Question about Oldsmobile Silhouette

1 Answer

How much would it cost to replace a weel berring for a 1995 Oldsmoblie silhouette mini van

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Oldsmobile Master
  • 3,640 Answers

All i can say is call an auto parts store and see what a wheel bearing will cost. I just had one put on my 2000 malibu and it cost about 314.00, thats at a low labor rate 52.00 per hour. I called up advanced auto, and they told me a bearing and hub where 80.00, cheaper if you do it yourself ! I at least you will not have to pay the labor. would imagine if a dealer does it it will be about 4 something. so call around town. im in nys.

Posted on Apr 02, 2011

1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

2002 oldsmobile silhouette van,can lower passenger window but cannot raise it, works both ways from passenger controle

You most likely have a bad switch on the drivers side. Pretty easy replacement and fix. Not bad cost wise either.

Apr 07, 2016 | 2002 Oldsmobile Silhouette

1 Answer

How hard is it to re place the windshield washer tank on a 99 Olds mobile silouhett

Oldsmobile Silhouette Windshield Washer Reservoir ' Used ... > All Makes > Oldsmobile > Silhouette
Find a quality Oldsmobile Silhouette Windshield Washer Reservoir and other used Mini Van parts ... For example: If you're looking for a Hood Latch, ... This part is also known as Oldsmobile Silhouette Wdsh Washer Reserv; ... 1999 MONTANA

How To Install Replace Windshield Washer Pump Many GM ...

? 2:34
Jun 7, 2010 - Uploaded by 1A Auto Parts
How To Install Replace Windshield Washer Pump Many GM Vehicles ... can u tell Me were the Fuse located ...

Oct 29, 2015 | Cars & Trucks

1 Answer

What tools would be needed to replace a throttle position sensor on a 1995 Oldsmobile Silhouette 3.8 V6 van?

The two screws and the electrical connector are all that need to come off the TPS to remove it. I dont know of any other componants that you need to remove to get to it. The screws are either a 7mm socket or a T15 or T-20 Torx bit. It is normally on the backside of the throttle body, so on the van you'll have to "crawl-in" to reach it.

The TPS only goes on one way, just line up the "D" shaped slot on the sensor with the throttle shaft. Don't over tighten the screws, snug is good. You don't want to break them.

Aug 27, 2011 | 1995 Oldsmobile Silhouette

2 Answers

My fans on my 2002 oldsmoblie silhouette van will not come on, my van is overheating. Thermostat is fine, water pump is fine, fuses are good.

Is there power reaching the fans? If yes, the fan motors are no good. If no, it could be a faulty fan relay. Try turning on the AC...If the fan now works, you have an issue in the electrics.

Aug 21, 2011 | 2000 Oldsmobile Silhouette

2 Answers

No start

I have the same issue with my 2002 Silhouette mini van! As soon as the weather got warmer, issues starting- did you get any answers???

Nov 28, 2009 | 2002 Oldsmobile Silhouette

1 Answer

Need to put a camshaft position sensor on a 98 oldsmoblie silhouette, where is it on the motor?

Remove your Distributor Cap and Rotor button, and the black domed looking thing under the rotor button is your Camshaft sensor. It should have three to four wires sticking out of the distributor connected to the wiring harness fairly close to the distributor.

"00 Buck"

Nov 06, 2009 | 1998 Oldsmobile Silhouette

1 Answer

1995 Oldsmobile Silhouette 3.8 liter engine

Have a fuel pressure test done to determine if proper pressure is there. At very least change fuel filter.

Jul 11, 2009 | 1995 Oldsmobile Silhouette

3 Answers

My 1995 Oldsmobile Silhouette van shuts off while driving

I had a the same problem with my 95' Silhouette it got worse and then would not restart until it cooled off. the problem is most likely the crankshaft position sensor this is what resolved my issue.

Mar 28, 2009 | 1995 Oldsmobile Silhouette

1 Answer

'95 silhouette mini van

Its was my neighbor wanting the info and she decided to send it to the scrape yard for $200.
Thank you for replying

Jan 16, 2009 | 1995 Oldsmobile Silhouette

1 Answer

Mini van repair issues

if the prices are close to us could be like arrond 200

May 27, 2008 | 1995 Ford Windstar

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

129 people viewed this question

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts


Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8215 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides