Question about 2005 Infiniti G35

1 Answer

Car is a 6spd manual has a slight rattleing noise that is sporatic allso clutch is almost gone trying to figure out whats causing noise place told me its due to clutch , but i dont believe so car has 68k

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Infiniti Master
  • 4,525 Answers

U need to get a # of opinions--cud also be trans or electronic issue--scan car and buy a repair book at the parts place

Posted on Apr 04, 2011

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Noise when turning left


well it could be the brake pads rattling when turning have the brakes checked. it could also be a bad cv joint gone bad causing the noise only on a turn. if its when turning left then the left cv joint has gone bad. replace the left half shaft. some people say a rattle noise when its a clicking noise.

Aug 07, 2014 | Chevrolet Chevy Cars & Trucks

1 Answer

A rattle in my egine of a 1996 voltswagen jetta trek would could cause it?


This may be a loose heat shield rattling, try to pin point the noise.

Oct 06, 2012 | Cars & Trucks

1 Answer

I have a 2005 camry with 260,000 km. I brought my car into the dealer for a routine maintenance asking them to check out a front end rattling when i go over large bumps. I was told that the control arms...


First,as you travel over a rough road that causes the rattle apply the brakes slightly,is the rattle gone now?If so it's loosely mounted brake pads and/or worn brake caliper mounting bolts/sliders.
Rattle still there with your foot on the brake?Then it's usually the sway bar links and/or sway bar bushings.
To check this sway bar noise,disconnect the sway bar links and tie the bar up/out of the way and try that same road.
No noise now? address sway bar bushings and/or links.
Still noise?Might be struts.
If someone tells you,.you have loose lower control arm bushings,have them show you the play in the bushings before you spend any $$$.

May 06, 2017 | 2005 Toyota Camry Solara

1 Answer

There is a rattling noise in my engine compartment that increases with RPMs. It only goes away completely when I have the clutch fully pressed down and I'm at a complete stop. Therefore I thought it was a...


sounds like a transmission noise... have you checked the trans fluid?
try doing a flush and replace it with a product called Syncromesh FM from the gm dealership. what motor? stock? it did wonders for my 95 civic ex

Aug 04, 2010 | 1995 Honda Civic

1 Answer

Peugeot 206 NEW clutch pressure and clutch plates were replaced including the bearing. Clutch is making a rattling noise but not when pedal is down. Having difficulty getting into 1st and 2nd gears....


its likley to be the clutch center plate cush springs are loos and the center plate is warped so wnen you try to get into gear the clutch is draging the gear box around,,,bipping the clutch stops the clutch spinning so no noise! all you can do is strip the lot down again and fine the fault and fix it

Feb 08, 2010 | 1987 Peugeot Liberte

1 Answer

Engine rattle stopped when clutch failed


Most likely its in the clutch, could have been a spring in the clutch disc come loose or out, or the throut bearing went bad, whatever it was they will find out when they replace the clutch.

May 06, 2009 | Hyundai Motor 1995 Accent

1 Answer

98 540I 6spd Hessitation problems at W.O.T.


i have came across this problem before.timing out by one tooth on timing gears; get it checked out.hope this helps yo.adrian

Feb 18, 2009 | 2003 Audi A4 Cabriolet

1 Answer

Scraping noise when off gas and clutch is out


either the throw out bearing has failed ot the clutch plate hub has failed
possibly from the clutch plate being installed incorrectly and the hub springs are hitting on the flywheel bolts

Jun 15, 2017 | 1999 Mazda MX-5 Miata

1 Answer

1994 Chevy Silverado 350


E-mail me, I'm in calgary i'll walk you through a step by step check so you can figure it out yourself. Easy!

Jun 16, 2008 | 1994 Chevrolet K1500

Not finding what you are looking for?
2005 Infiniti G35 Logo

Related Topics:

68 people viewed this question

Ask a Question

Usually answered in minutes!

Top Infiniti Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14363 Answers

Are you an Infiniti Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...