Question about Volkswagen Camper

Open Question

Vw transporter t4 aab engine(2.4 5 cyl diesel) can you tell me the correct valve clearances , inlet and exhaust?

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

fastboyz
  • 674 Answers

SOURCE: valve clearance

h

i hope this helps good luck
thanks for using FIXYAbc70713.gif

Posted on Aug 26, 2008

  • 1 Answer

SOURCE: vw transporter t5 04 van t30 2.5

I had the same problem with my T5 130. My mechanic replaced the head gasket to no avail,then we checked the oil filter,that was ok.then we went on to a web forum and found out that the AXD engine suffers from water pump failure.We took it off and it was corroded,the seal had failed and was pumping water into the block.My advice,CHECK WATER PUMP FIRST! Good luck Marc,Somerset.

Posted on Feb 01, 2009

  • 1 Answer

SOURCE: dont know the tyre pressure for my vw transporter

Way too low. I have the same vehicle. Pressure should be at least 55psi all round, depending on load.

Posted on Jun 09, 2009

  • 94 Answers

SOURCE: Retiming of vw transporter diesel pump

This requires the use of a special VW tool called "the indicator tool". Visit this site to buy it:

http://www.partsplaceinc.com/catalog/vw-specialty-tools-diesel-tdi-timingtools55.shtml

You will also need to buy a repair manual for your car so you can get the appropriate timing setting for the pump. I recommend the Bently manual:

http://www.bentleypublishers.com/vw/eurovan/1992-2003/VW-Eurovan-92-99-Factory-Repair-Manual.html

It's expensive but worth it. If you don't want to spend that much, you may find pump timing information in a Haynes or Chilton manual which can be purchased on Amazon or at your local Autozone.

Good luck.

Posted on Jul 08, 2009

  • 580 Answers

SOURCE: 2001 Volkswagen Transporter Owners Manual

I found a link that may help it is for a shop manual it includes the long wheel base and TDI models 1.9, 2.4, & 2.5 cost is $35.95 US
http://www.books4cars.com/result3.asp?finddesc=transporter+&imageField2.x=16&imageField2.y=16
You will probably find it cheaper on Ebay there are several listed there NOW
Sorry I could find nothing listed for OWNERS manual you should try a salvage or breakers yard for that
Hope this helps

Posted on Jul 12, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Fiat Punto 1.4 engine code 118A5C0 . not compression , valve timing correct and no bent valves.


sounds like the valve clearances are incorrect if your engine has got adjustable valve clearances check that 0.40mm inlet 0.50mm exhaust but the engine changed in 1999 to hydraulic valve lifters and when you refit origional folowers you should compress them to remove the old oil or the new refubished cyl head/valves will have no compression because the valves are not seating

Mar 02, 2017 | Fiat Cars & Trucks

2 Answers

Hi Ace 2L diesel van. What is the valve clearance warm and cold?


Cold: Intake 0.30mm, Exhaust 0.50mm.
Hot: Intake 0.20mm, Exhaust 0.040mm.

The 2L Toyota engine runs an overhead cam with bucket lifters, and requires removing and replacing of shims to adjust clearances...

Feb 13, 2016 | Toyota Cars & Trucks

2 Answers

Whats the worst that could happen if I've adjusted valves incorrectly?


If the valves are too tight, they don't fully close. That can "burn" the valves, causing an expensive repair job to replace the valves. Too loose will make tapping noises and eventually can wear the cam.

Nov 14, 2015 | Cars & Trucks

1 Answer

What is the tappet/valve clearance for the Renault scenic 2003?


E7J engine 1600cc when cold- INLET 0.10mm
EXHAUST 0.25

2.0 Ltr engines have valve control solenoid and you would need to get a workshop manual for this procedure

Diesel engines(1.9 F8Q & F9Q) when cold -INLET 0.20
EXHAUST 0.40

Jun 10, 2015 | Renault SCENIC Cars & Trucks

1 Answer

WHAT IS THE valve clearance adjustment OF ISUZU 6SD1?


valve clearences of diesels if not hydraulic operated will be .012" inlet hot and .014" exhaust hot

Dec 05, 2014 | Isuzu Cars & Trucks

1 Answer

I have a 2c toyota diesel turbo engine i put other valve and new valveseals the timing is correct and dieselpump is correct but the car don't want to start pls help


first check the valve clearance .0.15 inlet, and .025 exhaust. make sure valve timing and pump timing is correct.and check while cranking diesal is pump to the injector

Dec 21, 2013 | Cars & Trucks

1 Answer

Nissan valve clearance td25 diesel 4 door 2.4


12 inlet and 15 exhaust is used on most engines unless its a old 60s GT model

Nov 30, 2013 | Nissan Pickup Cars & Trucks

2 Answers

Procedure of tappet adjustment


make sure engine is warmed up. Put cylinder one at top dead center,remove the valve cover,loosen all adjustment lock nuts,adust intake and exhaust valves on cyl #1 and intake valve on #2 and exhaust valve on #3. now rotate crankshaft 360 degrees clockwise, now adjust intake valves on cyl#3 and cyl #4 and exhaust valves on cyl #2 and cyl #4.now tighten lock nuts and install valve cover. specs are intake valves 25mm clearance and exhaust 28mm clearance, use a feeler gauge,heres a picture to show you where to check clearance.7675a52.gif

Mar 14, 2010 | 1986 Suzuki Samurai

1 Answer

Head stud torque


cyl head torqes.1st stage 29 nm. 2 nd stage 57-67 nm. 3rd stage slacken off 360 cegrees, 4th stage 29 nm. 5th stage 64-74 nm. intake and exhaust valve clearance .38 mm hot setting. hope it goes ok.

Aug 14, 2009 | 1987 Nissan King Cab

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

293 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volkswagen Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

yadayada
yadayada

Level 3 Expert

74945 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7697 Answers

Are you a Volkswagen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...