Question about Dodge Neon

Open Question

How to take the starter off a 98 dodge neon? - Neon Dodge Cars & Trucks

Posted by on

Ad

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 18 Answers

SOURCE: flashing light on dashboard 98 dodge neon service engine soon light on

11= Timing belt skipped 1 tooth or more from initial learned value, Intermittent loss of either camshaft or crankshaft position sensor, No crank reference signal detected during engine cranking for dodge odb readout. Hope this helps.

Posted on Dec 08, 2008

Ad
motor1258
  • 6674 Answers

SOURCE: Block heater for 98 dodge neon

Well the block heater itself is usually way under the engine where you can't see it, so I'm thinking you want the plug & cord that makes it work so you can plug it in. My 95 neon had it coiled up laying near the top of the fender under the hood on drivers side, if i remember correctly. It had a black cap over the plug which made it hard to find sometimes, even though I thought I knew where it was. Sometimes it would fall down behind or beside the engine controller.(gray looking computer box) I was always looking for a shiny plug-in type end but it was covered with a hard to see black little cap over it. I used a flashlight, and went along the top of the fenders until I spotted what looked similar to a black extension cord, then followed it to the end, and that's how I found it most times. Try going along drivers side top of fender first, then passenger fender, and then along the front, and maybe even attached in behind grille at front of car sometimes.

Posted on Dec 15, 2008

  • 9 Answers

SOURCE: blue smoke from tail pipe 98 neon no leaks i can see

It sounds like you could need some new piston rings. when they go bad it causes oil to get by into the combustion chamber and burn when the engine fires.

Posted on May 01, 2009

  • 9 Answers

SOURCE: what size socket do I need to change the oil and brakes.

The oil drain plug is a 13 mm. The tools for the brakes, a 10 mm socket for the caliper pins, a flat head screwdriver, or a meduim size prybat to get the calipers out of the mounting bracket, and a 4" C-clamp to compress the pistons into the calipers so you can put the new pads on.

Posted on Oct 25, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Is the starter out of a 96 dodge neon interchangeable with a 97 dodge neon?


96 dodge neon starter interchangeable with a 97 Alana, if same engine, yes it is interchangeable.

Mar 27, 2016 | Dodge Cars & Trucks

1 Answer

Dodge neon 2002 need help


i just had this same problem on my wife's 98. check the alternator to starter hot wire (at starter solenoid) hers was rusted not passing enough current to crank starter. 5 amp for solenoid, 80 amp for starter. jumper wire off battery worked every time. replaced connector and all good. coroded wires = higher resistance = lower amperage passing and possable fire-hazard

Dec 27, 2013 | 2002 Dodge Neon

1 Answer

Put a starter on 98 dodge neon,hook the battery up and starter start running without ignition on,what is the problem?


probably got the little wire on the wrong terminal or the battery terminal on the wrong terminal. One of the terminals on the solenoid will have a wire going down into the starter body. If you have the positive wire from the battery on this terminal you have effectively by passed the solenoid and the starter will spin

Dec 17, 2013 | Cars & Trucks

2 Answers

Mt 98 dodge neon won't start. the starter checked out good. lights come on car won't crank. auto shop said syarter was good.


if it doesn't even turn over check starter cylinoid/relay, if so, check ignition fuses and relays.

May 30, 2010 | 1998 Dodge Neon

1 Answer

My 98 dodge neon will not start., when i turn the key i can here the solenoid click but the car will not start, the battery tested good. and all ther fuses were fine also. do i need to change the starter.


Try finding someone to help ya on this procedure. While another person tries to start it, lightly hit the starter and see if it starts to work. If it does start working, then the starter is defective. If it dont start cranking over then check your battery cables for damage, lose or corrosion. Good luck.

Feb 05, 2010 | 1998 Plymouth Neon

1 Answer

My fuel pump fuse keeps popping and we just changed the fuel pumpand it still pops it what could that be {98 dodge neon)


Check your power wire to the pump. It must have a bare spot somewhere, and is grounding out. Probably on top of the gas tank.

May 27, 2009 | 1998 Dodge Neon

1 Answer

Flashing light on dashboard 98 dodge neon service engine soon light on


11= Timing belt skipped 1 tooth or more from initial learned value, Intermittent loss of either camshaft or crankshaft position sensor, No crank reference signal detected during engine cranking for dodge odb readout. Hope this helps.

Sep 27, 2008 | 1998 Dodge Neon

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

452 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8514 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...