Question about 2001 Dodge Ram 3500 Truck

1 Answer

2001 dodge ram 2500 4x4 diesel code p0236 - 2001 Dodge Ram 3500 Truck

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 82 Answers

The code is map sensor too high, too long. certain programmers with boost foolers can cause this. if running a programmer disconnect and if problem isnt fixed replace the map sensor.

Posted on Apr 01, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the filter located on a 2001 dodge ram


2001 Dodge Truck RAM 2500 3/4 ton 4WD 5.9L Turbo Diesel 6cyl the Fuel Filter is located under hood, passenger side, lower engine area, mounted above starter.

2001 Dodge Truck RAM 2500 3/4 ton 4WD 5.9L SFI 8cyl the Fuel Filter is located under vehicle, center, below seating area, mounted on top of fuel tank, in fuel pump module.

Hope helps with this (remember rated the help).

Jun 01, 2010 | 2001 Dodge Ram 2500 Truck

1 Answer

How do I clear the error codes on a 2001 Dodge Ram 3500 diesel?


You will need a hand-held obd2 scanner to clear the codes. Advanced Auto store will do it for free if you have one in your area. Other part stores will also do it for free.
You can disconnect the negative battery cable for 10 minutes and replace it, but it doesn't always work. Sometimes the codes are stored in memory and require the hand-held obd2 to clear them

Apr 19, 2010 | 2001 Dodge Ram 3500 Truck

1 Answer

Dodge 2500 ram diesel no tail lights and my abs


replaced the IPM (the fuse box) it was shorted

Oct 25, 2009 | 2001 Dodge Ram 2500 Truck

1 Answer

P236 troub le code 2002 cummins in a dodge 1 ton


Computers and Control Systems: Diagnostic Trouble Code Tests and Associated Procedures
P0236
SYMPTOM
P0236-MAP SENSOR TOO HIGH TOO LONG
WHEN MONITORED
Engine running.
SET CONDITION
Boost pressure signal indicates boost pressure is high when other engine parameters (i.e. speed and load) indicate boost pressure should be low or
boost pressure is low when other engine parameters indicate it should be high.
POSSIBLE CAUSES
- Other codes
- Checking boost pressure sensor
- Checking the 5-volt supply circuit
- Sensor ground circuit open
- MAP sensor
- MAP signal circuit open
- MAP signal circuit STV
- MAP signal circuit STSG
- MAP signal circuit STG
- ECM

Sep 01, 2009 | 2002 Dodge Ram Maxi

1 Answer

2001 dodge ram 2500 diesel with 6spd manual trans. showing fault codes p1698 , p0237 & p0562. the truck will crank but not start. it has two new battery & map sensor.


p0562 is System voltage low
p0237 is Turbo/supercharger boost sensor A circuit low

cannot find a code p1698 but did find a p0698
p0698 is Accelerator pedal position sensor supply voltage to low

Apr 13, 2009 | 2001 Dodge Ram 2500 Truck

1 Answer

What is a Code 84


Hello
Welcome to FY
I would check your speed sensor located on the rear end this is on top of the housing this will throw that code too.
RD

Jan 10, 2009 | 2001 Dodge Ram 2500 Truck

1 Answer

ENGINE LIGHT ON


go to a parts store, most will scan the codes as a free service, write them down, ask them what they recommend to fix the problem, if u need more info, post it here w/ the codes.

Dec 12, 2008 | 2001 Dodge Ram 2500 Truck

2 Answers

ODB II Code P0236 & P0237 on a 2001 Volvo V40. What do I need to fix?


P0236 Turbocharger Boost Sensor A Circuit ange/Performance and P0237 Turbocharger Boost Sensor A Circuit Low. I would check to ensure your Sensor is didnt come unplugged and if not I would replace the Boost Sensor. Thanks for Using FixYa!

Sincerely,

JC

Dec 06, 2008 | Volvo V40 Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

363 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8152 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...