Question about 2006 Peugeot 604

Open Question

Hi,I have got Peugeot 607 2.2 petrol 2004 that has ABS ESP light on.Put it on diagnostic comp that showed ABS pump faulty. I took out the ABS pump and sent it for repair but the specialists sent it back as there was no fault(ABS pump working normally).I have checked wheel sensors and fuses-all OK.Any suggestions what it might be? Thanks for answers

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 2 Answers

SOURCE: electrical fault on peugeot 406 hdi

lift the carpet at o/s/f {drivers front footwell} there is two multiblock connecters guarenteed tobe sodden with water disconnect connectors& dry with a hair dryer on low setting hopefully the pins are not corroded reconnect connectors this is aknown fault i have worked with peugeot&citroen for 24 years kind regards alastair

Posted on Jan 30, 2009

Richie_asg1
  • 1036 Answers

SOURCE: Dashboard fault

I too have a Peugeot 206 - and has given me nothing but grief - mostly electrical.

The fact you are suddenly losing systems, and draining battery points to a short in the wiring loom - which is a common fault on pugs.

I advise you trace the wire from the rear heater to the fusebox (it's labeled in there). Use a cheap multimeter - pull the fuse out and check the wiring both to the heater (resistance to good earth) and the supply( check for 12V )with the switch on. You may end up undoing the loom cover in the engine bay - but check your feet area first for any damaged wires. Try wiggling the loom with the ignition switch on and in neutral to find the problem. Often just taping it up properly solves it.

Posted on Feb 04, 2009

lastech
  • 408 Answers

SOURCE: ESP,ABS and brakelights comming on

hello,good day,try to replaced your brake light switch,this switch have 2 function,for brake light and for esp and bas module,ty

Posted on May 10, 2009

  • 1201 Answers

SOURCE: fault code p0245 puegoet 406 turbo fault

My book shows that P0245 is the super/turbo charger solenoid "A" voltage is low.

Posted on Sep 29, 2009

Testimonial: "cheers for that x18wheeler60 thought it was low pressure not voltage,dont suppose you no which selonoid might be causing this nightmare."

  • 1 Answer

SOURCE: ABS and brake fault warning

I has a clicking/knocking noise on one of my 407 (54 plate) front wheels after a change of brake pads. On investigation I found that the bracket to which the caliper hydraulic hose was fixed (at the lower end of the suspension strut) had been bent downward and was catching the CV boot clip. I bent it back up and the noise went. It is possible (if the brake caliper is not supported during pad change) to bend the bracket supporting the hydraulic hose. It could also interfere with the ABS wheel sensor bracket - check. Simply jack-up and support the car on the side with the noise and turn the wheel by hand to see what gives (don't go under the car until it is supported safely)..

Posted on Oct 01, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

The Dynamic stability control (ESP/ASR) warning light is displaying, accompanied by an audible signal with a message 'ESP/ASR system faulty. What do i do to correct this fault?


I think you need a deeper code read- only the dealer can get the diagnostic codes to find the specific sensors that might be broken. Should do it for free or a few dollars

Mar 20, 2014 | 2007 Peugeot 607 2.0

1 Answer

Peugeot 607 2004, the winshield wipers do not work (the liquid is not being pumped). Thank you


if you mean the washers then this is a common fault if you put that blue liquid in ,the antifreeze makes the rubber seal inside swell up and jam ,what i do is to remove the pump take it apart and the rub the rubber down so move freely again ,a new motor is around 30 euros

Jul 25, 2013 | 2010 Peugeot 607 2.7

1 Answer

EPS light is on


The ESP system means the Electronic Stability Program. If the ESP lights on the dashboard permanently the ESP system is faulty. You must access the ESP Electronic Control Unit (ECU) memory for pull out all DTC (Diagnostic Trouble Codes), using diagnostic equipment connected to the data link connector of the car. Then you will be full informed about bad pieces (e.g.: front right wheel abs sensor interrupted, ...). After bad pieces replacement you will be able to erase all faults memored by ESP ECU, in other words reset the ESP system and turn off the warning lamp on dashboard.

May 30, 2011 | 2004 Volkswagen Passat

1 Answer

ABS and ESP lights on all the time. I bought Audi A4 B6 2004 only two months ago. It started in heavy rain.


The ESP system means the Electronic Stability Program. If the ESP & ABS lights on the dashboard permanently the ESP & ABS system is faulty. You must access the ESP & ABS Electronic Control Unit (ECU) memory for pull out all DTC (Diagnostic Trouble Codes), using diagnostic equipment connected to the data link connector of the car (placed in dashboard, under a plastic cover above the ashtray). Then you will be full informed about bad pieces (e.g.: front right wheel abs sensor interrupted, ...). After bad pieces replacement you will be able to erase all faults memored by ESP & ABS ECU, in other words reset the ESP & ABS system and turn off the warning lamp on dashboard.

Dec 31, 2010 | 2004 Audi A4

2 Answers

Peugeot 407 05 reg my abs and esp lights stay on why


have it plugged in at your local garage and if it comes up with right rear wheel speed sensor faulty then dont panic!!
usually if you remove the sensor and clean up the area where it sits with some sand paper or a file and re fit it then it should be fine

let me know if this helps
cheers

Oct 12, 2010 | 2006 Peugeot 405

1 Answer

Hi, i have a 2.2HDI 607 on an 03plate. yesterday


new exhaust silencer with particle filter 1000euros plus .fit a normal exhaust

Sep 09, 2009 | 2005 Peugeot 405

1 Answer

Service Vehicle soon trouble light comes on, along with ABS light and Trac Off light, but no diagnostic codes show up on diagnostic reader. How do you determine what is wrong?


If you are using an obd2 reader, make sure it has all the updates. If the check engine light is on, is should show up on reader. There is also a ABS light tester as well. It sounds like an error in the ABS/Trac cirucuits. It could be a bad pump or faulty module.

Jul 06, 2009 | 2004 Pontiac Grand Am

2 Answers

ESP,ABS and brakelights comming on


hello,good day,try to replaced your brake light switch,this switch have 2 function,for brake light and for esp and bas module,ty

May 09, 2009 | 2001 Mercedes-Benz E-Class

4 Answers

ESP and warning lights on Peugeot 407


abs esp warning light coming on peugeot 407

Feb 15, 2009 | Peugeot 407 Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

844 people viewed this question

Ask a Question

Usually answered in minutes!

Top Peugeot Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Wahs Team

Level 2 Expert

205 Answers

yadayada
yadayada

Level 3 Expert

75077 Answers

Are you a Peugeot Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...