Question about Honda Accord

1 Answer

I need to no where does my transmissom fluid go inthe car. i do not see a stick for a 1993honda accord

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 829 Answers

Will be a very short stick or threaded knob close to the bottom on the very front of transmission.very difficult to see.

Posted on Apr 02, 2011


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

1993honda accord wont start when its cold outside

Possible causes: ice in gas filter clogging gas flow, preheater for carburator or fuel mix not working

Jan 21, 2013 | Cars & Trucks

1 Answer

1993honda accordhow dow you removal thebottom boit on the starter

Will need to know if your car is a 4 cylinder or a V6. Please reply and I will help you. Thanks.

Jan 15, 2013 | 1994 Honda Accord

1 Answer

1993honda runs on start, but dies in the on position

it sounds like a bad ignition switch easy way to check is follow the relay back with a test light and see if your not getting power in the on position thats your concern (ingnition switch) hope i could be of some help...

May 24, 2011 | 1993 Honda Accord

1 Answer

DO I have to drop the motor and transmissom together or can i drop the bellhouse and transmissom by its self out of a 2000 mustang Gt.

Being rear wheel dirive, it is possible to remove the transmission and bellhousing by themselves........

Oct 10, 2010 | 2000 Ford Mustang

1 Answer

Could you tell me where to put the transmission fluid in a 1988 honda accord dx. I can't seem too find it.

If there is a dip stick to show you the level of the fluid in the transmission, the transmission fluid is added through the dip stick tube. With the dip stick out, place a funnel in the tube opening and pour the fluid into the funnel.

Apr 29, 2010 | 1988 Honda Accord 4 Door

1 Answer

Where do you put the gear fluid in the 96 accord?


If you mean transmission fluid? It goes in the same place where your dip stick goes into. You need a small end, long funnel.

Take Transmission Dip Stick out, insert funnel and add manufactured recommended fluid as nedded. DO NOT OVERFILL

If helpful, click below. Good Luck

Apr 05, 2010 | 1996 Honda Accord

1 Answer

My 1996 grand cherokee transmissom is real slow

My jeep does the same thing but from 1st to 2nd i was told the solenoid valve in my valve body sticks until the fluid is warmed up and opens up.Cheapest thing to do is let your jeep warm up for a little bit to let the fluid cycle.

Feb 06, 2010 | 1996 Jeep Grand Cherokee

3 Answers

Where do i put transmission fluid

there is the dip stick tube. you have to use a funnel for this the trnas dip stick should be marked red. please rate this solution

Aug 29, 2008 | 1995 Honda Accord

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

45 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts


Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides