Question about Hyundai Motor 2003 Elantra

Open Question

2003 elantra gls code PO442. where is the location of the purge valve and also where can i find a diagram. Also how to install purge valve

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

emissionwiz
  • 75235 Answers

SOURCE: 01 sonata gls v6...code po455, po442. what are

If you have an EVAP leak, you will get the following codes:

1. P0442 evap emission control system leak (small).
2. P0455 evap emission control system leak (large).

If these codes come up, you need to trace the leak. The most common place for the systems to leak besides the gas cap is at the service port under the hood, the hoses at the purge solenoid, and the hoses around the fuel tank. Check all your EVAP hoses from under the hood , all the way back to the gas tank. You can repair a split hose easily. Buy some 14.5mm EVAP hose at the auto parts store. Just cut the split or cracked section out and attach the new hose.

I can only say that u must fix the code issue and light to pass state emission test, if u reset the light they will know, the system will tell the tester that the system is not ready, this will cause a fail.

Posted on Mar 16, 2009

ghost4548
  • 776 Answers

SOURCE: Location of the Purge Control Valve for 2003 Hyundai Tiburon

There were two different engines which were installed in the 2003 Tiberon... the 2.0 liter 4 cylinder:
22c99c7.jpg

And the 2.7 Liter V6:
cb31feb.jpg

Posted on Jun 06, 2009

  • 94 Answers

SOURCE: purge valve location

On your Tiburon the purge valve is located below the throttle body. It is easier to access if you remove the boot between the airbox and the throttle body. After removing the boot look under the throttle body, the purge valve will be found mounted in a rubber hangar and it has a vacuum hose to both ends.

Posted on Jul 04, 2009

  • 2 Answers

SOURCE: Code PO442 & PO455 on a 2003 Dodge Caravan with 3.3 engine

The problem is most likely to be with your vacuum line they put cheap rubber hose for this purpose. You should find a diagram at the front of the vehicle trace the hoses by this diagram. You most likely will find a bad piece of hose.

Posted on Jul 20, 2009

  • 184 Answers

SOURCE: 2003 Hyundai Elantra GLS. Check engine light, code PO133

Did you use a aftermarket O2 sensor or a genuine Hyundai one? If it's an aftermarket one it may be bad or not as good as the OEM one. See here for more details and other potential causes: P0133

Posted on Feb 11, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is a/c drain hose on 2003 hyundai elantra gls


Look for a hose coming out of your firewall running down to the bottom of the car

Oct 17, 2016 | 2003 Hyundai Elantra GLS

1 Answer

PO442 code on my 2004 mit galant,LS V6 3.8 how to fix an evap problem small leak


the causes for the small leak are listed as
hose connections --intake leak--- EVAP canister--- EVAP canister purge valve
check hoses for small cracks ( old hoses) or replace the purge valve

Sep 19, 2016 | 2004 Mitsubishi Galant

1 Answer

Have a 2003 hyundai elantra gls has code po441 I've replaced the o2 sensor twice and some bad fuel lines the purge valve and canister have been replaced to but still saying po441


This was never an oxygen sensor issue.
There are connections that go from the PCM computer to the purge control and those need to be checked. Check all the hoses again to be sure,

Apr 13, 2016 | Hyundai Cars & Trucks

1 Answer

PO442


code p0442 refers to evaporative emission (EVAP) system--small leak detected====causes hose connection/s---intake leak--EVAP canister---EVAP canister purge valve
it also refers to evaporative emission system --large leak detected (fuel cap loose/ off)===causes---mechanical fault--hose connection/s--EVAP pressure sensor.

Jun 14, 2014 | 2003 Toyota ECHO

1 Answer

Codes0441 0442 0455 0456


codes po441 po442 po455 po456. code po441 - EVAP system no flow during purge conditions.code po442 -EVAP system small leak detected conditions. code po455 - EVAP system large leak detected conditions.code po456 - EVAP system very small leak detected. possible causes loose damaged missing fuel cap.fuel tank sensor disconnected or failed. ORING on top fuel sending unit leaking.purge valve vapor line clogged disconnected or purge solenoid failed.vent solenoid not closing or has failed.

May 23, 2013 | 2002 Dodge Durango

3 Answers

I need to replace the purge valve in my 2003 Hyundai Elantra. I have the new purge valve and am ready to install it. However, I have no idea where the old one is located. I only know that it's under t


I sent to an auto parts place and bought it and casually asked the clerk where it went. He almost offered to go out into the parking lot to help me. He told me where it went, but then I forgot. They ran out of manuals (handy and cheap), but I got one on order. PS: Kia used the same one and it costs either the same or less. Back then there really wasn't much difference between Kias and Hyundais. You could call up one of the nationally known auto parts suppliers and simply ask the guy over the phone and tell him you'll come down and pick it up if he has one.

Mar 18, 2013 | 2003 Hyundai Elantra

1 Answer

Where is the air charge temp sensor located on a 2003 hyundai elantra


WHERE IS AIR CHARGE TEMP. SENSOR LOCATED ON A 2003 HYUNDAI ELANTRA

Nov 07, 2012 | 2003 Hyundai Elantra GLS

1 Answer

Hyundai Elantra GLS 2003 starter does not work


it can if you have the proper tools and a little patience its not very hard at all it may be a little snug i cant remember off hand where the starter is located on that car but its relatively an easy fix.

May 21, 2010 | Hyundai Motor 2003 Elantra

1 Answer

2000 elantra po455 code evap emission control system leak detected (gross leak) Any suggestions ?


Large leak?... Fuel Cap not tight or the wrong one is installed. Also, the charcoal canister close valve may be stuck 'open' AND/OR the purge control solenoid valve may be stuck 'closed.'

Oct 13, 2009 | Hyundai Motor 2003 Elantra

2 Answers

Let our Experts solve your "I have a 2002 Hyundai Elantra with fault code P0441 Not sure what this code means or how to fix the Problem.


P0441 is evap system insufficient purge. It means that the computer thinks the purge control valve isn;t operating properly. The fuel tank pressure sensor can send faulty info causing code to set but most of the time it is just the purge valve that needs replaced

May 03, 2009 | Hyundai Elantra Cars & Trucks

Not finding what you are looking for?
Hyundai Motor 2003 Elantra Logo

Related Topics:

117 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7782 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...