Question about 1998 Oldsmobile Silhouette

Open Question

Can you tell me location of canister vent solenoid for 1999 Oldsmobile Silhouette.

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 119 Answers

SOURCE: ECM location 1998 Oldsmobile Silhouette

On the 98 Silhouette, the PCM should be located in the air filter housing.

Posted on May 21, 2008

Ad
emissionwiz
  • 76846 Answers

SOURCE: drain the antifreeze on a oldsmobile silhouette

Under the bottom of the radiator on the there is a drain ****, you will have to raise the car and crawl under it to see it, be careful to not break it, the screw in plug is fragile, it will be hard to unscrew.

Posted on Oct 11, 2008

  • 275 Answers

SOURCE: 2004 Pontiac Grand Prix Evaporative Canister

you should be able to fix it look for a can near the fuel tank that has vacuum hoses coming out of it and you should be able to just buy the bad solenoid

Posted on Nov 03, 2008

  • 37 Answers

SOURCE: HAVE A TROUBLESHOOTING MESSAGE PO446

DTC P0446 Evaporative Emission (EVAP) Vent System Performance

The vehicle control module (VCM) monitors the performance of the evaporative emission (EVAP) system by applying a predetermined level of vacuum to the EVAP system and monitors the vacuum decay rate. The VCM sets this diagnostic trouble code (DTC) if the vacuum decay rate is more than a predetermined value. The VCM monitors the amount of vacuum and the amount of pressure in the EVAP system by monitoring the fuel tank pressure sensor. For this DTC, the VCM turns ON both the EVAP purge valve and the EVAP vent valve when the Conditions for Running the DTC are met. This applies an engine vacuum to a closed EVAP system. The VCM turns OFF both the EVAP purge valve and the EVAP vent valve when the system reaches a correct amount of vacuum. The EVAP system should quickly RELEASE the vacuum in the EVAP system with the EVAP purge valve OFF and the EVAP vent valve OFF (open). This test indicates a blocked or restricted EVAP vent path if the EVAP system fails to release the vacuum quickly enough.

3208f98.gif


Posted on Dec 06, 2008

  • 1 Answer

SOURCE: OBD code P0499, P0499 NVLD Canister Vent Valve Solenoid, Cause?

its above ur fuel tank from what i kno of but it could be ur canister or just a short in the wire to ur solenoid

Posted on Jan 17, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1999 6 cyl. Where Is The evap canister vent solenoid located?


The canister is located under the rear driver's side bumper, behind the rear wheel, above the exhaust pipe, next to the fuel tank. The Canister Vent Solenoid is mounted on the canister toward the rear of the car. The Canister Purge Solenoid is mounted in the front passenger side wheel-well, under the large protective plastic above the tire. The system is connected to the intake manifold on the passenger side just on the engine side of the throttle body. The service port is on the passenger side next to the A/C condenser.
Hope this helps you out

Apr 25, 2016 | Ford Mustang Cars & Trucks

1 Answer

I'm trying to find the canister vent valve solenoid on a 2000 Alero Oldsmobile


Evaporative Emission Canister Vent Solenoid
Under the rear of the vehicle

Sep 17, 2015 | Oldsmobile Cars & Trucks

1 Answer

I have a 1999 oldsmobile aurora, northstar motor. I was told I need to replace my purge valve solenoid. Can someone please tell me where it is located?


It's under the plastic cover on top of the engine . Remove the intake manifold top cover.
Remove the solenoid quick-connect hose (3) at the EVAP canister purge solenoid (4). Remove the solenoid quick-connect hose (7) from the EVAP canister purge solenoid (4) to the enhanced EVAP service port (8). Remove the electrical connector (6) at the EVAP canister purge solenoid. Remove the EVAP canister purge (2) solenoid valve bolt. Remove the EVAP canister purge solenoid tab from the bracket (5).

Aug 06, 2015 | 1999 Oldsmobile Aurora

1 Answer

Canister vent valve solenoid


EVAP Vent Solenoid Valve
Behind left rear fascia splash shield behind wheel well

Apr 20, 2015 | 1998 Oldsmobile Silhouette

1 Answer

Canister vent solenoid


it is not on the fuel tank it is on a small box located near the fuel tank or in some cases it is located on the vent line going to the vent boox

May 08, 2014 | 2004 Buick Rendezvous

1 Answer

Sometimes when i turn my van off it will not start back up until an hour later


run fault codes and look for a problem in the canister area ---vent purge valve ---solenoid etc . There may be a vacuum in the tank which is sucking the fuel back and drying out the fuel manifold until the vacuum is low enough for the pump to overcome it and pump fuel through

Feb 17, 2014 | 2002 Oldsmobile Silhouette

2 Answers

1999 ford winstar v-6 3.8 l ! what is a canister vent solenoid, i got code #p1451 and where is it located


Did you check the block box connected to the vent solenoid? There's a hose that comes off it that appears to run nowhere, that's the fresh air vent. If it's blocked it won't allow air into the system which will set the trouble code. If that's clear, the vent solenoid itself is bad and needs to be replaced.

Sep 11, 2012 | Ford Cars & Trucks

1 Answer

What is code P0449 for 1999 oldsmobile silhouette?


code 0449 evaporative emission control system vent valve solenoid circuit malfunction check your fuses as well as connections and power going to the solenoid see manual for location of valve

Jun 28, 2012 | 1999 Oldsmobile Silhouette

1 Answer

Where is the vent selonoid located on a 1999 oldsmobile intrigue with a 3.8 engine?


Vent solenoids are located with the charcoal canisters. Usually under the car behind the gas tank. The canisters are black and the size is about 2" thick,5" wide and 8" long has several plastic hoses going to it. The solenoid will be the only thing that has an electrical plug

Jun 28, 2011 | Oldsmobile Intrigue Cars & Trucks

Not finding what you are looking for?
1998 Oldsmobile Silhouette Logo

Related Topics:

231 people viewed this question

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8575 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...