Question about Chevrolet Corvette

2 Answers

Were is the fuse for the fuel pump on my 1993 corvette

Posted by on

2 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 693 Answers

Check under your hood in a small black box, Remove the cover and the digrame should be there marked fuel pump, Good luck

Posted on Apr 01, 2011

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Where can I find the auxiliary fuse box (or clock, or holder) in a Corvette 1993??

Posted on Aug 14, 2011

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 25 Answers

SOURCE: My corvette doesnt want to start because theres no power going to the fuel pump fuse.

THE OIL PRESSURE SWITCH IS NEXT TO THE DISTRIBUTOR, JUMP THE PLUG AND SEE IF IT RUNS .. ASSUMING THE FUSE IS GOOD

Posted on May 29, 2009

abauto
  • 353 Answers

SOURCE: INSTRUCTIONS TO INSTALL FUEL PUMP ON 1989 CORVETTE

REMOVAL

  1. Relieve fuel system pressure.
  2. Disconnect battery ground cable.
  3. Remove fuel filler door.
  4. Remove fuel cap.
  5. Remove fuel tank filler neck housing and disconnect drain hose.
  6. Remove screws attaching fuel meter/fuel pump to tank.
  7. Disconnect fuel lines, fuel vapor line and electrical connector.
  8. Remove fuel meter/fuel pump and gasket.
  9. Replace fuel pump.
INSTALLATION
  1. Reverse procedure to install.

Posted on Jul 27, 2009

  • 1 Answer

SOURCE: trying to locate fuel pump relay for 1991 corvette- coupe

The fuel pump relay in the 1991 corvette is located under the IP on the pass side.
Open pass door, unscrew two screws under the glovebox (you will be upside down in the car), take off the fuse panel, unscrew third screw to plastic plate underneath glovebox, pull away carpet (velcro), pull down plastic plate (watch out for the wiring to the lamp), then under the glovebox you will find a number of fuses and relays if you dive in under there DEEP, prob 4 or 5 in a row, not really sure wich one, but one in the middle is the fuel relay, and they are the same (interchangable).
Take a look at --the12volt.com/relays/relays.asp--
It´s those relays we are talking about.

Posted on Sep 12, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

No start no fuel 1990 corvette has spark and new fuel pump


As someone who made this mistake, are all the wires reconnected under the fuel door? Check fuel pump fuse

Jul 11, 2014 | 1990 Chevrolet Corvette

1 Answer

1993 corvette was running great then going about 50 it just quit, cranks but won,t start


check your fuel pressure should be 35 to 42 with key on engine off,and about 5 to 7 more with engine running and vacuum line off the regulator,also check your fuel regulator with vacuum off it should be dry if it is wet with gas it is bad

Apr 30, 2014 | 1993 Chevrolet Corvette

1 Answer

1993 Corvette fuel pump symptons


Assuming you have replaced the fuel filter, you would check the pressure at the fuel rail with a gauge.

Jun 24, 2012 | 1993 Chevrolet Corvette

2 Answers

Where is the fuel pump fuse for an 89 corvette


is the car left or right hand drive .if left hand drive try looking in the right hand side ,also sometimes a fuse will cover more than one item , i would check all fuses

Mar 12, 2012 | 1989 Chevrolet Corvette

1 Answer

1982 Corvette fuse relay location and do you have to drop the gas tank to replace the fuel pump?


Yes, you need to remove tank.
There is a fuel pump test connector, either a single wire connector in engine compartment, left side, OR terminal G of the ALCL, the diagnostic test connector under the dash. Put battery voltage there and see if pump works.
Diagram also shows a fuse for the pump, probably in the dash's fusebox.The relay is probably is there also.

Nov 21, 2011 | 1981 Chevrolet Corvette

1 Answer

I have a 1986 Corvette that blows the 10amp fuse for the fuel pump. How can I determine the cause?


If the fuse blows after turning the ignition key to the "on" position you might try disconnecting the electrical connector to the fuel pump and turning the key to the "on" position. If the fuse still blows there is a short in the wiring to the fuel pump. If the fuse does not blow it is more than likely the fuel pump.

Jan 27, 2011 | 1986 Chevrolet Corvette

2 Answers

Trying to locate fuel pump relay for 1991 corvette- coupe


The fuel pump relay in the 1991 corvette is located under the IP on the pass side.
Open pass door, unscrew two screws under the glovebox (you will be upside down in the car), take off the fuse panel, unscrew third screw to plastic plate underneath glovebox, pull away carpet (velcro), pull down plastic plate (watch out for the wiring to the lamp), then under the glovebox you will find a number of fuses and relays if you dive in under there DEEP, prob 4 or 5 in a row, not really sure wich one, but one in the middle is the fuel relay, and they are the same (interchangable).
Take a look at --the12volt.com/relays/relays.asp--
It´s those relays we are talking about.

Jul 08, 2009 | 1991 Chevrolet Corvette

2 Answers

My corvette doesnt want to start because theres no power going to the fuel pump fuse.


I am looking at alldata , the schematics for the fuel system. I see a fuse in the fuse block(10 amp) that comes from the fuel pump relay to the pump. I see a fuseable link (link H)that goes through a oil pressure sending unit. I would get a test light and test the oil pressure sending unit, the inline fuseable link and the relay. If still no power check the connection at the pump and then work backwards testing the harness.

May 27, 2009 | 1985 Chevrolet Corvette

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

222 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8180 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...