Question about 1996 Subaru Legacy

1 Answer

Replaced fuel pump on 96 legacy wagon. will not start now, it does start if hot wired directly to pump. Any suggestions? Have also replaced the fuel pump relay.

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Champion:

    An expert who has answered 200 questions.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

  • Expert
  • 231 Answers

Hi yes had same problem it was the plug that sits under the rear seat that supplys power to the fuel pump it had got hot and was charred inside, just cut it out and soldered wires together and fixed prob hope it helps

Posted on Apr 05, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1995 subaru legacy wagon stopped running while I was driving


Try the fuel pump the car needs spark, fuel and timing to run so if you can rule out timing, then try the first two mainly the fuel pump

Apr 21, 2012 | Subaru Legacy Cars & Trucks

2 Answers

1994 CONCORD NO POWER TO FUEL PUMP, NOT FIRING AND DOES TURNOVER, REPLACED CRANK SENSOR AND CAM SENSOR, TRIED DIFFERENT RELAY FOR FUEL PUMP-STILL WON'T START?


NO POWER TO FUEL PUMP......CHECK ALL IN LINE WIRING
NOT FIRING... START WITH COIL PACK, DIST CAP ETC...PLUGS/WIRES??????
"HOT WIRE" (DIRECT W/ FUSED JUMPER) TO FUEL .PUMP....NO - GO,,,BAD PUMP

Oct 09, 2011 | 1994 Chrysler Concorde

1 Answer

I have a 92 legacy sedan with bad motor. Bought a 92 legacy wagon turbo. Do I have to change wire harness in front with computor, or can I change just computor?


hi im presuming your old car is non turbo if so you will have to change a lot of parts over to make it work, you will have to replace entire engine loom, the ecu will need changed over then the fuel pump and all of the fuel lines will need to be replaced with the bigger turbo model ones to keep up also the trans will bolt strait up but will be the major weak point so swap over if possible.

Jun 15, 2011 | 1992 Subaru Legacy

3 Answers

How long should it take to replace a clutch on a 94 subaru loyale 4wd. thanks


Hello. Replacing the clutch in a 4WD is a pretty big job. Dealerships charge it as a ten hour job. It could take from 8-12. Joe

Mar 30, 2010 | 1997 Subaru Legacy

2 Answers

Replaced fuel pump. turns over strong but won't


check wireing harnes to fuel pump that yr and model were prone to going bad and causeing fuel pump to kick off and on at wrong time

Nov 16, 2009 | 1996 Chevrolet C1500

2 Answers

How to replace fuel pump on 96 Subaru legacy


the fuel pump is located in the fuel tank, that tank must be pulled to do this. the procedure for removing the tank and pump are very little changed from car to car, here are a good set of general instructions with photos.

http://www.aa1car.com/library/fuel_pump_replace.htm

Nov 12, 2009 | 1992 Oldsmobile Cutlass

2 Answers

How do you replace the fuel pump in 1992 2wd Subaru Legacy Wagon


  1. Relieve the fuel system pressure.
  2. Disconnect the negative battery cable.
  3. Remove the rear exhaust pipe and muffler assembly.
  4. On All Wheel Drive (AWD) vehicles, remove the rear differential assembly and the rear crossmember. You do not have AWD so this step is not for you
  5. Remove the fuel filler cap and drain the fuel into a suitable container.
  6. Remove the fuel filler pipe protector.
  7. Raise and support the vehicle safely on jackstands.
  8. Remove the fuel filler, air vent and delivery hoses.
  9. On AWD vehicles, disconnect the air breather hoses and evaporation hose from the pipes.
  10. Support the fuel tank with a floor jack or equivalent lifting device.
  11. Loosen the attaching bolts and lower the fuel tank slightly.
  12. Disconnect the fuel pump harness

Feb 18, 2009 | 1992 Subaru Legacy

Not finding what you are looking for?
1996 Subaru Legacy Logo

356 people viewed this question

Ask a Question

Usually answered in minutes!

Top Subaru Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7772 Answers

Are you a Subaru Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...