Question about 2007 Lexus ES 350

1 Answer

I unhooked the battery for like 12 hours then hooked it back up and car won't start

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Do the lights show up on the 'push to start'? If not, then I believe your computer system is locked out and you will probably need a lexus dealership to reset the computer system.

Posted on Apr 18, 2011


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

2008dodge ram wont start after unhooking battery

Won Start or won't keep running , Well if it won't start you need to hook thebattery back up. But if it won't stay runnig after youstart it then removed the hot wire ,(your Alternadter is'nt charging )

Apr 03, 2013 | 2005 Dodge Ram 1500

1 Answer

1996 Saab 900 Radio Won't Accept Code

unhook the battery for an hour or so to fully clear any previously bad entry attempts. hook battery back up and try the code again

Dec 23, 2012 | 1996 Saab 900

2 Answers

My jeep won't start or even turn over

you need to check the voltage at the battery when you have trouble. should always remain above 12 volts.
If not then the battery or the connections are bad. first test the battery right at it's lug terminals, then check the terminal connectors. battery or cable or connectors - def sounds like major voltage issue in the battery area!

Mar 27, 2017 | 1994 Jeep Wrangler

1 Answer

My 1997 Subaru Impreza won't turn over.

here is a trick ...jump it off and unhook + batt cable if car shuts off alternator if stays on replace batt

Aug 16, 2012 | 2002 Subaru Legacy

1 Answer

93 jeep cherokee, will not start, not getting fuel...if i unhook the negative cable to the battery it will start after waiting a half hour or so to hook the cable back up.

If the check engine light does NOT come on when cranking at the times when it won't start, then your ECU is in need of repair. The engine will only start after the check engine light comes on and the ecu is what controls that. It's likely going bad, causing the delayed start problem typical of early 90's jeeps. Repair or replacement services for your jeep ECU are available on ebay.

Jul 01, 2012 | 1995 Jeep Grand Cherokee

1 Answer


Unhook batteries and leave unhooked for at least 1 hour or overnight if possible. When you hook the batteries back up your climate control should have power.

Apr 10, 2012 | 2004 Ford Excursion

2 Answers

1994 Cadiallac Deville won't start because of theft system

Unhook battery, let sit for 5 mins and hook back up.

Apr 01, 2012 | 1994 Cadillac DeVille

1 Answer

I have a 2000 Lincoln Navigator. About 2 weeks ago, my air compressor for the suspension quit coming on, and my back end sank to the frame. I read online that it is probably the solid state relay, located...

Wow. I have a Mark VIII, so I can empathize...they really load these things up with electrical controls, and I know from experience to start with basics-get a digital meter and check your battery voltage when the car has been sitting for a few hours, it should be 12.5 volts. Next, check voltage when running-it should be about 15 when first started, gradually dropping down to about 14.2 after a few minutes. I cannot emphasis how important good power is on these power-hungry systems.
Check your connections at the battery, make sure the terminals are immaculate and the lugs are too-and you might try removing BOTH clamps and hold them together for a few minutes to discharge electrical components. Hook them back up (always hook up the positive cable first), and start the vehicle and let it idle for 5 minutes-then gently drive it for another five, to reset sensors. Assuming your battery and laternator are good to begin with, if you still have the problems you describe, you probably have a major malfunction with modules or even the ECM, something the dealer will have to diagnose with a Tech 2 scanner.

Jul 19, 2011 | 2000 Lincoln Navigator

1 Answer

Took battery out now key wont start car security light stays on

Try leaving the battery unhooked for 12 hours. The Passlock system that GM uses is a real pain sometimes. If you get lucky, 12 hours without power will reset the memory and you'll be able to use your key again. This worked for me once on a Chevy Venture I was installing a remote starter into.

Mar 06, 2010 | 2003 Buick Century

1 Answer

Battery go dead after sitting for about 6 hours

first unhook the battery cable and wait 6 hours. If the battery is still charged when you hook it back up then start pulling fuses or relays. That car has so much electrical stuff it will take awhile to pin it down. One thing could be the seatcontrol box under the seat. It controls seat heat, power seats, memory seat. Do the power door locks work ok? A bad switch can drain the battery. How about rear leveling system. Leaky air shocks can make the pump run while the car is sitting. If you can't figure it out get a battery disconnect.

Jul 03, 2009 | 1997 Cadillac DeVille

Not finding what you are looking for?
2007 Lexus ES 350 Logo

Related Topics:

224 people viewed this question

Ask a Question

Usually answered in minutes!

Top Lexus Experts


Level 3 Expert

78267 Answers


Level 3 Expert

917 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Are you a Lexus Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides