Question about Toyota Passenger

1 Answer

Poor pick up - Passenger Toyota Cars & Trucks

Posted by Anonymous on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 3,400 Answers

When was last tune up? All fluids, filters plugs, wires??? I'd start there and run a good fuel system cleaner through it and AVOID cheap gas.

Posted on Apr 01, 2011

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Poor pick after engine head got repaired


hi Medovi

poor pick-up and less miles per gallon after engine head repaired is due to two things could be done wrong during repair,
1: wrong tappets clearance, witch is suppose to be 0.30 MM inlet, 0.40 MM exhaust
2. wrong timing setting ( timing belt setting )
better to get your mechanics to double check it
good luck

Jan 06, 2014 | 2008 Fiat Palio 1.2

1 Answer

I have a 94 astro van when it is cold it will start but let it set it wont start till the engine is cold can someone pls help


When a vehicle start from a cold start it is in open loop,it gets more fuel,resistance on the sensors are low,so is the ignition coil.When you say you replaced the distributor is that with a pick up? You also need to inspect the pick up terminal for corrosion. and bad connection,this also goes for the ICM which is recommended when you replace the pick up and you need to inspect ICM connection for corrosion and poor connection

Mar 21, 2012 | 1994 Chevrolet Astro

1 Answer

Engine running ruff ,engine misfiring even after plug change ,wires changed rotor and distributor


check the map sen check for vacuum and check to see if at idle if removed vacuum from the map sens Eng should stall however it a known wit the distributor pick up coil to not put out a good signal to the coil their for poor spark and poor idle also check for water in fuel

Nov 11, 2010 | 1993 GMC Sierra K1500

1 Answer

Not picking up gas when engine is cold, sputtering, bogging out especially when travelling uphill, Is this some sort of a sensor maybe??,the spark plugs are new. thanks


check fuel filter. it is starving for fuel. unless the fuel pump is bad. check filter first, then go from there. symtoms of a bad coolant sensor--poor cold idle, stalling, rich mixture retarded timing, slow idle speed, cold hesitation or stumble, poor fuel milage.

Aug 20, 2010 | 2001 Pontiac Grand Prix

1 Answer

2003 dodge caravan is slow to pick up speed


Replace the fuel filter as a first step, but also check for a faulty fuel regulator. Find the fuel regulator near the throttle body in the fuel line and pull off the rubber hose and see if there are any traces of fuel dripping out of the rubber hose. The hose is for air only and fuel in that hose indicates the fuel regulator requires replacement. Also check for vacuum leaks in the hoses from the motor's intake to the crankcase where the PCV valve is located. Relatively small holes in that area will cause poor acceleration and a lean condition in the motor and loss of power or hesitation. Also check the plastic air tubes going from the air filter box to the throttle body area to make sure everything is tight and there are no holes. Holes or leaks there will cause hard starts and poor driveability.

Jul 25, 2010 | 2003 Dodge Caravan

2 Answers

Car starts but cuts out on tickover just put on new battery


if you mean the vehicle starts and cuts out immediately then it is an immobilizer problem. a diagnostic test will pinpoint the problem as a.fault will be stored in the memory. fault normally a poor connection at ignition pick up ring or at instrument cluster connectors. [immobilizer control unit built into cluster]. unplugging and reconnecting normally sorts out this fault. poor connection due to very fine pin connectors.

May 20, 2010 | 1999 Volkswagen Passat

2 Answers

When you give it gas it picks up slow and doesnt


52 psi fuel pressure is good ,so im leaning to timing,does it run poor ho or cold

Feb 24, 2010 | 2000 Dodge Stratus

2 Answers

Oil pressure drops to nothing and engine stalls


it has worn rod bearings . motor needs rebuild

Jul 08, 2009 | 1989 Chrysler LeBaron

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

12 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

77169 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8732 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...