't fix it it is likely the coil pack

Apr 16, 2009 | 2004 Chrysler Sebring

Not finding what you are looking for?
2000 Jaguar S-Type Logo

Related Topics:

23 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jaguar Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

yadayada
yadayada

Level 3 Expert

80339 Answers

SPEEDY CAR WORK SHOP...

Level 2 Expert

489 Answers

Are you a Jaguar Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...