Question about 1993 Chevrolet S-10 Blazer

1 Answer

A.C. continues to get cold until it freezes up.

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Low on freon or evaporator dirty not allowing air flow

Posted on Aug 08, 2008

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

The freezer doesn't freeze that good but the refridgerator does work.


It is possible that the defrost cycle is not working. Look for signs of ice built up in the freezer compartment. The excess ice prohibits the air circulation.


26128165-5xkmzur1kbcrfneaoxy43scu-3-0.jpg If defrost cycle appears working and compressor runs continuously it is probable that the Freon is low or compressor is failing.

the usual tell is the refrigerator gets colder than usual and the freezer does not get as cold. The situation is that the compressor runs until the freezer temperature is satisfied. If the compressor can not achieve the cold temperature of the freezer it will run continuously.

When the unit runs continuously the bi-pass of air is increased bringing more cold air into the refrigerator portion of the unit.

Mar 13, 2016 | Cars & Trucks

1 Answer

Hot water in kitchen only froze


good idea to let the cold water to run a bit to stop freezing up . Pity that you didn't do the same with the hot water. There is only hot water in the tank but the water in the hot water pipes will freeze as the heat goes out of the pipes. (Always to have to wait for the hot water to come through when you use the shower or bath.) The water will freeze up right back to the hot water tank

Jan 29, 2014 | Cars & Trucks

1 Answer

Have a 2000 V 70 and the a/c doesn't get cold. I put in a can of freon and it helped a little bit until the weather got hot again. Bought another can of freon, but it wouldn't go in. A red light...


Without gauges you can refill the unit by running the engine at about 3000 rpm. Turn AC on full speed. Then open the freon can a tad to get rid of any air in the line and connect it to the suction port. Open can full blast, shake it while upright and continue filling until the intake line going to compressor starts getting cold and sweats. Then stop. Air coming out of vents should be around 41 degrees.
Cabin filter if clogged will only impede air flow - not how cold it is. Actually, id the flow is impeded the air coming out will be colder since less is passing over the evaporator. But that could under certain conditions lead to the evaporator freezing up (then use outside air option instead of recirculated) to deal with situation. There- you are now an EXPERT!

Aug 25, 2017 | 2000 Volvo V70

2 Answers

I just changed the radiator. How much antifreeze do I put in?


put a 50/50 mix. remove radiator cap when cold,start car let run 1 min and dump 50/50 mix till full, a little will come out cap when thermostat opens this is normal,when thermostat opens coolant will go down,continue to fill till full,put cap on and fill reservoir to cold mark,check reservoir after you run a day and fill if needed to the full cold mark again

Jan 21, 2011 | Chevrolet Monte Carlo Cars & Trucks

1 Answer

My 07 Nissian Frontier Heater is intermittent--works fine while drivng but when stopped starts blowing cold air--suggestions? I did have my coolant change right before the summer, I saw some comments...


probably a bubble of air in the system that hangs at the heater hose until pressure from water pump increases. Park on an incline to help the bubble migrate to the radiator. Open radiator cap, start engine and let it warm up until thermostat opens. after water is flowing in, fill radiator all the way to the neck. watch to see if bubbles continue to come up after the level stops going down, as this would indicate a blown head gasket. If bubbles stop, close cap and you should be good.

Dec 09, 2010 | 2007 Nissan Frontier SE Crew Cab

1 Answer

How much anti freeze do i put in my punto if i empty out the radiator


You will fill the radiator with a cold engine. You will then start the car with the radiator cap off, as the engine warms, the thermostat will open and allow coolant to circulate, you can then finish filling and replace the cap. Then fill the overflow resevoir to the proper level for warm engine. Allow the engine to continue running and keep an eye on the resevoir level. It will likely go down some and you can continue putting the fluid into the resevoir until it bleeds all air out of the cooling system. Good luck! I hope you find this to be very helpful!

Dec 26, 2009 | 2007 Hyundai Tucson Limited

1 Answer

84 f150 started location


Its on the right rear bottom corner of the engine. No they can not freeze.

Nov 13, 2008 | 1984 Ford F 150

Not finding what you are looking for?
1993 Chevrolet S-10 Blazer Logo

Related Topics:

42 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

77202 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...