Question about 2001 Chevrolet S-10

1 Answer

En gine shuts off while driving,starts after I switch it off and restart it

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 518 Answers

Check the obvious first. Look for loose,crushed or broken vacuum hoses. Tune up including distributor cap,rotor, wires, fuel & air filters. Check fuel pressure.

Posted on Apr 04, 2011


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Did a 1993 chevy cheyenne have a 4.3l vortec en gine

utube site has it shown as a 1993 chev s10 blazer 4.3 l vortec v6
so I would say that yes is the answer

Feb 08, 2016 | Cars & Trucks

1 Answer

At start up, how long before oil pressure shows on gauge?

within 3 to 5 seconds your gague should tell you oil pressure .if this was helpful please leave good feed back

Feb 18, 2015 | Cars & Trucks

1 Answer

Camshaft bearings in 350 tbi with it the engine

A special tool is required to replace cam bearings and the en gine has to be out of the car.

Aug 15, 2013 | Cars & Trucks

1 Answer

My 1993 bmw 318I water temp gage rises to the middle(like it should) stays there for a while than shoots up to hot. The thermostat has been changed the water pump has been change the gage sensor has been...

if the bottom hose never heats up then theres a flow problem. have u run the car up without the thermostat in ?? just cuz its new doesnt mean it works !! also radiators themselves can block up, back flush ur cooling system and check the radiator holds the water it should, if the bottom half of the rad is blocked, this will cause ur problem, the radiator sounds like its ur problem, make sure u blead the system aswell. the 318 4cylinder has a bleaad valve on the top corner of the rad if i remember correctly.

Jun 20, 2010 | Cars & Trucks

1 Answer

My check en gine light started blinking and my car studers really hard my heat gauch goes krazy some times

I suggest scanning for knowed fault codes there. With this "code number" we can send other details.

Apr 09, 2010 | 1995 Mazda 626

1 Answer

While driving 2ooo silhouette van, the rpm gauge goes erratic and the change engine oil light comes on, followed by battery light, then it feels like transmision slips or en gine stalls and comes back on...

sounds like your alternator is about to go out, not feeding enough currant to the electrical components that need it, i.e. ECM , ESM..and so on.
you may want to have that checked or replaced.
always a good idea to replace the battery when replacing the alternator.

Dec 29, 2009 | 2000 Oldsmobile Silhouette

1 Answer

740i engine makes a clicking renewed tension

You need to replace your hyd chain tensioner, that is your timeing chain tensioner located in the front of the engine.

Dec 22, 2009 | BMW 750 Cars & Trucks

2 Answers

Shuts off while Driving. Will Start easily but

first is making sure fuel preasure is good at time of shut down and at restart when skiping if fuelpreasure remains good then i would say you might have aproblem with the coil packs or the control module, good luck.

Oct 22, 2009 | 1998 Buick LeSabre

1 Answer

1991 gmc sierra c1500 will start then suddenly stop

your fuel injectors may be clogged or your fuel sending unit may be operating for a while then cut off causing the fuel supply to the fuel injectors to not feed anymore fuel to the engine. check those out then write me back. thanks.

Dec 28, 2008 | 1991 GMC C1500

Not finding what you are looking for?
2001 Chevrolet S-10 Logo

Related Topics:

135 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8514 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides