Question about 1992 Jeep Wrangler

1 Answer

Jeep wont start. Battery good, alternator good. replaced starter 2 years ago...

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 2,926 Answers

Wont start or won't crank?

Posted on Apr 05, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

New battery new alternator wont start ?


I'd check for bad or corroded contacts/cables from battery to starter (If your vehicle is older than 14 years). If that looks good I'd be suspicious of the solenoid in your starter sticking(will probable need a new starter).

Sep 04, 2014 | Cars & Trucks

1 Answer

Jeep just clicks when trying to start


Sounds like your starter is not working,here's a link on how to remove,take to Autozone and they will test for free,takes only a few minutes.To check for power at starter,get meter and it should read 12 volts.

Mar 22, 2013 | 2002 Jeep Liberty

1 Answer

88 rx-7 convertible doesn't click or start, new battery and alternator installed 2 months ago ... does the starter/ solenoid need replaced?


try tapping on the starter housing while somebody is in the car. have them try to start the car while tapping on it if it starts replace the starter. who may have a dead spot in the whindings. good luck steve

Jan 03, 2012 | Mazda H240 Cars & Trucks

2 Answers

2005 jeep gc wont start. replaced fuel pump,replaced battery, run for two weekes, wont start but it click clicks


will it start with a jump? check battery for full charge, maybe alternator is not charging, check battery connections all the way down to starter, check selonoid by cross jumping terminals to engage starter.

Mar 09, 2011 | 2005 Jeep Grand Cherokee

1 Answer

My dodge aries wont start every time. I turn the key several times and it makes a clicking sound before it tries to turn over and ever when the engine catches it wont start completely. I changed the...


The clicking is the starter solenoid which is normal, the starter motor is not making a good contact due to it's worn, a starter replacement will fix the problem.

Jun 30, 2010 | 1987 Dodge Aries

1 Answer

Wont turn over


The starter is most likely the problem,tap on the starter lightly with a hammer while trying to start the engine,dont get run over doing this it will take two people,if the engine starts,the starter needs replacing.

Apr 25, 2010 | 1998 Jeep Wrangler

2 Answers

My 1994 Jeep Cherokee Country - 6 cyl 4WD is clicking and not turning over. My battery is a few years old and I replaced the starter 2 years ago. I have been told that it may be the solenoid.....any...


First, do not assume anything. Check the battery with a volt meter and make sure there is 12.v or better there. Clean cable terminals where they contact the battery, check both ends of cables for good clean solid connection. Since you hear a click, that is good ...ignition switch etc is likely good. Check the voltage at the starter : large cable should have 12v, small wire should have 12v when key is turned to "start" position. If you have both, starter has failed. Some Jeeps have an additional starter relay inside the power distribution center near the battery. if you have voltage at the starter, the relay is good. If when you test battery, voltage is low, have it charged and load tested. If battery fails test, no other tests are valid.
Once started, check for running voltage of at least 12.9v with all accessories and lights on. At no time should voltage drop below 12.5, or should it continue to creep down. If it does, the alternator may be faulty.(providing belt is good and tight)

Jun 15, 2009 | 1994 Jeep Cherokee Country

1 Answer

1996 Jeep Grand Cherokee Limited Alternator issues?


have the alternator regulator and diodes tested. sometimes when the regulators fail they allow ac voltage to go to the battery. ac voltage doesn't charge the battery properly (causes it to deep cycle and shortens its life) and causes all sorts of funny problems with the car. also make sure the battery is secured properly, vibration isn't good for them at all.

Aug 11, 2008 | 1994 Jeep Grand Cherokee

Not finding what you are looking for?
1992 Jeep Wrangler Logo

Related Topics:

162 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...