Question about 2004 Audi allroad
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
I had the brake light switch replaced by a local dealer. Cost was $140 and it fixed the problem. Have driven the car for two weeks since and no lights and all systems normal.
Posted on Oct 15, 2008
SOURCE: Audi A6 Allroad
jack the car up saftely then take the wheels off .. then you will see the brake calipier turn the wheel towards you so the calipier is facing you . at the bottom of the calp you will see a small bolt at bottom undo this and lift prize the calp up then remove 1 pad the inside on where the piston is then put calp back down and put the bolt back in just to hold it in place then when you have done this put a large stronge screw driver in via hole in front to push the piston all the way back but make sure you do the evenly and piston goes in straight or it will get stuck same with all types of brakes. once you have done this reopen calp and take the other pad out clean all area with a wire brush and replace the new pads in place,, and retighten bolt etc , before you start the other side please make sure you pump brake peddle until it goes hard again. then do same to over side ,
hope this is a great help matdav69
Posted on Apr 07, 2009
It can be your CO2 sensor. And another one that all ways makes the check engine light come on is your gas cap be for you turn your car on make sure your gas cap is on like 3 clicks then go clear the codes. If that doesn't help then good luck
Posted on Apr 13, 2009
The RADIO CODE is the security number from device car; generally this is located in the stocker label in back side radio or in the last page of the owners manual. If you dont find it, need call to the delaer and with the VIN and Serial number they can send it to you (sometimes you need to pay for this service).
Posted on Apr 16, 2010
SOURCE: p0431 code on audi allroad 02
Typcally caused by one of the front oxygen sensors or a bad ground associated with these sensors.Replace both front sensors with direct fit type NOT universal, because there may be a cracked wire and the universal sensor does not contain the complete wire harness. Direct fits, are about $20 more than universal fit type.
The O2 sensors have integrated heating elements that bring them up to the proper operating temperature. Code P0431 indicates that the O2 sensor on your driver side catalytic converter is not reaching the proper operating range. The O2 sensors are usually in the $150 range online.
Posted on Jun 30, 2010
Tips for a great answer:
Oct 22, 2011 | 2004 Audi allroad
Jul 22, 2010 | 2002 Audi allroad
May 14, 2010 | 2004 Audi allroad
Mar 26, 2010 | 2004 Audi allroad
Apr 13, 2009 | 2004 Audi allroad
274 people viewed this question
Usually answered in minutes!