Question about 1992 Dodge Stealth

Open Question

My 91 Dodge Stealth R/T won't shift gears? Please help!

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

SOURCE: Tranny wont shift from third gear.

You have a solenoid bad in the trans. Will need to drop the pan to replace part. Most likely a code is stored in the computer to help direct the technician.

Posted on Jul 14, 2009

  • 137 Answers

SOURCE: 91 Tracker wont shift out of first gear.

http://www.kick-fix.com/tranny/shift-stick.jpg

here is what is broken.
unless you mean clutch is bad?

you can shift out even key off and the start car ? in neutral.

19 and 26 always fail, they are plastic.

the extension housing must have been dropped in with the forks centeralized. forming a square box.
at the end of 3,4,5 in photo

salud

Posted on Oct 22, 2009

  • 523 Answers

SOURCE: why wont my 91 dodge stealth have fire

Given the history of this product (early 1990 Mitsubishi products) I expect it is the engine ECU, located behind the radio. You'll need to remove the two pieces of carpet trim/panel off of the tunnel, pop off the plastic caps (one on each side) and remove the phillips head screw. The trim now loose will in-hook from a point near the fire-wall and then back by the shifter. Looking behind the dash in the middle the ECU will sit vertically and the (3) yellow electrical plugs within it, unplug these and remove the three bolts/screws holding it in place (if my memeory serves they are No. 10 metric) Note the MD number on the ECU this is important as you must keep this common with the replacement. The death of these ECUs are the (3) capaciors within them. If you like you can open up the ECU and look for these; under them you might notice a thick grease like substance, this is the failure of a leaking capacitor. It is possible for you to replace these capacitors (must be done with care) If you purchase a rebuilt unit the
new capacitors are of better quality and less prone to leaking.

The attached link should assist.

http://www.wrenchmonkey.com/Webpages/ECUrepair.html

I hope this may have assisted you,
Tom

Posted on Oct 30, 2009

wracefans24
  • 1985 Answers

SOURCE: my 91 dodge stealth is in limp mode how do i fix

Your car is in "limp"mode because the computer doesn't know what speed your doing,So it doesn't shift,
There are three possible reasons for this,
#1= input sensor faulty on transmission,
#2=output sensor faulty on transmission,
#3=speed sensor faulty on transmission,
you need to have the transmission codes read to know which one,Autozone checks codes for free.

Posted on Jan 14, 2010

agent91
  • 2100 Answers

SOURCE: witch timing marks do I use for my dohc 91 dodge stealth?

I don't know what you got there, but, the marks are just dots, or little arrows, they have to line up or else. I don't think the cam can go in but one way, all 4 valves opening at once doesn't make sense to me but I'll check it out.

Posted on Mar 06, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

91 dodge stealth will run and idle fine for 10to 20 mins then starts to misfire


yes as will a cracked distributer cap, and a bad coil will only fire when it decides to having a nomiss nomiss miss nomiss situation.

Dec 13, 2013 | Cars & Trucks

1 Answer

I was driving my manual 91 dodge stealth home when i went to shift into 4th gear the clutch pedal went all the way to the floor and stuck and now it doesnt like to go into gear with the clutch in but it...


Clutch disk or pressure plate or both are worn out, and I would replace the throw out bearing. You can buy a kit at autozone or kragen that has everything all together 100-200 dollars.

Aug 10, 2013 | 1991 Dodge Stealth

1 Answer

My 91 dodge stealth es it goes in reverse but goes hard an goes in gear wount shift up or down shift think it is stuck in 2nd gear what could it be


check fluids for contanination..(small aluminum shavings and debris in the fluid)sounds like a filter and fluid change are to be done(cheaper first) then if problem still exist look at shifter linkages and cable for operation.if still time for overhaul/replacement if car is worth it..good luck

Jan 17, 2013 | Cars & Trucks

1 Answer

91 Dodge Spirit stuck in low gear, won't shift out.


Sounds like you need a new shift cable. Remove the shift cable from the linkage on the transmission. If the transmission linkage moves freely back into the park position and the shift lever inside the car still will not move back into park than the cable is bad. If the transmission shift linkage will not move back into park with the cable removed than the transmission will need to be pulled apart to service the shift rod.

Aug 07, 2012 | 1991 Dodge Spirit

1 Answer

Got a 91 Stealth ES manual, only 74xxxx on it. need some help.


i had same problem i replaced the slave cylinder and removed the hydraulic clutch dampiner right next to slave cylinder now no grinding plus quicker shifts operates like a performance clutch with out the cost. slave cylinder cost $25 there is a do it yourself video on you tube. must remove dampiner and rejoin hydraulic line with a connecter for the added performance.

Mar 07, 2012 | 1991 Dodge Stealth

2 Answers

My 91 dodge stealth is in limp mode how do i fix this transmission problem


Your car is in "limp"mode because the computer doesn't know what speed your doing,So it doesn't shift,
There are three possible reasons for this,
#1= input sensor faulty on transmission,
#2=output sensor faulty on transmission,
#3=speed sensor faulty on transmission,
you need to have the transmission codes read to know which one,Autozone checks codes for free.

Jan 13, 2010 | 1991 Dodge Stealth

1 Answer

Tranny wont shift from third gear.


You have a solenoid bad in the trans. Will need to drop the pan to replace part. Most likely a code is stored in the computer to help direct the technician.

Jul 14, 2009 | 1991 Dodge Stealth

Not finding what you are looking for?
1992 Dodge Stealth Logo

Related Topics:

115 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8140 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...