Question about 2002 Chrysler Sebring

2 Answers

2003 Chrysler Sebring won't start

The car would not start but all gages and power seemed normal. I put the car in neutral, rolled it back with my foot then returned it to park and the car started. This is what happened about 3 or 4 times over the next few days. Now the car will not start at all. Any info would help thanks.

Posted by on

  • shawn29morri Aug 07, 2008

    It will not start in neutral either. could it be the starter?

  • shawn29morri Aug 10, 2008

    If this is the Neutral safety switch where is it located



2 Answers

Probably the switch that is made when you have it in park. there is a switch that tells the car its in park. try and put the transmission in Neutral and see if it will start. Most cars will allow you to start the engine inpark and neutral. If it starts in neutral all the time then its the switch.

Posted on Aug 07, 2008

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Chrysler Master
  • 5,370 Answers

Car not starting or turning over indicates towards multiple possibilities. It can be issue with battery or weak battery. But if battery checks out ok, then it can be starter issue or faulty alternator or problem with low fuel pressure or no spark at spark plugs due to dirty spark plugs or faulty ignition coil or injectors getting cracked or dirty and needs to be cleaned.

To confirm the problem, the basic troubleshooting is required.

Click this link below and follow the troubleshooting:------


This will help.


Posted on Feb 18, 2012


1 Suggested Answer

  • 2 Answers


Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

How do i check to see if the neutral safety switch is bad. 2004 Chrysler sebring GTC

Most safety switches are a black module located on the side of the transmission, where it shifts into gear.

May 19, 2014 | 2003 Chrysler Sebring

1 Answer

2004 Chrysler sebring. Was stuck in park.. Would not start. How do i check to se if the neutral safety switch is bad

On the console there should be a little door. If you open the door and use a narrow screwdriver in this hole it should allow you to take the car out of park. Be sure that you have your foot on the brake when you do this or the car may move.

May 19, 2014 | 2002 Chrysler Sebring

1 Answer

2002 T&C 3.8L intermitten starting

You would need to check the neutral safety switch for power in park and neutral going to the starter.

Feb 24, 2013 | 2002 Chrysler Town & Country

1 Answer

My 2003 Sebring Convertible is possessed.

the ECM ( engine control module) is responsible for the engine operation
you have several control modules all connected by a canbus unit which allows each one to communicate
could possibly be a bad ground , or harness connection
run the fault codes

Dec 21, 2017 | 2003 Chrysler Sebring

1 Answer

Cant get it out of park

cant shift out of park 2008 sebring conv

Apr 02, 2010 | 2008 Chrysler Sebring

1 Answer

2003 chrysler sebring

Could be starter, or neutral switch in the tranny.

Jan 18, 2009 | 2002 Chrysler Sebring

Not finding what you are looking for?
2002 Chrysler Sebring Logo

2,692 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts


Level 3 Expert

85178 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides