Question about 1997 Honda Accord
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: Main Relay on 92 Honda Accord
On you Honda Accord the main relay is located.
On left side of dash, under the Instrument Panel. Left side of the Steering Column.
To get axces You will need to Remove the Cruise Control Module. That is attached with 2, 10mm screws. one on the Steering column, the other one at the dash braket.
after you remove the cruise control module, you will see a Little Box Gray colour, Is a Relay more biger than a Regular Relay.
The NUMBER on the RELAY is : RZ0088.
OK.. I hope this help on your question.
Thank you for use fixya.
Posted on Aug 16, 2008
First drain radiator by opening drain valve,"located on bottom corner usualy the right,but not always." If you open the overflow or remove cap this will happen much faster.For safety sake disconnect ground wire from battery,the radiator is locked down by top cover that attaches to body with generaly 4 bolts, upper and lower hoses have to be disconnected and if it is automatic the transmission cooling lines are connected in stacked fashion,"one above the other."The cooling fan has to be unplugged and it should be removable at this point,"when unplugging fan be carefull with connector so it doesn't break.reverse steps to replace making sure the bolts go in the right place and it all fits properly.the thermostat,"located behind the kneck of upper hose," should be replaced after connecting lower hose because in order to fill the block up and prevent damaging thermostat the block shoud be filled with coolant before attaching upper hose.
Posted on Apr 20, 2009
SOURCE: 1997 honda accord overheating
well you should first hard wire the non working fan to the battery to see if it is ok, then I would check the engine coolant temperature sensor, it is the sensor that tells the computer to turn the radiator fan on
Posted on May 27, 2009
Difficult to describe, but I will give it a try.
Inside the driver's side fender, close to the front of the car, there is a bracket that is held in place by one bolt, but which has a short horizontal bar as part of it which has two large clips encircling two cylinderical devices which have wires clipped into them at the bottoms. The one closest to the front (radiator) is the compressor clutch relay. The other one is the condenser fan relay.
Hope this helps you find it.
Posted on Oct 20, 2009
Detach the cable from the negative terminal of the battery. Caution: If you have an anti-theft radio, make sure you have the activation code before disconnecting the battery.
Remove the battery and battery tray from the engine compartment (remove the battery first, then remove the bolts for the battery tray and remove it.).
Remove the lower radiator hose and the wiring harness from the starter bracket. Make sure they are positioned out of the way.
Clearly label, then disconnect the wires from the terminals on the starter motor solenoid (the smaller cylinder attached to the starter). Disconnect any clips securing the wiring to the starter.
Remove the mounting bolts (two) and detach the starter (pull it gently out of its housing).
Reverse this procedure for installation.
Hope this is of help to you.
Posted on Dec 26, 2009
Tips for a great answer:
Sep 13, 2013 | 1997 Honda Accord
Apr 19, 2012 | 1997 Honda Accord
Sep 20, 2011 | 1997 Honda Accord
Sep 07, 2011 | 1997 Honda Accord
Jul 03, 2009 | 1997 Honda Accord
Sep 29, 2008 | 1992 Honda Accord
135 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: