Question about 1998 Volkswagen Cabrio

1 Answer

What are the ramifications of pulling a 800lb wave runner..with my 98 cabrio

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Master
  • 2,841 Answers

This car is not designed to tow any weight let alone a 800 pound wave runner on a trailer weighing even more. You will be towing over 1/2 ton. Possibly overheating the engine and transmission and you will have a hard time stopping unless the trailer has brakes. Not a good idea.

Posted on Apr 03, 2011

1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

I have a myster oil leak on my 2011 Yamaha wave runner cannot find

if you can find a motor oil leak while in the wave runner
rear engine seal / oil filter seal /rocker covers front cover seals
lift the motor out and replace all the engine seals and gaskets

unseen internals
hardened valve stem seals /burning oil through rings



Apr 22, 2017 | Yamaha Cars & Trucks

1 Answer

1996 Yamaha wave blaster 2 760 starter won't engage into the flywheel

Replace it. The least expensive way to do it is to bring it to a place that rebuilds starters & alternators. Last I checked for my wave runner 3 a rebuild was $60 & a new one was $340. Good luck.

Sep 04, 2015 | Cars & Trucks

1 Answer

Is there a sheer pin on the 2002 wave runner

To prevent the shaft from being damaged when the unit gets fouled it is normal to have a fail safe device either in the impellor or at the crank shaft end. IT may be a shear pin or a rubber bush in the impellor that will tear when there is a problem. Best talk to a wave runner service centre

Jun 22, 2014 | Cars & Trucks

1 Answer

What's the towing capacity for dodge caravan 2000? can't seem to find it on the net...

I've got an 05 model with the 3.3 and given what I know I wouldn't pull anything over 2k lbs a small utility trailer with a riding mower or a small 14-16 ft boat or wave runner would be the extent of it without having a heavy duty transmission, a seperate trans fluid cooler, and an elec braking device

Apr 28, 2011 | 2000 Dodge Caravan

1 Answer


This vehicle is not designed to tow. I would advise against towing anything with this vehicle. By the time you load the jet-ski on a trailer you will have well over 1/2 ton. Your engine and brakes will not handle this load.

Apr 03, 2011 | 1998 Volkswagen Cabrio

1 Answer

My heater doesnt work in my 98 cabrio. I dont have manuel where the fuse is where would it be/

the fuse box is under the knee dash under the steering wheel and above the pedals.

Oct 10, 2010 | 1998 Volkswagen Cabrio

1 Answer


mcdevito75 here, The inside of the door panel has to be removed then linkages removed, you may need special tools, let a shop that does glass, locks change that handle for you.

Jun 17, 2010 | 1998 Volkswagen Cabrio

1 Answer

Winterize a 2004 4-stroke Honda Aquatrax F-12

i put oil in mine and i do not even start it and in a day its low on oil and theres no oil leeks in the compartment.

Jul 07, 2008 | 2004 Honda Civic

1 Answer

Seat Belt will not retract on 98 Pre Runner

When you replaced the belt did you make sure that the position of the belt assembly was the same. A slight misaliengment can affect the return mechanism. Pull the full length of the belt from belt coil Slacken the securing bolt moving the assembly will most likely allow the return of the belt.
If it was an old unit perhaps a drop of WD40 will release the mechanism.
Hope this helps

Jun 09, 2008 | 1998 Toyota Tacoma

Not finding what you are looking for?
1998 Volkswagen Cabrio Logo

119 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volkswagen Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers


Level 3 Expert

75066 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7754 Answers

Are you a Volkswagen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides