Question about Ford Econoline

1 Answer

My 1984 E350Econline with a 460 is leaking gas from the line and I need to know what size line it is to replace it. Thanks

Posted by on

1 Answer

If your asking about a steel tubing--measure what you need to replace

If it is rubber fuel hose--surely you can look at it,read the outside,
if it has a size or insert a drill bit to find size.

Posted on Mar 31, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

1984 S10 wont run fuel coming out at pump but doesnt seem to supply carb. has new filer. when primed it runs for a few seconds.


Is this a carbed engine, that usually means mechanical fuel pump? Take fuel line loose from carb, aim into container, crank engine, does gas flow? If so, have to check float bowl in carb to see if any gas, if no gas, need a carb kit in my opinion.
I don't know liter size of engine? If fuel injected, let us know.

Mar 20, 2017 | Cars & Trucks

1 Answer

85 Blazer s10 4x4 looks to be dripping trans fluid near the rear of engine. Small to medium size fluid leak when sitting. Seems to drip from unknown location, down onto the exhaust line. When idle,...


check the lines that goes trans to radiator
if o.k.it could be trans torque converter seal
if thats it trans has to be removed to replace seal

Apr 02, 2011 | 1984 Chevrolet Blazer

1 Answer

1984 ford econline 350 with a 7.5 (460) engine. where is the air bypass/managment valve located?


if the sticker for the vacuuum line routing is still on the front clip, it will show you where it is

Oct 21, 2010 | 1984 Ford Econoline

1 Answer

When you get down on it hard it acts like it aint getting enough gas 460 4 barrell motor 2 gas tanks where is the fuel filters


in the end of the fuel line at the carb.It could be as simple as a collapsed filter.Sometimes happens when it sits for some time.

Feb 19, 2010 | 1984 Ford F 350

2 Answers

1984 chry fifth ave run out off gas week later


check the fuel filter to make sure it is open/clean also check the fuel pump pressure to make sure it is okay? check for air leaks in the fuel lines for lose hoses connections and fuel it getting to the throttle body

Jan 21, 2010 | 1984 Chrysler Fifth Avenue

1 Answer

1984 dodge w-150 a/t starts and runs good go down the road and it hardly wants to run sputtering do 3 mph replaced everything cap,rotor,plugs,wires,pcv valve,air cleaner,fuel filter,ballest risistor dont...


it sounds like the its not getting enough gas to stay running. try looking for vacum leaks with a propane torch going over all the vacum lines with the FLAME OUT but the troch on when it is idling. if the idle goes up at any time when the torch passes over a line than you have found your leak and replace the line. even if you have one line bad keep going over all of them. and if there is no vacum leaks than start the engine and let it idle for about ten minutes, shut the engine off and take all the plugs out. if any of them are wet with gas than you have a spark problem and then begin going over your cap, rotor, wires, and points.

Nov 29, 2009 | 1984 Dodge Ramcharger

2 Answers

I need to replace the fuel pump on a 1984 chevy celebrity 2.8/V6 but I do not know where it is located. Also does this car have a fuel filter? I have searched and cannot find one.


84 celibrity has a carborater and the filter is in the carb. where the fuel line connects to it. Follow this metal line down past the timing cover and the other end screws into the fuel pump thats connected to the side of the engine block near the oil pann gasket on the belt drive end of the engine it has some brackets surounding it for the power steering pump and it's hard to get to and lots of other stuff needs to be removed to get to it. When their bad they leak oil too and sometimes they leak gas into the oil.195379185.jpg

Nov 28, 2009 | 1984 Chevrolet Celebrity

2 Answers

1984 ford f250 diesel rough idle and white smoke


i had the same problem with the same exact kind of truck... it is the fuel injectors take it to your local shop and have them test them

Nov 11, 2008 | 1984 Ford F 250

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

31 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

fordexpert

Level 3 Expert

5495 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...