Question about 1995 Pontiac Grand Prix

Open Question

How to replace a water pump on a 1995 pontiac grand prix se with a 3.1 litre engine

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

CMV9
  • 594 Answers

SOURCE: replace water pump 93 grand prix

here is a step by step instruction on how to replace your water pump. please do not forget to rate and comment about your experience today with fixya.

  1. Disconnect the negative battery cable.
  2. Remove the air cleaner assembly.
  3. If necessary for access, remove the coolant recovery reservoir.
  4. Partially drain the coolant, into a suitable container, to a level below the water pump.
  5. If equipped, remove the serpentine belt guard/cover.
  6. Remove the serpentine belt.
  7. Remove the retaining bolts, then remove the water pump pulley.
  8. Unfasten the 5 water pump attaching bolts, then remove the water pump and gasket. Discard the gasket.
To install:
  1. Thoroughly clean the water pump mounting surfaces.
  2. Position a new gasket, then install the water pump.
  3. Install the attaching bolts and tighten them to 89 inch lbs. (10 Nm).
  4. Install the water pump pulley.
  5. Install the serpentine belt and belt cover/guard (if equipped).
  6. Refill the cooling system with the specified type and amount amount of engine coolant.
  7. Install the air cleaner assembly.
  8. Connect the negative battery cable, then start the engine and check for coolant leaks.

Posted on Apr 17, 2009

  • 83 Answers

SOURCE: 2000 pontiac grand prix se ecm location

located in air box beather box for intake.

Posted on Jan 13, 2009

emissionwiz
  • 75117 Answers

SOURCE: 1995 pontiac grand prix se neutral safley switch

this is part of the gear position switch on top of the trans where the shift linkage connects, it is mounted over the selector post that sticks out of the trans. Here is a picture.
300? 300: true ); MAX-HEIGHT: 400px; ; HEIGHT: expression(this.height > 400? 400: true )" src="http://info.rockauto.com/getimage/getimage.php?imagekey=96388&imageurl=http%3A//info.rockauto.com/ACDelco/12450003.jpg" />

Posted on Feb 13, 2009

  • 22 Answers

SOURCE: 1995 Pontiac Grand Prix SE 6v 3.1L running red line hot!

maybe a water pump.

Posted on May 29, 2010

sref
  • 82 Answers

SOURCE: how to change fuel pump

Inside The Fuel Tank. If Yours Tests Bad, You Will Need To Drop The Tank And Replace It. Be Sure To Have Someone Test To Make Sure Yours Is Bad, This Is A Difficult Job And Expensive.

Posted on Feb 21, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

No coolant flow


Water pump ? Thermostat ?

Aug 01, 2013 | Pontiac Grand Prix Cars & Trucks

1 Answer

Where is the water pump located on a 1995 pontic grand prix


the pump is located on front of the motor.if you stand facing the motor looking towards the pulleys(from passenger side to drivers side)in the center of the motor it has the pulley that is in the middle of the engine this is were the water pump is.

Mar 30, 2011 | 1995 Pontiac Grand Prix

1 Answer

I have a 1995 Pontiac Grand Prix SE 3.1L V6 and I have no heat, and the defrost barely works. My coolant is leaking and when the car is on, it flies off the front of the belt and drips to the ground. Is my...


more than likely one of your heater hoses has sprung a leak ... if your car is not over heating with water in it than your water pump is fine.... the gasket around it may need to be replaced tho ... start your car then you look for your leak please get back to me

Feb 05, 2011 | 1995 Pontiac Grand Prix

2 Answers

What kind of code scanner do i need for 1995 pontiac grand prix se 3.1 litre


Probably it is OBD1. I think OBD2 cam in 1996. Check the internet, you might get the check engine light flashing the code with the right on/off/on switch combination.

Mar 30, 2010 | 1995 Pontiac Grand Prix

1 Answer

3.1 litre engine swap


2000-2004 impala easyest

Feb 22, 2010 | 2002 Pontiac Grand Prix

1 Answer

Heat fluctuation on temp gauge


change the sending unit to the fan, if that doesnt work check for power too the fan or even a bad fan

Mar 22, 2009 | 1995 Pontiac Grand Prix

1 Answer

How to replace fuel pump on 95 pontiac grandprix se


you got drop the gas tank remove retainer ring on the top of the tank n pull the pump out i hate doing this kind of job good luck

Jun 16, 2008 | 1995 Pontiac Grand Prix

Not finding what you are looking for?
1995 Pontiac Grand Prix Logo

387 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7768 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...