Question about Ford Escort

Open Question

Where is the crank sensor located on a 1994 escort 1.8si

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 18 Answers

SOURCE: 98 escort 2lt.

Does this pertain to the Crank Shaft or the Ignition sensor? I've never heard of a crank sensor... I'll check...

I found this from a guy on another website..."It does however have a crank sensor and if you look at the lower crank pulley just to the back of the pulley and go around the pulley you should find the sensor mounted on a bracket. You should see what appears as a sprocket with widely spaced teeth on the engine side of the pulley. This "sprocket" so to speak is what the crank sensor "reads". I believe that the crank sensor is the only sensor used for engine timing. "

Good Luck

Posted on Oct 26, 2008

  • 56 Answers

SOURCE: 1994 Ford Escort will crank but not start.

it may be the cam sensor or the crank sensor. take an ohm meter to check them to see if they are any good

Posted on May 16, 2009

  • 16 Answers

SOURCE: where are the cam sensor and crank sensors located on my car?

Crank Sensor: Passenger side of transmission just to right and above the differential cover. Has 3 wires:

Light Blue/Dark Blue stripe - Signal
Dark Red - 8v supply
Black/Light Blue stripe - Ground

If the car runs or cranks, you can test this sensor by first checking for power on RED wire with key ON. Should be 8-9.5 volts DC. Furthermore, connect a dwell meter to the signal wire by probing the back of the connector. Dwell reading should be 49-51%. If not, its likely bad.

If you remove the sensor, you MUST replace the paper spacer on the end of the sensor or you risk damaging the sensor or even the torque converter drive plate otherwise. Also make sure O-ring is in good shape and positioned properly.

Cam Sensor:
Facing Engine, it is on the driver side timing case housing, on top of the round part, just to the right of the fuel rail pipe where there is a capped fuel valve.

Has 3 wires:

Tan/Yellow stripe - Signal
Dark Red - 8v supply
Black/Light Blue stripe - Ground

Testing is same as for Crank Sensor.

Posted on May 21, 2009

  • 1 Answer

SOURCE: 1994 ford escort gt won't fire

Overall, the best car I have ever owned, hands down. I am the original owner, and have close to 250K on it. I'm not religious about oil changes every 3000, but I get to them eventually. There's plenty of power in the manual trans 1.9 engine, I can pull steep grades with a full load of passengers & luggage running in 4th gear. I'm on my 5th set of tires, 4th windshield (darn rocks), 3rd water pump (they go after about 120K, easy fix tho), 2nd radiator (replaced at 210K), 5th timing belt. Those are all pretty minor, even expected things. The engine, manual trans, A/C, suspension, body, interior, all have been rock solid.
_______________________
@Jackson
Does anyone know if escortmatcher.com is for real?. Those female escorts looks kinda cheap?. Can I trust them?
<a href="http://www.escortmatcher.com" rel="dofollow">female escorts</a>

Posted on Jun 09, 2010

  • 27 Answers

SOURCE: Where is the crank sensor located on a 2001 ford

The Crank Sensor is on the block, below the Exhaust manifold. You will need a T-20 Torx bit to take loose the bolt that holds it in. The wiring for it goes down the block on the front side and is off the same harness that the coolant sensors are on.

Posted on Jun 01, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Where is the location of the engine data sensor on a 1994 ford escort hatchback lx


Which sensor? There are several 'engine data' sensors. What particular data is it?

Cam position
Crank position
Coolant temerature
Airflow
Air temperature
Knock sensor
Oil pressure
??

Dec 30, 2014 | Ford Cars & Trucks

1 Answer

Where is the engine data sensor located on a 1994 fordescort lx


There are a bunch of sensors on the engine. Which one? If your looking for the engine control module, it is on the passenger side, mounted in the firewall.

Dec 30, 2014 | 1994 Ford Escort

1 Answer

Where is the crank sensor located in a 2000 ford escort zx2


The Crank Sensor is on the block, below the Exhaust manifold. You will need a T-20 Torx bit to take loose the bolt that holds it in. The wiring for it goes down the block on the front side and is off the same harness that the coolant sensors are on.

May 26, 2011 | 2000 Ford Escort

1 Answer

Where is the crank sensor located on a 2001 ford escort zx2 model?


The Crank Sensor is on the block, below the Exhaust manifold. You will need a T-20 Torx bit to take loose the bolt that holds it in. The wiring for it goes down the block on the front side and is off the same harness that the coolant sensors are on.

May 26, 2011 | 2001 Ford Escort ZX2

2 Answers

Location of cam and crank position sensors


The cam sensor is located at the front right front side of the cylinter head, while you are facing the engine.---------- The crank position sensor located below the pcv valve that is located on block not the valve cover, its below the exhaust manifold. You will have to remove the catalytic converter to see the exact view of both the sensors. The camshaft sensor is on the head. The crankshaft sensor is in the block, just below the exhaust manifold. ------------ Thanks.Helpmech.

Nov 12, 2010 | 2001 Ford Escort ZX2

1 Answer

My 94 ford escort just died on the way home it dident make any noise it was like it was out of gas, but that was not the case it still has gas and I cheaked the pump and its still good ?could it be the...


HI, the crank sensor is located in the distributor. It is only serviced as a unit. You may want to check and make sure you have enough fuel volume as well as fuel pressure and these vech. are prone to timing belt failure. Hope this helps.

Aug 25, 2010 | 1994 Ford Escort

2 Answers

No spark no FI pulse NO START


Check the ignition switch please. Had that on a 93 Ford that it was bad and the coil wasnt getting any electricity while the switch was in "start" position.

Aug 17, 2009 | 1994 Ford Escort

2 Answers

1994 Ford Escort will crank but not start.


it may be the cam sensor or the crank sensor. take an ohm meter to check them to see if they are any good

Feb 19, 2009 | 1994 Ford Escort

1 Answer

98 escort 2lt.


Does this pertain to the Crank Shaft or the Ignition sensor? I've never heard of a crank sensor... I'll check...

I found this from a guy on another website..."It does however have a crank sensor and if you look at the lower crank pulley just to the back of the pulley and go around the pulley you should find the sensor mounted on a bracket. You should see what appears as a sprocket with widely spaced teeth on the engine side of the pulley. This "sprocket" so to speak is what the crank sensor "reads". I believe that the crank sensor is the only sensor used for engine timing. "

Good Luck

Oct 26, 2008 | 1998 Ford Escort

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

185 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

fordexpert

Level 3 Expert

5470 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...