Question about 2003 Chevrolet Blazer

1 Answer

Where is the drain plug on a 2003 chevy blazer

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Chevrolet Master
  • 959 Answers

The oil drain plug is located on the bottom of the oil pan.
The radiator drain is on the bottom passangers side of the radiator.
The transmission drain plug is in the trans oil pan , or you may have to drain by releasing the tension on the pan bolts... in which case you will likely need to replace the transmission pan gasket to reseal it.

Posted on Mar 31, 2011


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

A diagram of the flushing of a radiator and block of a chevrolet blazer LS 2000

Theres no such thing as a diagram, here are the draining instructions, hope this helps...
  • 1-Place a large drain pan beneath the radiator drain plug. The drain plug is located on the passenger side at the very bottom of the radiator on the engine side.

  • 2-Make sure the engine is cool. Open the hood of the truck and remove the radiator cap.
  • 3-Loosen the drain plug. On the 2000 Blazer, the drain plug is a wing-nut type of plug. Twist it with your fingers until the coolant begins to drain.

  • *To flush the block, once you have drained the radiator, run the engine for a bit untill the temp gauge goes up to normal, then the coolant will have been evacuated from the block. DO NOT leave the engine on, once it reaches normal temp, (this will happen quick) turn off right away, otherwise you'll be forking out a few hundred $$$ to fix the worped heads.
    4-Tighten the drain plug with your fingers once the coolant has drained fully from the radiator. Remove the drain pan and dispose of the used coolant properly.
    Some service stations will take and recycle your used coolant.
    Hope this helps...

  • Read more: How to Drain a Radiator From a 2000 Chevy Blazer '

    Aug 19, 2011 | 2000 Chevrolet Blazer

    1 Answer

    Need to know how to drain radiator fluid on a 05 chevy blazer?

    There should be a drain plug on the passenger side of the radiator. If there is no drain plug and both hoses are at the top of the radiator you can pull the lines to the transmission. Adjust the flow coming out by taking off and putting on the radiator cap. Just make sure to reconnect the lines before you refill the radiator.

    Jul 20, 2010 | 2005 Chevrolet Blazer

    1 Answer

    How do I drain and replace the engine coolant for a chevy Blazer?

    You'll want to remove the radiator cap. On that tank, on the bottom toward the engine is a drain to unscrew. You might want to spray some WD-40 on the drain plug, to help get it unscrewed.

    May 17, 2010 | 2000 Chevrolet Blazer

    1 Answer

    I cannot remove the key from my 2003 chevy blazer ignition after turning it off. light stays on and drains the battery

    Turn the igition to on,then off.Pull on the key while the igition is in the lock position at the same time turn the steering wheel left to right.The steering wheel will move slightly while in the lock position

    Oct 07, 2009 | 2003 Chevrolet Blazer

    1 Answer

    Where is the radiator drain on a 2003 Chevy blazer v6 and do you need a special tool?

    There is a draincock on the bottom of your radiator (probably hidden by the splash gaurd). You can either take the splash guard from the vehicle to drain the radiator, or disconnect the lower radiator hose. Both methods will allow you to drain the radiator.

    Jul 03, 2009 | 2003 Chevrolet Blazer

    1 Answer

    Driver Side Window won't work- Chevy Blazer 2003

    If it does not make any noise, or sound like its getting any power, most likely its the switch.

    Feb 20, 2009 | 2003 Chevrolet Blazer

    1 Answer

    Oil change

    the drain plug will be on the oil pan. look on the lower drivers side of your blazer will be a 15mm plug

    Oct 20, 2008 | 1999 Chevrolet Blazer

    1 Answer

    Radiator drain plug

    turn it a quarter turn and pull it out

    Oct 07, 2008 | 2005 Chevrolet Blazer

    3 Answers

    2003 Chevy Blazer won't start

    have the computer checked out. may need reprogramming and have updates added. also check for loose or corroded connections at the terminals.

    Aug 27, 2008 | 2003 Chevrolet Blazer

    Not finding what you are looking for?
    2003 Chevrolet Blazer Logo

    564 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Chevrolet Experts


    Level 3 Expert

    76846 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    22246 Answers

    Ronny Bennett Sr.
    Ronny Bennett Sr.

    Level 3 Expert

    6910 Answers

    Are you a Chevrolet Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides