Question about 1992 Oldsmobile Cutlass Ciera

1 Answer

Car spits and spudders while driving and shuts down and will not start up. I have to wait about a half hour for it to start. When the car is in park it will idle for about ten minutes and shut down. I have replaced so far the main computer, module, fuel pump, fuel filter, mass air sensor, and fuel pressure regulator on the car. The previous owner replaced the coil packs, cat, and O2 sensor. What is causing the problem?

Posted by on

  • honeymokey
    honeymokey Apr 01, 2011

    Engine size please.

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 66 Answers

Try replacing the ignition module insied the the distributor

Posted on Apr 01, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Have replace 4 coil packs in the last year and half. the car shut off as I am driving down the road and will not start back up. What would cause this?


Engine Stalling Due to Mass Air Flow/Crankshift Position ...

repairpal.com > Problems > Buick > Park Avenue
Buick Park Avenue Engine Stalling Due to Mass Air Flow/Crankshift Position Sensor ...engine shuts off when driving. ... The next two times it stop while driving it took longer to start, so i decided to ... 2000 Buick Park Avenue- 3.8L V6Visitor.

Sep 14, 2015 | 2000 Buick Park Avenue

1 Answer

Spit and spudder


Clean the idle speed control valve in the upper intake near the throttle valve with CRC brand throttle cleaner.

Jan 10, 2014 | 1996 Toyota Camry

1 Answer

Reset check engine light on 2000 avalon


stop the car and turn it off and don't forget to remove the key. the open the hood and find the battery. Then remove the negative battery terminal connector completely from the battery. with the battery disconnected turn on you headlamps as you would for night time driving. Wait an half an hour so all the current drains out the the electrical system. after the half hour TURN OFF THE HEADLAMPS BEFORE RECONNECTING THE BATTERY! Next reconnect the negative battery terminal connector back on the negative battery terminal don't forget to tighten it down. Put the key in the ignition turn the computer on to on BUT wait 5 seconds before actually starting the car, then start the car as normal and drive the car at least 25 miles 10 city 15 highway so the car can relearn all it functions again **Note first time start the car my be rough due that it need to relearn if it is acting rough apron start up let it idle for a bit before driving so it can calm down**

Oct 03, 2013 | Cars & Trucks

1 Answer

When the engine is started in the morning it doesn't run right


It starts and will run perfect or will not start at all

Oct 25, 2009 | 2001 Dodge Ram 2500 Truck

1 Answer

Starts rought,drives and sounds like a lawnmorer?


The most likely cause is water allowing secondary (spark) voltage to go to ground. Look at all plug wires. Inspect carefully the inside and outside of the distributer cap...

Sep 09, 2009 | 1985 Mercedes-Benz 190

1 Answer

Looses power why driving has trouble starting you can be going down the highway then it starts to spit and spudder all the sudden pull off and shut it off for about 15 minutes or so try to fire it up it...


A good pump and a bad one look identical; problem with the bad one is that after running for a while, it gets hat, begins to bind and then stops. Once cooled down, it will repeat the process. Even when pressure testing, it may "seem" fine but not be., 'till it gets bad enough to show up during testing. Your crank position sensor can act the same way, so can an ignition coil. (internal expansion during heating shows internal shorting.) When in "no start" check for spark. This should separate fuel problem from ignition related stuff. Then, go from there. Do real testing...guessing and replacing parts can cost you a fortune.

Jul 29, 2009 | 1996 Jeep Grand Cherokee

Not finding what you are looking for?
1992 Oldsmobile Cutlass Ciera Logo

173 people viewed this question

Ask a Question

Usually answered in minutes!

Top Oldsmobile Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8180 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...