Question about Pontiac Trans Sport

1 Answer

Where do I split the steering colum when dropping the cradle to remove the engine

Posted by Anonymous on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Pontiac Master
  • 715 Answers

It's easier to remove it at the rack, should be a 10mm bolt, you have to remove the bolt completly to clear the notch

Posted on Apr 05, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

3.1l. How to remove engine


The engine comes out through the bottom

May 18, 2016 | Oldsmobile Cutlass Supreme Cars & Trucks

2 Answers

1991ford van won't shut off


It will when it runs out of gas....just trying to lighten the situation up. Sorry..

Seriosly, are you saying that when you turn the ignition switch to the off position the engine continues to run?

May 29, 2014 | Cars & Trucks

1 Answer

How to remove engine from aford focus, do you split of the gear box


yes anytime you pull a front wheel drive engine you will split the engine and trany from each other unless... you can drop it out the bottom all together on the K member/ engine cradle. its all about the same time to do it either way.

Oct 06, 2011 | 2003 Ford Focus

1 Answer

Need to remove steering column on a 1992 lincoln town car


Remove the steering wheel, turn signal reset (plastic), remove clip and spring. Remove trim to expose the entire colum. Disconnect all connectors. There are four main bolts holding the colum up. Remove the bolts and lower the colum. At the end of the steering shaft there is a bolt going through the colum. Remove the bolt. The colum can then be removed.

Mar 04, 2011 | 1992 Lincoln Town Car

1 Answer

My 99 blazer s10 wit 4.3 engine at idle lopes or skips changed injectors,fuel pump,tps sensor thermostat,egr is workin,tuned up plugs wires cap rotor,fuel ,air filter, had inte man resealed,brougt it to 2...


replace the electric part of the ignition down on the steering colum ....u will have to drop the steering colum down but not totaly remove...fixed 2 s-10 trucks same year that way

Nov 26, 2010 | 1999 Chevrolet Blazer

1 Answer

How do I drop the steering column to replace the ignition switch on top of it?


Take the plastic from the dash underneath steering colum , There will be metal bracket with 2 nuts you need to take off. This will allow the steering colum to drop down enough for you to get to switch . It still kinda hard to get to but doable .

Aug 28, 2010 | 1992 Oldsmobile Cutlass Ciera

1 Answer

How do you change a rack and pinion on a ford windstar


This is a repair that should not be attempted by a novice! Put the van in the air,remove the front wheels,remove the cotter keys from the tie rod ends and remove the nuts and separate from the spindle,Remove the Power steering lines from the rack and pinion unit,Remove the single bolt that attaches the rack to the steering shaft,Remove the two large steering rack mounting bolts from the engine/transaxle cradle, with support under the engine/transaxle cradle remove the rear mounting bolts slowly lower the cradle slowly to gain access to remove rack assembly and reverse for installation. NOTE: Install new seals on the power steering lines and when removing outer tie rods from the rack count how many turns it takes to remove the end and put it back on the same amount of turns. Refill the system with proper fluid and have the vehicle Front end aligned!!!!!!!!

Aug 27, 2010 | 2000 Ford Windstar

1 Answer

Just wondering if anyone knows where the igntion Starter switch is located in my 99 Caravan 3.3 v6


ignition switch is in the steering colum,the plastic around the colum will split open when u remove all the screws

Jun 28, 2009 | 1999 Dodge Caravan

1 Answer

How to drop the steering colum on a 1996 Chevy Blazer.


remove the trim panel from under the column, then there are two nuts that attach the column to the dash support, remove them to drop column down..

May 19, 2009 | 1996 Chevrolet Blazer

1 Answer

Engine change


Drop cradle with engine, tranny, steering rack, front struts and all attached to it.

May 10, 2009 | 1994 Pontiac Trans Sport

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

31 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7782 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...