Question about Chrysler Sebring

1 Answer

I have water boilking from the coolant reserve. I have a 1999 Chrysler sebring

Posted by on

1 Answer

Thermostat Stuck or Bad Head Gasket

Posted on Apr 03, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do you remove the radiator on a 2007 chrysler sebring limited 3.5


REMOVAL

  1. Disconnect negative cable from battery.
  2. Remove radiator upper crossmember support. WARNING: DO NOT REMOVE THE CYLINDER BLOCK PLUG OR THE RADIATOR DRAINCOCK WITH THE SYSTEM HOT AND UNDER PRESSURE BECAUSE SERIOUS BURNS FROM COOLANT CAN OCCUR.
  3. Drain the cooling system.
  4. Remove the radiator fans.
  5. Disconnect coolant reserve/recovery hose.
  6. Remove vapor purge solenoid from mounting bracket.
  7. Disconnect upper and lower hoses from the radiator.
  8. Remove the A/C condenser side brackets to radiator attaching screws. Separate the condenser from the radiator by lifting upward to disengage from lower mounts. Allow the condenser to rest in front of radiator.
  9. Radiator can now be lifted free from engine compartment. Care should be taken not to damage radiator cooling fins or water tubes during removal.
  10. INSTALLATION

    1. Be sure the air seal is in position before radiator is installed. Slide radiator down into position. Seat the radiator with the rubber isolators into the mounting holes provided, with a 10 lbs. force.
    2. Position air conditioning condenser onto the radiator lower mounts and install upper screws. Tighten fasteners to 5 Nm (45 in. lbs.).
    3. Install the radiator upper and lower hoses.
    4. Connect the coolant reserve/recovery hose.
    5. Connect the vapor purge solenoid to the mounting bracket.
    6. Install the radiator fans.
    7. Install the radiator upper crossmember support.
    8. Fill the cooling system.
    9. Connect negative cable to battery.

Nov 10, 2016 | 2007 Chrysler Sebring

2 Answers

Water shoots out of the radiator when car is running. Unable to add water/coolant because of this. What is causing this to happen?


Wiil if water just shot out by just running thenyou have a bad radiator
If the water shot out asyou ran the car some thenyou my have a bad water pump and the timing i think not if it was you motor mynot run right...

Oct 19, 2012 | 1999 Chrysler Sebring

2 Answers

I have boiling water in the reserve i have blown a radiator fixed that checked for a thermostat which isnt in the car and the water pump is working any ideas?


ok you have a lack of circulation. this happens when you get a pocket of air locking in the coolant system, you will need to get it out in order to fix the problem, or you have a blockage, best thing to do is take it to a shop, tell them you want the coolant system flushed, this is what they should do, put a flush on the system this will tell them and you if there is a blockage, then if there is not, they will use an Air lift type system to vaccuum the coolant system down thus eliminating the air lock. problem solved with minimal cost. I would walk you though how to do this at home but its not cost effective sine the tools you need ot do it are quite costly.

Sep 22, 2011 | 1999 Chrysler Sebring

2 Answers

Changed thermostat. temp guage rising to "H" after about a week. little steam coming from radiator cap. reserve FULL and not going down. added coolant/water to radiator. temp gauge OK. could...


Hi,
If you are not seeing any leaks, most likely air in the coolant system, improper/weak coolant mixture, bad radiator cap, bad thermostat. Sounds more like the air and/or weak coolant to me.
Mike

Jun 20, 2011 | 1999 Chrysler Sebring

1 Answer

How often do i replace the timing chain 1999 chrysler sebring lxi


The belt is supposed to last for 105,000 miles. These sebring cars are notorious for breaking timing belts well before then. If your car has over 80,000 on it I would schedule a timing belt change in the near future. Don't be surprized if you have to also change the water pump.

Kelly

Feb 27, 2010 | 1999 Chrysler Sebring

1 Answer

How do i change the water pump on a 1999 2.5 v6 chrysler sebring?


Hello,

Removal:
Drain cooling system, remove the timing belt if necessary. Remove water pump mounting bolts. Separate water pump from water inlet pipe and remove.

Inspection:
Replace water pump if it has damage or cracks to pump body. Check the shaft seal for any leaks as evidence by traces of coolant from vent hole. Check for any impeller rubbing inside pump, and for loose or rough bearings.

Installation:
Clean all gasket and "O" ring surfaces. Install NEW "O" ring on water pipe (wet "O" ring with water to aid assembly). DO NOT allow oil or grease to contact "O" ring. Install NEW gasket on water pump, and install pump inlet opening over water pipe. Install pump-to-block bolts and tighten to specification 18 FT. Lbs. (25n.m). To complete installation, reverse removal procedure.

Hope this helps :)

Oct 19, 2009 | 1998 Chrysler Sebring

1 Answer

2001 chrysler sebring lxi is leaking coolant and seems to have a emissions problem


The coolant leak is probably from the water pump. The seal behind the bearing is worn out. You need a new water pump.

May 31, 2009 | 2001 Chrysler Sebring

1 Answer

I have a 99 Chrysler Sebring, my radiator blew last week, we have replace it and the radiator fan will only run for a minute or so and then shut off. It does that whether the A/C is on or off. Any...


it could be the water pump or the thermostat if the sensor for the fan is located on the radiator the fan probably turns off because the radiator is cool meaning the coolant is not circulating

Mar 02, 2009 | 1999 Chrysler Sebring

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

73 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7782 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...