Question about Nissan Xterra

Open Question

How to replace the rear bumper for Nissan Xterra . I need diagram

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 2 Answers

SOURCE: remeove rear combination tail light cover 2006 Nissan XTERRA

I just changed out a tailight on my 2000 Nissan Xterra, so I assume it may be similar. You have to pop the plastic strip which runs across the back. There are pop rivits in it.

Posted on Jan 02, 2009

michigan man
  • 3533 Answers

SOURCE: thermostat replacement

try www.autozone.com to see if they have your car listed for diagrams pictures and step by step instructions if your car is not listed then try your local library they have all the car manuals and even copy them for you

Posted on Mar 21, 2009

abauto
  • 353 Answers

SOURCE: need step by step instructions on how to remove a

Rear Bumper: Service and Repair
REAR BUMPER
Removal and Installation
REMOVAL
1. Remove the LH and RH rear combination lamps.
2. Remove both the rear wheels and tires.
3. Remove the LH and RH splash shields.
4. Remove the rear bumper fascia clips and screws, then remove the rear bumper fascia.
5. Remove the rear energy absorbing foam.
6. Remove the rear bumper reinforcement.
7. Remove the rear bumper supports.
INSTALLATION
Installation is in the reverse order of removal.

c674cde.jpg

Posted on Nov 12, 2009

ZJLimited
  • 17970 Answers

SOURCE: Diagram available for 01 Nissan Xterra Knock Sensor location?

V6 3.3L The sensor is located underneath the air intake manifold on top of the engine block. This should take an experienced mechanic about 3-4 hours to replace.

9bd8ec7.jpg

Fig. Engine compartment component locations

Hope this help (remember rated this free help) Good luck.

Posted on Feb 08, 2010

SOURCE: HOW TO REPLACE A FUEL PUMP FOR A NISSAN XTERRA


Removal & Installation

  1. Before servicing the vehicle, refer to the precautions in the beginning of this section.
  2. Relieve the fuel system pressure.
  3. Drain the fuel tank.
  4. Remove or disconnect the following:

    Negative battery cable Fuel pump module harness connectors Filler hose shield Fuel pressure and return lines Filler hose Vent hose Evaporative Emissions (EVAP) hose Fuel tank skid plate Fuel tank Fuel level sender Fuel pump

To install:
  1. Install or connect the following:

    Fuel pump Fuel level sender. Tighten the screws to 17-23 inch lbs. (2.0-2.5 Nm). Fuel tank. Tighten the bolts to 27-36 ft. lbs. (37-49 Nm). Fuel tank skid plate. Tighten the bolts to 27-36 ft. lbs. (37-49 Nm). EVAP hose Vent hose Filler hose Fuel pressure and return lines Filler hose shield Fuel pump module harness connectors Negative battery cable
  2. Fill the fuel tank.
  3. Start the engine and check for leaks.

Posted on Mar 31, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Xterra brakes


left front
right front
left rear
right rear

Apr 03, 2014 | 2001 Nissan Xterra

3 Answers

Diagram available for 01 Nissan Xterra Knock Sensor location?


V6 3.3L The sensor is located underneath the air intake manifold on top of the engine block. This should take an experienced mechanic about 3-4 hours to replace.

9bd8ec7.jpg

Fig. Engine compartment component locations

Hope this help (remember rated this free help) Good luck.

Feb 08, 2010 | 2001 Nissan Xterra

1 Answer

How to change the rear tire on a 2007 nissen


if you look by the rear hatch lock at the bumper,there is a cutout for the tool for the winch lever to fit into.the 2005 to 2009 are all the same.

Nov 05, 2009 | 2007 Nissan Xterra Off Road

2 Answers

Front bumper on my 2001 xterra is rusting. I want to remove it , sand it and repaint. How do I remove the front bumper?


Grab a factory service manual it will make it much easier, plus you may need to remove other parts as well. Here is link to a factory service manual for your 2001 Nissan Xterra.

Oct 09, 2009 | 2001 Nissan Xterra

1 Answer

Instal diagram for nissan xterra grill gaurd


they jusy bolt to bomper brackets and where bumper bolts to bracket hey vote for me ok

May 26, 2009 | 2008 Nissan Xterra

1 Answer

Loose drivers side fog lamp on 2003 Xterra


if you look up from under the front bumper there should be some screws surrounding the lamp that's the adjustment

Apr 26, 2009 | 2003 Nissan Xterra

2 Answers

Remeove rear combination tail light cover 2006 Nissan XTERRA


I just changed out a tailight on my 2000 Nissan Xterra, so I assume it may be similar. You have to pop the plastic strip which runs across the back. There are pop rivits in it.

Jan 01, 2009 | 2006 Nissan Xterra

1 Answer

Stock radio wiring diagram


Nissan Xterra Car Audio Wiring Diagram Car Radio Battery Constant 12v+ Wire: Pink
Car Radio Accessory Switched 12v+ Wire: Blue
Car Radio Ground Wire: Gray
Car Radio Illumination Wire: Red/Blue
Car Stereo Dimmer Wire: Red/Yellow
Car Stereo Antenna Trigger Wire: N/A
Car Stereo Amp Trigger Wire: N/A
Car Stereo Amplifier Location: N/A
Car Audio Front Speakers Size: 6 1/2′
Car Audio Front Speakers Location: Doors
Left Front Speaker Positive Wire (+): Pink
Left Front Speaker Negative Wire (-): Blue
Right Front Speaker Positive Wire (+): White
Right Front Speaker Negative Wire (-): Black
Car Audio Rear Speakers Size: 6′ x 9′
Car Audio Rear Speakers Location: Side Panels
Left Rear Speaker Positive Wire (+): Light Green
Left Rear Speaker Negative Wire (-): Purple
Right Rear Speaker Positive Wire (+): Blue
Right Rear Speaker Negative Wire (-): Pink

Hope this helps!
-->

Oct 11, 2008 | 2004 Nissan XTerra

1 Answer

Continuous Blown Fuse


You have a short. With these Xterras it is most likely from one of the front side markers rubbing the bumper support. Is the front bumper pushed in or damaged in anyway if so check the wiring to these lamps. Hope this helps.

Aug 13, 2008 | 2004 Nissan XTerra

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

105 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...