Question about 1996 Mercury Grand Marquis

1 Answer

My 1996 mercury grand marquis runs fine till i put it in gear then it dies,when hot or cold while under load. what would cause this problem?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 10,319 Answers

Faulty trans shift solenoid for 1st gear

Posted on Mar 31, 2011

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

1997 grand marquis wont restart when cold


change air filter and fuel filter clean fuel injectors.faulty coolant temperature sensor will cause cold start problems.

Jan 04, 2013 | 1997 Mercury Grand Marquis

1 Answer

Ac on 96 grand marquis continues to blow hot air with new compressor and freon?


The first question is do you know if the ac compressor is running ?
If one ac line is hot and the other is cold you may have a blend door problem under the dash.

Jul 01, 2012 | 1996 Mercury Grand Marquis

1 Answer

Is there a relearn procedure for blend doors in a 97 mercury grand marquis. Removed battery and now ac blows hot only


probably has a bad belend air door motor, to run the systen completely through its self diagnosis process" if has electronic auto temp control"
press."off "and "floor" at the same time release... then hit the "auto" button
wait til gives you code...... it will then "SOMETIMES start WORK normal til moved again by you.....
if manual, change hot to cold, listen carefully for clicking ...if clicking rplave blend door motor and inspect the plenums door while motor out

Jan 20, 2010 | 1996 Mercury Grand Marquis

1 Answer

I got a 1988 mercury grand marquis LS that just about stalls when you drive it cold and put it into park. Cold meaning the oil is cold not the weather.


it doesent mean the weather it works the same if the engine hasent been rann for awhile its not at operating temp try running it till it reaches normal temp if it does not stall its your cold oxigen sensor

Sep 30, 2009 | 1988 Mercury Grand Marquis

1 Answer

1996 MERCURY GRAND MARQUIS WITH OCCASIONAL SLUGGISHNESS ON ACCELERATION AND SEEMS LIKE IT MAY BE USING MORE GAS THAN USUAL. HAS BEEN WELL TAKEN CARE OF, REG. OIL CHANGES, NEW FUEL FILTER 2 YRS AGO-DR


I would use 10W40 in the 96 and 5W20 or 30 in the 2002.

For the 96 with sluggishness, you need to gently clean the MAF sensor wires with carb cleaner and a toothbrush. It is in the air intake tube. After cleaning, disconnect the battery for 1/2 hour, then reconnect so the computer can relearn the clean sensor. Drive for 10 miles, it will run rough until it relearns.


Section 03-14: Engine Controls, Electronic 1996 Town Car, Crown Victoria, Grand Marquis Workshop Manual
DESCRIPTION AND OPERATION Mass Air Flow (MAF) Sensor The mass air flow sensor (MAF sensor) (12B579):
  • is mounted on the corner of the engine air cleaner (ACL) (9600).
  • uses a hot wire sensing element to measure the amount of air entering the engine; air passing over the hot wire causes it to cool.
  • sends out an analog voltage signal to the PCM (12A650) to determine the intake air mass. The PCM will then calculate the required fuel injector pulse width to provide the desired air/fuel ratio.
The mass air flow sensor hot wire sensing element and housing are calibrated as a unit and must be serviced as a complete assembly.

Mass Air Flow (MAF) Sensor

f314297.gif

May 27, 2009 | 1996 Mercury Grand Marquis

1 Answer

Air condition do not blow hot air in cold weather


this problem is caused by a defective air temp control blend door motor, to replace this part the dash must be removed.

Mar 23, 2009 | 1996 Mercury Grand Marquis

1 Answer

My 96 meunder the mercury grand marquis is running hot


A cracked Intake manifold. Check the manifold in two places, on the front cross over behind the alternator and the base of the heater hose connector on the rear of the passenger side.

Mar 02, 2009 | 1996 Mercury Grand Marquis

1 Answer

Car won't idle without revving when cold and dies when in drive


This Vehicle needs an Idle air control/Idle speed motor. Good Luck

Dec 28, 2008 | 1996 Mercury Grand Marquis

Not finding what you are looking for?
1996 Mercury Grand Marquis Logo

Related Topics:

254 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercury Experts

yadayada
yadayada

Level 3 Expert

76691 Answers

fordexpert

Level 3 Expert

5537 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...