Question about Hyundai Elantra

Open Question

Where is the differential oil filler plug for a 2004 hyundai elantra

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

michigan man
  • 3533 Answers

SOURCE: oil change procedure on a 2005 Hyundai elantra

it is very easy to change the oil put the car on ramps secure the back end look for the drain plug underneath the engine make sure you have the right size wrench and when you remove the plug also check the gasket on the plug to make sure it is not cracked you will also need an oil filter wrench and my other suggestion to you is to go to autozone to see if they have a Haynes repair manual for your car and if they don't see if they can order you one in the mean time they can also print you off a diagram of how to change the oil in you car safely

Posted on Jan 20, 2009

  • 1 Answer

SOURCE: location of oil filter on a 2008 hyundai elantra

It is located under the alternator. If you are looking down at the engine, it is to the far left. If you are under the car it is to the far right before the oil pan.

Posted on Feb 09, 2009

USfalcon
  • 175 Answers

SOURCE: How to replace headlight bulb hyundai elantra 2004

yes , you need to remove the headlight cover from the back after u move the bulb conector then there is a holder for the bulb u need to push down then move.
i hope it help ,,,, thanx

Posted on Mar 16, 2009

  • 2 Answers

SOURCE: oil control valve

on the lower front of the cyl head right where the thermostat is a 14 mm bolt remove that bolt and there will be a screen filter for the ocv if clogged it will reduce oil pressure to the ocv and give you a p0010 or p0011 code clean screen replace clear code all should be good

Posted on Jun 22, 2009

  • 94 Answers

SOURCE: How to replace 2004 Hyundai Elantra starter

First, disconnect the battery. Then the only part that needs to be removed to access the starter is the rubber air plenum boot between the throttle body and the air filter housing. This allows enough room to get an arm in there to access the 14mm bolts that attach the starter to the transmission. After removing the bolts, the starter can be removed from underneath the car. lower it down as much as possible, and unbolt the power cable. You may have to twist and turn it a bit to get around the support between the engine block and intake manifold, but it will come out.

Posted on Feb 07, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

2003 gmc sierra rear differential oil how much and what kind is recommended


85 or 90w will be fine, take the differental plug out and add fluid until it just does start to run out of check hole

Jan 14, 2011 | 2003 GMC Sierra 1500

1 Answer

How to refill brake fluid in 1995 hyundai elantra?


Hello,

Manual trans: remove the filler plug (high up on the drivers side of the car... looking at it from underneath) stick a thin hose attached to a fluid pump into the trans until it touches the bottom then **** the old fluid out. then fill to the bottom of the fill plug hole with the correct oil (75W-80W gear oil), replace the filler plug.
Automatic trans: remove the drain plug on the pan, drain into a container, remove pan, clean or replace filter/screen, replace pan, fill with correct oil (not common Dexron II or III -- Hyundai ATF SP-II or Chrsyler spec 7176).

Sep 09, 2010 | Hyundai Elantra Cars & Trucks

1 Answer

What type of oil do i need for an hyundai 2003 elantra


Check your owner's manual if it does not display it on the oil filler cap. Otherwise a good bet is 10w-30.

Jul 19, 2010 | Hyundai Motor 2003 Elantra

1 Answer

Lost oil suddenly while driving on highway.... what could have happened? 2004 Hyundai Elantra.... 53500 miles


Dont ask me, I m not there to look??? ck the oil filter . maybe jiffy lube didnt put it on right, or check the drain plug. ck oil sender switch. Fill it up and see where the leak is.

Apr 24, 2010 | 2004 Hyundai Elantra

2 Answers

How do I change the rear and front Differential fluid?


There is a drain plug on some vehicles at the bottom side of the differential that must be removed to drain the old oil out but on others you must remove the cover which has at least ten bolts that are in a circle pattern around the differential cover. After removing the cover and draining the old oil out dry out the excess oil left inside the casing with a clean rag, scrape off any old gasket material on both the differential casing and the cover. Purchase a gasket for the cover and reinstall the cover tightening the bolts in a criss cross or X pattern not too tight . Proceed to locate the filler plug on the upper right or left side of the differential, this plug is usually removed with the square end of a 3/8" socket wrench just using the square end of the socket wrench should do it or you may need a large hex head allen wrench but usually using a short extention with the socket wrench to get the clearance to turn the square end of the extention or socket wrench inside the plug will work, some times the plug is very tight and you may need to use a 1/2' drive socket wrench with a 1/2" to 3/8" reducer or adapter to acheive the neccessary torque required to crack the filler plug free, now get a coulple of 80/90 weight gear oil quarts and cut the filler tip back a bit with a razor or utility knife and using a 3/8" length of rubber hose slide it over the end of the tip tighten a small hose clamp on to the hose to prevent it from sliding off the filler tip, then feed the end of the hose into the filler hole on the differential and invert and sqeeze the container of oil to force the oil into the differential until it fills and over flows out the filler hole, screw in the filler plug and tighten. Use this general procedure for both the front and back differentials.

Oct 27, 2009 | 2005 Jeep Liberty

2 Answers

Where is the oil pan on a hyundai elantra 2002 GT?


Rule of thumb; if you can't find the oil pan then you do NOT have the skill it takes to change the oil!

Jul 17, 2009 | 2004 Hyundai Elantra

2 Answers

Where do i put the differential gear oil


Front Differential Oil Change dd7e0eb.gif
  1. Before changing or inspecting oil, be sure to stop engine and lift vehicle horizontally.
  2. With vehicle lifted up, check leakage. If leakage exists, correct it. NOTE: Whenever vehicle is hoisted for any other service work than oil change, also be sure to check for oil leakage.
  3. Remove oil filler plug (2).
  4. Remove drain plug (1), and drain old oil.
  5. Apply sealant to thread of drain plug (1), and tighten it to specified torque.Tightening torque Differential oil drain plug a: 23 Nm (2.3 kg-m, 17.0 ft. lbs.)
  6. Pour new specified oil until oil level reaches bottom of oil filler plug hole (3) as shown in figure. NOTE:
    • Hypoid gear oil must be used for differential.
    • It is highly recommended to use API GL-5 80W-90 gear oil.
Differential oil specification: API GL-5 (For SAE classification, refer to viscosity chart [A] in figure.)

Differential oil capacity (Reference): 0.9 - 1.1 liters (1.9/1.6 - 2.3/1.9 US/Imp. pt.)

  1. Apply sealant to thread of level / filler plug, and then tighten it to specified torque. A: Sealant 99000-31260SUZUKI Bond No.1217G Tightening torque Differential oil level / filler plug b: 23 Nm (2.3 kg-m, 17.0 ft. lbs.)

Jun 04, 2009 | 2007 Suzuki Grand Vitara 4WD

1 Answer

Does anyone have a picture of the transaxle oil fill plug for its location on a 1997 Lantra manual gearbox


hi
remove the speed senser from gear box and put trans oil in . this is only one way if u dont have filler plug

Apr 06, 2009 | 1997 Hyundai Elantra

3 Answers

Oil change procedure on a 2005 Hyundai elantra


it is very easy to change the oil put the car on ramps secure the back end look for the drain plug underneath the engine make sure you have the right size wrench and when you remove the plug also check the gasket on the plug to make sure it is not cracked you will also need an oil filter wrench and my other suggestion to you is to go to autozone to see if they have a Haynes repair manual for your car and if they don't see if they can order you one in the mean time they can also print you off a diagram of how to change the oil in you car safely

Jan 20, 2009 | 2005 Hyundai Elantra

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

50 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7772 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...