Question about 1988 Chevrolet Blazer

2 Answers

1999 chevy blazer starter...how many wires attach to it? i thought there were 3 when we disconnected it but now can only find 2. help plzzz

Posted by on

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Chevrolet Master
  • 3,640 Answers

So basicaly run the hot wire to the big stud and the ignition to the smaller one and if it turns over its right? the wire from ignition switch for the solenoid goes to the small stud with S by it.
all other wires go to the battery cable stud. have a good day !!

Posted on Apr 05, 2011

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 638 Answers

Do you have 2 wires , plus the positive battery cable, if so , i believe the 2 wires went to the solenoid, if you only had 1 wire and a positive battery cable, then the 1 wire went to the solenoid, and positive cable went to the starter.

Posted on Apr 05, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1999 chevy blazer wiring harness diagram for remote start


Large purple wire is your starter engagement wire, I believe you will have to tie into more than that wire to get your remote start to work properly, maybe get me brand and model number so I may research more and point you in the right direction as far as installation goes.

Nov 30, 2011 | 1999 Chevrolet Blazer

2 Answers

How do I take a starter off 1997 chevy blazer?


I had to take motor mount loose on that side & lift motor away from mount to get room to remove starter

Apr 01, 2011 | 1997 Chevrolet Blazer

1 Answer

I am trying to replace my starter on a 2000 chevy blazer. Where is it located?


follow red wire from battery towards engine/motor it will be attached to the starter motor it should be between the engine/motor and the gearbox/transmission...hope that helps

Aug 30, 2010 | 2000 Chevrolet Blazer

1 Answer

How do you replace the starter on a 1999 Chevy S10 4 cylinder?


Hi,
Start by disconnecting the negative battery cable.
I don't know if your vehicle is 2 wheel or 4 wheel drive, but please note that on some 4WD vehicles, access to the starter is difficult due to the front driveshaft and/or related hardware. This may or may not be the case with your vehicle, but be prepared to remove other parts if necessary.
There are two bolts that are installed vertically at the bottom of the starter near the bell housing cover. Remove them and hold the starter up while doing so. The starter should then drop down far enough to disconnect the wiring attached to the solenoid. Note where the wires are removed from in order to reconnect them correctly.
Remove the starter and reverse the process to install the new one.
You may have to twist and/or reorient the starter to get it out and to replace it. Remove other parts, such as the bell housing inspection cover, as necessary.
Good luck with your project! Hope this helps...

Sep 29, 2009 | 1999 Chevrolet S-10 Pickup

2 Answers

How do i remove the starter from my s10 chevy truck 2000


remove your positive lead from the battery. Climb under the vehicle and remove the 3 wires attached to the starter, remove the 2 bolts holding the starter in place, install new starter in reverse order.

Sep 16, 2009 | 2000 Chevrolet S-10

1 Answer

Starting Problems AGAIN


Personally, I would return it to the dealer and state that is still not fixed.
When the remote start / security system was removed or disconnected, the starter circuit would have had to be rewired as the remote start / security system prevents the starter from engaging.
The wire splicing that would have had to take place may still be a problem.
If you would rather diagnose this problem your self I will be happy to help.
Let me know.
Regards,.

Feb 19, 2009 | 1999 Chevrolet Blazer

1 Answer

Starter 99 s10


First disconnect the positive battery cable. You already have the bolts out. pull the starter back and down and it will drop out. do not let it hand from the wires. Disconnect the wires to the starter. Pay attention as to which wire comes off what terminal. They must be attached correctly or your starter will not crank after installation. Then the last thing you do will be to hook the battery up again.

Jan 21, 2009 | 1999 Chevrolet S-10 Pickup

1 Answer

1999 Chevy Blazer Starter


the starter is located on the passenger side lower motor. it has two bolts in it that hold it in place. it actually goes through a hole/slot in the transmission to the flex plate.

1st. disconnect the negative cable on the battery.
2nd. raise the vehicle safely and place a jack stand under the vehicle out of your way but near where you will be working(for safety).
3rd. remove the two bolts that hold the starter in place.
4th. remove the wires from the back of the starter.
5th. install in reverse order of above.

note: there may be little plates between the starter and the mounting points called shims. if there are then make sure you put them back.

Sep 24, 2008 | 1999 Chevrolet Blazer

1 Answer

Wireing on starter, 1997 chevy blazer 4x4.


this just jumps to the other large post (battery power) on the starter -jeff please rate

Jun 30, 2008 | 1997 Chevrolet Blazer

Not finding what you are looking for?
Cars & Trucks Logo

216 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8152 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...