Question about 2008 Dodge Avenger

1 Answer

Drivers side window is closed and will not move. the other windows work fine. when pressing the power switch there is a low noise as if it is trying to work ?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 3,074 Answers

Regulator is bad, cost anywhere from $80 to over $100. I would check eBay. The dealer is to expensive. Hope this helps Tim

Posted on Apr 01, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Drivers side window (power) quit working. all other windows work fine. what am I looking at. fude? regulator? motor? Is the regualtor and motor together in in this model? 2004 Ford Taurus SEL


Try this....
Open the door, turn the key to the ON position without starting the engine and everything that makes noise is off. Lean down placing your ears close to the bottom center of the door or at the speaker grill. Press the window switch UP and DOWN. Listen for the window motor. If heard the drive is damaged. If not heard, turn key off and locate and replace the relay with one of the other window relays. Check window again. If it works now, get a new relay. Sometimes, removing the motor and turning it by hand will get it working good as new. I have had to do that with Brand New motors! So try it.
If all has failed, with the door panel still off, check for voltage at the motor connector when pushing the window switch. No voltage means its the switch, especially if its a auto down or up switch.

Window fuse's and relay's may be up under drivers side dash or next to battery.
Drivers door window gets used the most so it could be the motor, window switch, relay or fuse.
Could also be a broken wire in the rubber boot going from the door to the body. You will have to eliminate each till you find the culprit.

Aug 13, 2011 | 2004 Ford Taurus

Tip

Power windows are not working


Power windows pretty much come standard on all new vehicles, and they are usually pretty durable, but sometimes they will fail. The window will go down but not back up, or all you hear is a clicking or grinding noise noise when you press the control switch. Or when you press the Power window switch, you get nothing. These are two separate problems, and knowing the difference is the first step in diagnosing any power window or power window switch problem. If you press the power window switch and all you hear is a grinding or clicking noise, or the window acts like it wants to move, then stops and makes noises, then chances are you have a mechanical failure and will probably need to replace the power window regulator or motor. If you press the motor and hear nothing or the window does nothing, then you may have a Blown fuse or an open or short in the wiring circuit that supplies the power window circuitCheck the fuse first. Refer to your owner’s manual for the location of the fuse panel (usually located under the dash on the driver side, on the driver’s side kick panel, or on a side panel in the center console. Locate the numbered fuse that corresponds to the power window circuit, then pull out the fuse to see if the wire inside has burned through or is broken.If the fuse has blown, there is either a short or an overload in the power window circuit. Try replacing the blown fuse with a new one (make sure it has the SAME amp rating as the original, not lower, not higher). Then turn the ignition key on and try to lower one of the power windows.If the new fuse blows immediately, there is a short in the wiring that will have to be found and fixed. DO NOT try to install a higher amp fuse or bypass the fuse for the power window circuit, as this is your only protection against a dangerous overload that could start an electrical fire!If the windows work, it may have been a temporarily overload that caused the fuse to blow. Trying to lower a window that is frozen shut in the wintertime can do this and/or break the window mechanism inside the door.If the fuse is okay, there may be a break in the wiring that routes power to the power window motors and switches. You’ll probably need to look up a wiring harness diagram for your vehicle to identify and trace the wires in the circuit.For more information on diagnosing Power window problems, please go here for step by step instructions on finding out why your power windows will not go up or down.

on Sep 13, 2010 | Acura Integra Cars & Trucks

1 Answer

The power window on the passengers side stopped working. I tryed to check the fuses and breakers, but couldnt find either one. Question: is there one and I am just missing it? Drivers side works fine. It...


Probably motor and regulator, if you tried both switches on driver and passenger side suspect both window motor and regulator on passenger side sometimes while pressing the switch on the passenger side bang on the door panel inside and sometimes it may move if it does then suspect only the window motor.

Oct 11, 2010 | 2000 Dodge Caravan

1 Answer

Drivers side window not working. I can manually move it up in down with my hand but the power window does not move when the switch is used. All other windows work. Drivers side makes a clicking/grinding...


IF there is a grinding noise then the motor is trying to move, so take out he unit and try to see if the motor works , if so the mechanism is faulty or the motor does not have power in the drive.
can be the driver switching the motor or the motor itself. Replace after testing the transistor drive.

Sep 28, 2010 | 2004 Kia Spectra

1 Answer

I have a 1998 Subaru Outback Legacy Wagon. The driver side window switch was having problems for a couple months - down switch was fine, but when I tried to close the window, I'd have to press on the...


do any other windows work?
do they work from the drivers switch panel?
if they do, then power is likely to be present to the switch.
if the driver and pass. switches are interchangeable, try swapping them.
if all windows are dead, look for blown fuse first, then check switch and the socket/wiring harness connected to the switch.
smell the switch, if it smells burnt, it probably is...

Aug 06, 2010 | 1998 Subaru Impreza

1 Answer

My power window to my toyota tundra (2002)passenger window does not move up/down. Press switch, and no sound, no movement. what can I do to restore power?


try using the window switch on the pass side and drivers side. is the master turned on to allow the pass switch on? try closing the pass door while holding the switch in the DOWN position, sometimes this will jar the window loose. If you watch the dome light real closely while pushing the window switch down, it should dim slightly, it it does dim, then the switch is working.

Oct 09, 2009 | 2002 Toyota Tundra

2 Answers

Driver window works intermittently when closing


you need a new windo regulator assembly.

Jun 26, 2008 | 2001 Dodge Caravan

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

152 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8215 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...