Question about 1999 Chrysler Town & Country

1 Answer

'99 Chrysler T&C van stalls without warning but starts right back up with no problem. nothing registers on computer. replaced fuel filter, had tune up. Still stalls every now and then. Stalled 8 times yesterday but drove it for a week after having tune up with no stalling issued. replaced starter about 8 months ago. Any ideas what's causing it to stall?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 3,400 Answers

When was last tune up? Plugs, wires, all fluids & filters especially fuel filter? I'd start there and run a good fuel system cleaner through it. Also avoid cheap fuel - lot of questionable fuel at cheap/cut rate stations.

Posted on Apr 01, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I replace the fuel filter on a Chrysler 1997 town and country 3.8 lxi


  • Relieve the fuel system pressure by removing the fuel pump relay from the power distribution center. Start the engine and allow it to run until it stalls. Try to start it again and let it run until it stalls. Repeat this procedure until it no longer will start. Turn the ignition off.
  • Disconnect the negative battery cable and raise the vehicle. Support the fuel tank with a transmission jack. Locate the fuel filter on the top of your Chrysler Town & Country fuel tank.
  • Remove the fuel line from the front of the tank and then the ground strap. Next, remove the inboard side of the fuel tank straps and front T-strap fastener. Lower the tank about 6 inches.
  • Detach the fuel lines from the fuel pump module and then remove the fuel filter. Put the new filter in its place. Tighten the fuel filter bolts to 40 inch pounds.
  • Reconnect the fuel lines to the fuel pump module and reposition the tank. Replace the front T strap fastener and tighten it to 250 inch pounds. Put the inboard fuel tank straps back and tighten them to 40 foot pounds.
  • Put on the ground strap and connect the fuel line in the front of the tank. Start the engine of your Town & Country and check for leaks.


  • Read more :

    Nov 09, 2015 | Chrysler Cars & Trucks

    1 Answer

    I'm having trouble starting the car. When it idols the RPM's pulsates up-and-down and then it stalls. Once under way the car seems to run fine but without any warning it will die as I start to


    check air filter, might be plugged, [dirty so engine is starving for air.] check fuel lines & filters, dirt blockage need replaceing, check for fuel leaks in lines etc, uses fuel & then sucks air causing it to stop, listen to see if fuel pump is running properly & not stuttering could be short in it's wiring

    Dec 16, 2012 | 1994 Mercedes-Benz E-Class

    2 Answers

    I have a 95 town and country the gauges are not reading correctly the oil pressure reads really high when driving for about 10 minutes then levels out I just had an oil change my fuel gauge will sometimes...


    If the check engine light is not on, stay away from sensors for now. First when is the last time you have had a tune up? PLugs , wires, air and fuel filter. Stalling at a stop can be from the air filter, fuel filter (clogging up), It can also be from the catalytic conveter, these also clog up. It can be from vacuum leaks, this usually has a rough idle also. It wouldn't hurt to check for codes, intermittant codes don't always pop the light on. On some vehicles the o2 sensors can cause a rough idle and stall at stops, ut they usually set a code/ light.

    Jul 19, 2011 | 1995 Chrysler Town & Country

    1 Answer

    Car keeps stalling out. Replaced battery &


    sounds like you are dealing with either a bad crankshaft sensor in ignition coil(s)

    Jun 07, 2010 | 2005 Chrysler Town & Country

    1 Answer

    My van stalls when i let off the gas?`


    i have replaced most things on the van due to same issue.. im going to do the map sensor next.. good luck.. if questions, email me at meduso99@yahoo.com

    Nov 09, 2009 | 1994 Chrysler Town & Country

    1 Answer

    1999 chevy astro van studdered stalled and now will not start


    I have had that exact issue on my 99 astro,but before it left me stranded on the side of the Highway it was running a little rougher than usual,but once accelerated it was fine,until it finally Stalled. So i Replaced the fuel filter and The Cap and Rotor and now it is Fine,started Right Up.

    Jun 16, 2009 | Chevrolet Astro Cars & Trucks

    1 Answer

    1996 astro stalling/stalls


    Right turn signal - activate turn signal and check to see if bulb (front and rear) are flashing. If not it will affect the flashing timing. Replace bulb. As for stalling, may yet be sediment/gunk in tank that is clogging new fuel pump filter and inline filter. Or an idle/throttle position sensor. Hatch problem, I've no idea. Family members 1998 Grand Caravan has been infected with similar gremlins in the sliding doors. Best advice is to obtain a Chiltons/Haynes repair manual and go through the troubleshooting section.

    May 02, 2017 | 1995 Chevrolet Astro

    1 Answer

    199 Jeep cherokee stalls without warning


    Does it start right back up after it stalls? make sure all conections are tight at fuel pump, sounds like it could be loosing ground at pump, or hot lead is loosing its connection at pump.Also fuel pump relay could be getting hot and quits working.

    Feb 09, 2009 | 1999 Jeep Cherokee

    3 Answers

    1994 caravan stalls


    if it stalls and start right away without long crank time more likely you have ignition spark cutting out.this vans are notorious for ecm failing to ground contorol.if it is a 3.3 or 3.8 V6 very common problem. check for spark at a plug wire when stalles and if no spark replace ecm.i hope i was helpful. please rate me.

    Jan 28, 2009 | 1994 Dodge Caravan

    Not finding what you are looking for?
    1999 Chrysler Town & Country Logo

    Related Topics:

    310 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Chrysler Experts

    yadayada
    yadayada

    Level 3 Expert

    75817 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    22156 Answers

    Jeff Turcotte
    Jeff Turcotte

    Level 3 Expert

    8180 Answers

    Are you a Chrysler Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...