Question about 1995 Jeep Grand Cherokee

1 Answer

1995 jeep grand cherokee a/c clutch turns off and on. what can cause this?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • Master
  • 324 Answers

It is normal for the clutch to cycle when set to A/C, Defrost, and Heat/Defrost, depending on the temp setting.

However, if for example, the clutch is cycling when you are set for MAX A/C and have the temp dial all the way down, the cause is usually a low refrigerant charge. To correct this problem, you can either take your Jeep in for service, or purchase an A/C recharge kit at any decent auto parts store.

If you think your problem is a low charge, you may want to consider spending a few extra dollars for a leak detector kit. This kit comes with a refrigerant charge containing a UV dye, a "blacklight" penlight, and enhancing goggles which will allow you to see any external leaks in your system- just follow the directions with the kit, and you will be able to pinpoint a leak if you have one.

Posted on Apr 05, 2011

Testimonial: "It could be low on refrigerant or sensor is defective. jjejuice.com"

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1991f-150xltlarettmanualtransissioncluchrebuild


can i buy a space?
did you post a ford question to the 1995 Jeep Grand Cherokee?
forum section?
no real questing but the statement clutch is slipping
so disconnect the clutch linkage or slave. at the BELL
slips in 1st or Reverse now , is a bad clutch.

easy , huh?

Dec 11, 2013 | 1995 Jeep Grand Cherokee

1 Answer

How do i remove the fan and fan clutch from my 1995 jeep grand cherokee? The water pump pulley is pressed on. When I try to turn the big nut, the pulley turns. How do i stop this?


Leave the serpentine belt on. Get a wrench or use a crescent wrench, hit to the left to loosen. It may take a few hits to loosen but will work. If not, use an air hammer.

Feb 10, 2013 | 1995 Jeep Grand Cherokee

3 Answers

How to permanently disarm alarm on 1995 Jeep Grand Cherokee Laredo


#1 solution for this is to " BUY A GM PRODUCT" & save your money on costly repairs of these chrysler & JEEP (amc) vehicles!

Apr 25, 2012 | 1995 Jeep Grand Cherokee

1 Answer

A/c clutch does not work


1. check fuses
2. check low refrigerant
3. check wire going to clutch
4. with volt meter or test light check clutch wires / bypass clutch turn A/C on; turn ignition on; does the light - light?
5. with ohm meter check cluch wiring - cluch may have burned out

Apr 05, 2011 | 1995 Jeep Grand Cherokee

1 Answer

95 jeep grand cherokee water pump


YOU HAVE TO REMOVE FAN SHROUD FIRST BEFORE YOU CAN REMOVE THE FAN WITH CLUTCH ATTACHED.

Apr 15, 2010 | 1995 Jeep Grand Cherokee

1 Answer

I need to know how to remove the fan clutch shaft from the water pump on a 95 jeep grand cherokee with a v8 clutch shaft looks like it might have reverse threads??


The fan unscrews counter clockwise when facing the engine compartment. A large cresent wrench can be rapped with a hammer, or there is also a speciality tool that can be purchased..

Feb 24, 2010 | 1995 Jeep Grand Cherokee

1 Answer

After i start my 95 jeep grand cherokee limited


crank or camshaft sensor will cause this, a bad crank sensor will cause it not to start or start hard. it controls timing and sends info to pcm for proper fuel mixture and spark at the right time.

Apr 05, 2009 | 1995 Jeep Grand Cherokee

1 Answer

1995 jeep grand cherokee right rear axle bind in sharp turn


If you have a positraction rear differential, the clutches may be sticking. If so, change lube and use an additive for posi rears. After changing lube, go in a parking lot and make a series of tight turns in both directions to get plates to separate and resume normal function. Before changing lube check to make sure it is full and that no suspension components in the rear are broken or loose that could cause rear to move and drag one wheel when turning.

Feb 24, 2009 | 1996 Jeep Grand Cherokee

Not finding what you are looking for?
1995 Jeep Grand Cherokee Logo

Related Topics:

332 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7768 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...