Question about Ford Freestyle

Open Question

My oss sensor is bad on my 2006 ford freestyle. 2wd sel. is it easy to get to and change or does the transmission have to be removed to get to it?

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

alicantecoli
  • 22095 Answers

SOURCE: change oxygen sensor 2001 ford windstar

fist unclip wire,then unscrew it with a 28mm spanner ,fitting procedure is the reverse .It turns anticlockwise to unscrew and clockwise to screw up ,torque setting is a grunt and two scuffed knuckles and max of 3 swear words

Posted on Jan 01, 2009

MNfisherman
  • 11896 Answers

SOURCE: Transmission Speed sensor wire on 06 Ford E-350

The older vehicles have a cable that hook up to left side of tranny. New vehicles have the speed sensor on the wheels and run to ECU then to speedometer

Posted on Jul 09, 2009

moparownr
  • 667 Answers

SOURCE: 1999 FORD EXPEDITION 2WD 4.6L EGR VALVE,EGR

Remove the throttle body housing on the top of the intake, it is a 90 degree tunnel like small piece held by 4 small bolts, turn it over and look for two holes, these holes are for the EGR valve flow, they are probably plugged up with carboned crud, clean them out with the tip of a screwdriver if neccessary to remove all the crud, once its clean reinstall it and reset your check engine light, hope this helps, let me know

Posted on Dec 04, 2009

  • 1 Answer

SOURCE: do I need to change transmission fluid on my 2005 ford freestyle

The high pressure filter and fluid are supposed to be changed at 60k intervals. Ford has a very specific oil for this transmission and the service fee will be $300 to $450 - mine was around $420.

No other car place will touch the CVS transmission in a Ford Freestyle and most Ford dealerships are clueless on thier maintenance and repairs. On most issues that crop up the first thing they want to do is swap it out - for $4000+.

Posted on Mar 08, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Ok one major question! Will changing the tcc solenoid in my 01 cougar fix the o/d flashing and make the car go forward when I try to drive it?


No. replacing the TCC or the OSS, will not make the transmission work. You can unplug these transmissions and they will still work, less OD. Sounds like you may have stripped the torque converter oil pump gear. Common in these older Mercury/Fords.

Mar 18, 2016 | 2001 Mercury Cougar

1 Answer

How difficult to change a fuel pressure sensor on my 2005 Ford Freestyle.


you can go to autozone.com they even have videos that show you how.

Feb 06, 2015 | 2005 Ford Freestyle SEL

1 Answer

How to remove and install a transmission on a 2007 ford freestyle sel


Transmisson repair shop & lots
of money in your check book

May want to start changing your trans & power
steering fluids every 3 years, on all the vehicles you
own from now on.

They fail for a reason,lack of knowledge mostly
Drive till it quits

Jul 15, 2014 | 2007 Ford Freestyle Limited

1 Answer

Can you tell me where vechile speed sencor 'A' is on my focus st the fault code is P0500


P0500 Vehicle Speed Sensor "A"
P0501 Vehicle Speed Sensor "A" Range/Performance
P0502 Vehicle Speed Sensor "A" Circuit Low Input
P0503 Vehicle Speed Sensor "A" Intermittent/Erratic/High
Vehicle Speed Sensor Removal & Installation Automatic Transmission To Remove:
  1. Remove or disconnect the following:
    • Output shaft speed (OSS) sensor electrical connector.
    • Bolt and OSS sensor
To Install:
  1. Apply a light coat of petroleum jelly to the O-ring before installation
  2. Install or connect the following:
    • OSS sensor torque bolt to 89 in-lbs (10 Nm)
    • OSS sensor electrical connector
Manual Transmission To Remove:
  1. Remove or disconnect the following:
    • Vehicle Speed Sensor (VSS) electrical connector.
    • Retaining pin.
    • VSS.
To Install:
  1. Install or connect the following:
    • VSS.
    • Retaining pin.
    • VSS connector.
---
The VSS is on the transmission near the output shaft. It will not be a wheel speed sensor on the hub.

Good luck on this repair, tommy.

Nov 06, 2010 | 2006 Ford Focus

1 Answer

Where is the location of a speed sensor on a 2003 Ford F250 superduty?


It should be sticking out of the top of the transmission at the rear of the unit. There are 2 sensors, 1 at front of unit (TSS) and one at the rear of the unit (OSS). The OSS is your speedometer related sensor.

Assuming 2wd auto

Jan 20, 2010 | 2003 Ford F250 Super Duty Crew Cab

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

97 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

fordexpert

Level 3 Expert

5474 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...