Question about 2000 Chrysler Cirrus

1 Answer

My brake pedal goes all the way to the floor. the pads and rotors look fine, the fluid is full and i can't find a leak in the line. the light does not come on...

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 594 Answers

Is pedal conected under dash to actuator rod
does light come on when key is first turned on
is there any burnt fuse
fluide could be leakig back into vavumed brake booster (on firewall)
take cap of put rag over and depresss pedal sevral times check levels
pulling back up on pedal to get full pedal motion some leaks are harder to find has
they sray out if your alone put carbord under vehicle and press pedal until there is
luide on carboard then trace that area
works for me on hard to find leaks

Posted on Apr 02, 2011


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

4 Answers

Brake pedal goes to floor vehicle still stops

Is the brake light on? Check your fluid level. Pedal going to the floor could be because of a leak in the hydrolic system line, hoses, caliper, wheel cylinders, master cylinder internal and external leaks. Can also be because of over sized drums and/or under adjusted brake shoes.

Jun 13, 2014 | 2000 Chevrolet Blazer

1 Answer

Leaking brake fluid from right front wheel 1995 honda passport

Sounds like from what you describe it's a leaking break caliper. The best thing to do is get a rebuilt one. It's best to replace them in pairs. Also replace or clean the brake pads thoroughly!

Dec 20, 2012 | 1995 Honda Passport

1 Answer

Just asked how ti fix my issues with the brake problems I am having

When you say leaking off, I assume the pedal is soft or goes to the floor when depressed. Since all of the major brake system components have been changed, the brake lines are the next suspect. DO you notice any loss of brake fluid from the reservoir? Do you see any fluid leak on the ground or at the wheels?

Sep 27, 2012 | 2003 GMC Envoy

1 Answer

Brake petal goes all the way to the floor no leaks antwhere front passenger pad stuck closed on rotor front passenger rotor pad bolts very hot after driving

the bolts are getting really hot because the friction of the pads running on the rotor the whole time whilst driving.
the pedal problem could be a few things but the most likely is either that the brake fluid needs replacing because it's got water in it,
there's air in the lines or the brakes master cylinder seals need replacing due to age.

Apr 14, 2011 | 2000 Dodge Caravan

2 Answers

Brake pedel goes to floor & no brakes. I changed rotors & pads 4 mos ago. Has fluid in resevior. Can`t get to pump up.

check the master cylinder. it can go bad without leaking. the fluid bypasses the internal cups causing a fall in the pedal. also if you broke the lines lose to do calipers you might have air in the system bleed it good. if not i suspect the master cylinder

Jan 19, 2011 | 1996 Ford Explorer

3 Answers

While driving my 1994 Honda Accord the brakes went out. I can only get the car to stop if I press the brake pedal all the way down to the floor. When the car is shut off and I pump the brake pedal, I can...

There may be air in the lines. Bleed all your brakes starting at the farthest wheel from the resevoir, and finishing at the closest one. Try the pedal after its bled. If the pedal still feels soft or travels to the floor there may be a pinhole leak that may be spraying on the underbody of the car, or the seals in the master cylinder are gone filling the vacuum booster(if equipped). Air compresses more than oil so if bleeding works that may be the problem.

Feb 21, 2010 | 1994 Honda Accord

3 Answers

I have a slow brake fluid loss. I think it may from the master cylinder. Are there any seals in the lines that go into the master cylinder unit.

no they are inverted flare fittings no seals check all lines and calipers/wheel cylinders if all are dry remove the vacuum hose from the booster if there is brake fluid in the hose the master cylinder is bad

Sep 24, 2009 | 2002 Hyundai Santa Fe

2 Answers

Brake pedal goes to the floor after you make your initial stop at a red light.while you;re holding the brake

there is either a leak in one of the lines or you have air in the brake lines. start by bleeding your brakes lines and checking you fluid. then see if you notice a leak in which case fix it then bleed that line and you should be good. if not then it could be a bad master cylinder that would be the next step. also if you had your rotors cut down below spec then the pedal could go to the floor and not have much stopping power. same could go for very bad pads. but from what you explained it sounds like a leak

Mar 28, 2009 | 2000 Dodge Neon

2 Answers

Brakes bad even after replacing pads/rotors

You need to replace the master cylinder. If all else is good and the petal goes to the floor, that's really about all it could be.

Nov 09, 2008 | 1989 Volvo 240

Not finding what you are looking for?
2000 Chrysler Cirrus Logo

264 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts


Level 3 Expert

80637 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers


Level 3 Expert

814 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides