Question about 1983 Cadillac Eldorado

Open Question

I need directions to remove and reinstall a power antenna for a 1983 Cadillac Eldorado? Seems the inner fender/wheel well assembly may need to be removed. There is no access from inside the door jamb, or access panel in the inner fender in the engine compartment.

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: How Do I remove the door panels in my 94 cadillac deville concours?

u have to remove the panel that has the door handle in it, remove the panel which has the window and the seat adjusters, unplug the wires and just lift the door panel and there u are.

Posted on Oct 16, 2008

  • 1 Answer

SOURCE: removal of door panel

how do i remove the rt. front door pannel to service the window operator?

Posted on Dec 14, 2008

  • 1 Answer

SOURCE: how to remove drivers inner

how to remove drivers inner door panel on 2003 cadillac deville dhs to repair window trac

Posted on Dec 28, 2008

cadman000
  • 607 Answers

SOURCE: 1983 cadillac eldorado,what i want to know is how

You need to remove the glove box. Remove the Programmer from the heater box. The heater box has studs going through the firewall attached with speed nuts on the UNDERHOOD side of the firewall . The nuts on the lower part of the box cannot be seen , so must be felt, and then removed. Place rags on both openings of heater core so as not to leak any coolant into the car. Heater box once unbolted must be artfully removed from UNDER the dashboard. Hope this helps

Posted on Jun 05, 2009

emissionwiz
  • 75235 Answers

SOURCE: 2002 Cadillac ElDorado Driver's door panel

U ARE GOING TO HAVE TO REMOVE THE PANEL AND REPAIR THE BROKEN PANEL RETAINERS. THE PARTS ARE VERY CHEAP.

Posted on Jun 25, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to remove a L/Front fender on a 1996 Mazda 626


Fenders are bolt on. Remove the plastic inner wheel well. Rais the hood. Remove bolts along too, in door jamb and inner wheel well. Most vehicles also require removing the front bumper cover, headlight assembly and sometimes the grill. You should be able to see the bolt hole locations on the replacement fender. Once you install it do not tighten up the bolts. You'll need to align the fender til the hood to get a narrow consistent seam then tighten the bolts.

Feb 10, 2017 | Mazda Cars & Trucks

1 Answer

My bolt that holds in my antenna has completely stripped of the threading. What is everyones advice should I get a new in dash sound system and antenna or just replace the bolt?


If you have an in fender antenna ( front fender) it should be accessible from inside the guard without removing the fender. You will have to remove the inner splash guard to get to it. Removing the wheel helps a lot to do the job The antenna is held in place in the fender by the silver nut at the base of the antenna just outside the fender.

Nov 05, 2014 | 2006 Jeep Liberty

2 Answers

Where is the power antenna motor located for a 1992 buick regal?


I have not owned a buick for years. However, the one I did have trouble with the power antenna motor was located directly under the antenna. It was in the rear fender housing. I have to remove the trunk lining on the side of the fender. It was mounted a bracket. It was easy to replace as it all comes as a complete assembly. Hope that helped

Feb 21, 2012 | 1992 Buick Regal

2 Answers

How do I replace the electronic aerial on my 1983 Cadillac Eldorado. Aerial is located on passenger side front. Thanks


Normally ,you remove inner wheel well cover to access the mast itself,but from there you have to find the antenna wire in the right kick panel and trace it to the back of the radio.

Jul 16, 2011 | 1983 Cadillac Eldorado

1 Answer

How do I change my alternator


Not fun! easier on a lift! disconnect the battery, remove the serp. belt (drive belt) remove the square inspection plate and the inner fender and then you remove the 3 bolts wiggle it out then reverse to install. REMEMBER THE PATTERN OF THE BELT IF NOT BROKEN OFF!

Sep 28, 2010 | 2000 Cadillac Eldorado

4 Answers

Can i install 16'' rim on a 1983 eldorado


If a wheel company has wheels for your application, yes. If not which I believe nobody makes wheels for this designed car do not attempt to do so for they will not work

May 06, 2010 | 1983 Cadillac Eldorado

2 Answers

My antena wont go down ,and the motor wont go off , even when the car is shut off .


Unplug the harness to the ant.It will not go off,until you replace the whole ant.mass.The gear(plastic)are stripped out,and the motor can not sense that the any.is moving.

Jan 19, 2010 | 1991 Oldsmobile Eighty Eight

1 Answer

Remove left front fender 1967 Chevelle


There are quite a few bolts on this fender. One on the bottom of the rocker, one between the the door and fender on the "A" pillar, one on the cal, one on the firewall then several on the inner fender and several on the radiator core support. after these are removes you need to take ou the head light assembly and you should have a fender brace under the front of the car. Hope this helps.

Oct 06, 2009 | 1983 Chevrolet Malibu

1 Answer

Cadillac antenne 1976


its has a hole through the fender for the mast to come through and a brace at the motor housing to attach to the inner fender support. a threaded antenna bezel is needed to mount the mast to the fender

May 25, 2009 | 1976 Cadillac Deville

1 Answer

Remove power antenna - 96 Seville


If there is a slot in the "fender hole", it unscrews with a big screwdriver If not, check for a slide clip under fender where it goes through.

Jan 17, 2009 | 1996 Cadillac DeVille

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

44 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cadillac Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7782 Answers

Are you a Cadillac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...